Effects of Solvents in the Polyethylene Glycol Series on the Bonding of Copper Joints Using Ag2O Paste

The effects of reducing solvents on the bonding process using silver oxide paste in a copper joint were investigated. Three solvent types were tested: diethylene glycol (DEG), triethylene glycol (TEG), and polyethylene glycol (PEG). The strength of the joints was assessed by fracturing, which occurred at the interface of the copper oxide layer and the copper substrate in DEG and TEG samples and at the bonded interface in the PEG sample. Analysis of the samples revealed that, in the DEG and TEG samples, the copper substrate was oxidized during the bonding process, which compromised the shear strength of the joints. In contrast, the PEG sample exhibited nonuniform sintering of the silver layer while retaining good shear strength. It was found that the combination of DEG and PEG produced optimum shear strength in the copper joint, as PEG suppressed the growth of copper oxide and DEG promoted the formation of a dense sintered silver layer. The bonding strength achieved was higher than that of the gold-to-gold joint made using standard Pb-5Sn solder.     

Energetics of compounds related to Mg2Si as an anode material for lithium-ion batteries using first principle calculations

Electronic energy calculations of (1) Li-intercalated Mg₂Si assuming 4b sites occupancy by Li and (2) the formation of MgSiLi₂ with the assumed structures by Wengert et al. and Herbst and Meyer have been performed by a density-functional theory. The calculated energy changes for intercalation reactions of Mg₈Si₄ + nLi → Mg₈Si₄Li_n are +0.349 eV, +0.822 eV, +1.178 eV, and +1.741 eV for n = 1-4, respectively, and the energy change for Mg₈Si₄ + 8Li → Mg₄Si₄Li₈ + 4Mg is −1.95 eV when Mg is in the metallic state, while +4.12 eV when Mg is in the state of an isolated atom. If we can retard the growth of metallic Mg from Mg₂Si by some methods, undesirable structural change of the Mg₂Si into MgSiLi₂ during charge-discharge cycles would be prevented and intercalation/disintercalation reaction of Li into/from Mg₂SiLi_n (n = 0-1.0) would proceed reversibly by applied electric field.     

Superhydrophobic/superhydrophilic micropatterning on a carbon nanotube film using a laser plasma-type hyperthermal atom beam facility

Superhydrophobic/superhydrophilic micropatterning on a carbon nanotube (CNT) film has been achieved using a laser plasma-type hyperthermal atom beam facility, which produces a small amount of damage and generates a highly anisotropic beam. Fluorination and oxidation on CNT films by exposure to fluorine-atom and oxygen-atom beams caused superhydrophobic and superhydrophilic surfaces, respectively, while maintaining the as-grown fibrous forms of the CNT films. Micropatterned oxidation on CNT films without using photoresists created superhydrophilic microdots and microchannels.     

Guided-mode resonant grating filter with an antireflection structured surface

We describe a new structure of guided-mode resonant grating (GMRG) filters with low sideband reflectance. This GMRG filter consists of a high-index thin film on an antireflective structured surface called "moth-eye structure." Since the high-index film undulates along the surface structure, the film acts as a modulated optical waveguide. An incident light wave satisfying a resonant condition is reflected by the GMRG filter, and nonresonant light waves pass through the filter. This GMRG filter is valid for reducing reflection of nonresonant light waves in a wide spectral range. The resonant reflection of this new filter was investigated by numerical calculation based on an electromagnetic grating analysis. In the case of a triangular antireflective surface structure whose thickness is 2x greater than its period, the sideband reflectance for nonresonant light waves was lower than 0.5% for TM-polarized light in a wide range of wavelengths.     

A novel gene delivery system in plants with calcium alginate micro-beads

We have produced micrometer-sized calcium alginate beads referred to as "bio-beads" that encapsulate plasmid DNA molecules carrying a reporter gene. In order to evaluate the efficiency of the bio-beads in mediating genetic transfection, protoplasts isolated from cultured tobacco cells (BY-2) were transfected with bio-beads containing a plasmid that carries the modified green fluorescent protein gene CaMV35S-sGFP. With the bio-beads treatment, approximately ten-fold higher GFP expression was observed after 24 h incubation compared to that with the conventional method using a naked plasmid solution. Transfection was up to 0.22% efficient. These results indicate that bio-beads have a possibility for efficient transformation in plants.     

Random-coiled conformation of polypeptide chains

Summary Random-coiled conformation of poly(L-leucine), which has -branched side-chain, was theoretically analyzed by a conformational energy calculation based on intra-residue interactions. Calculated characteristic ratio 7.62 was obtained by using the transformation matrix statistically averaged over the entire side-chain conformational space of L-Leu residue. This value is smaller than those of poly(L-phenylalanine) (11.24) and poly(L-tyrosine) (12.33) which have -branched side-chain.     

Influence of the image quality deterioration of a tilted thick specimen on electron tomography

In electron tomography (ET) based on a transmission electron microscope, the effective thickness of a specimen increases with the tilt angle and, therefore, the projection quality may deteriorate because of electron scattering. The information-missing region, however, can be reduced by broadening the specimen tilt range. To clarify the general influence of these effects on ET, the projection quality varying with the tilt angle was quantitatively evaluated for a 5-microm thick specimen observed with a 3 MV ultrahigh-voltage electron microscope. Simulations of three-dimensional reconstruction were then performed for different specimen thicknesses and tilt ranges. As a result, the ET accuracy was shown to decrease as the specimen thickness increased. However, an optimum specimen-tilt range, at which ET could reach its highest accuracy, was found to exist and become small with the increase of the specimen thickness. The presented results are helpful for determining the specimen thickness limitation on the ET resolution and improving the ET fidelity of thick specimens.     

Giant room-temperature magnetoresistance in single-crystal Fe/MgO/Fe magnetic tunnel junctions

The tunnel magnetoresistance (TMR) effect in magnetic tunnel junctions (MTJs) is the key to developing magnetoresistive random-access-memory (MRAM), magnetic sensors and novel programmable logic devices. Conventional MTJs with an amorphous aluminium oxide tunnel barrier, which have been extensively studied for device applications, exhibit a magnetoresistance ratio up to 70% at room temperature. This low magnetoresistance seriously limits the feasibility of spintronics devices. Here, we report a giant MR ratio up to 180% at room temperature in single-crystal Fe/MgO/Fe MTJs. The origin of this enormous TMR effect is coherent spin-polarized tunnelling, where the symmetry of electron wave functions plays an important role. Moreover, we observed that their tunnel magnetoresistance oscillates as a function of tunnel barrier thickness, indicating that coherency of wave functions is conserved across the tunnel barrier. The coherent TMR effect is a key to making spintronic devices with novel quantum-mechanical functions, and to developing gigabit-scale MRAM.     

Study on anisotropy of growth rate of ice crystal in supercooled water

The purpose of this research was to investigate the ice growth of a single crystal in three dimensions. Three-dimensional pattern of ice crystal growth in supercooled water was observed using Mach–Zehnder spectro-interferometer. Temperature was varied from −0.3 to −1.6 °C. It was found that the ice crystal began to grow as a single crystal at the tip of the capillary tube and propagated freely in supercooled water. Time variation of the shape of dendrite on a–c plane was obtained. It was found that half parabola fits the shape very closely, and the coefficient of squared term, a, of a quadratic function was calculated. The coefficient, a varied in time but at quasi steady state it was found to be depending mostly upon the degree of supercooling. Furthermore, the growth velocity in c-axis at the flat surface was calculated from the thickness measured. It was found that the velocity in c-axis is independent of the degree of supercooling but depends upon time, in other words, the thickness in c-axis.     

Mutants of the nematode Caenorhabditis elegans that are defective specifically in their attraction to cycloheximide

The nematode Caenorhabditis elegans exhibits chemotaxis toward a wide variety of chemicals including water-soluble molecules and volatile organic compounds. We have previously discovered that C. elegans wild-type strain N2 is strongly attracted by cycloheximide which has long been known as a bitter tastant for humans and other mammals. We describe here the isolation and initial characterization of the first mutants which were defective specifically in their attraction to cycloheximide. In our screenings, we selected two mutants that were defective in chemotaxis to cycloheximide but normal in their attraction to NH4Cl and histidine. These mutants also avoided quinine hydrochloride, CuSO4 and high concentrations of NaCl similar to the wild-type strain N2. Furthermore, no observable defect was detected in their attraction to volatile odorants such as isoamyl alcohol and diacetyl. Dye-filling experiments suggested that they have no morphological defect in the sensory endings of the amphid neurons.