Complex impedance and admittance of a silver-conducting glass

From the analysis of complex impedance and admittance data of (Agl)₇₅(Ag₄P₂O₇)₂₅ glass, an Ag⁺-ion conductor, it was revealed that the sample can be approximated by a seriesRC ₁ circuit at high temperature, with the capacitorC ₁ arising from the charge-carrier depleted region near the anode which develops as conduction proceeds, and by a parallelRC ₂ circuit at low temperature, with the capacitorC ₂ arising from the saturated value for ionic polarization of, say, the silver-iodine pairs as well as from the relaxation effect of the Ag⁺ ions for conduction. TheC ₁ andC ₂ values were found to be almost temperature-independent at peak frequencies of the distorted semicircles in respective complex planes, with the ratioC ₁/C ₂ as large as 10⁴.     

Electrical Properties of 1.7-MeV-Electron-Irradiated Sulfur-Doped GaP

The electrical properties of 1.7-MeV-electron-irradiated sulfur (S)-doped GaP were studied by using Hall effect and resistivity measurements. It was found that the concentration of S donors decreased and the deep acceptors were introduced by 1.7-MeV electron irradiation. The decrease of the concentration of S donors could be understood by considering the formation of a complex center of radiation-produced defects with S. A complex center acted as a deep acceptor and recovered in the stage centered at 150°C anneal. The introduction rate of this center was ~2.1 cm-1. From the isothermal annealing experiments, it was found that the recovery for this center approximately obeyed first-order kinetics and its activation energy was ~1.7 eV. Furthermore, another complex center involving S, which was a non-compensating defect in n-type GaP, was introduced. This center was seemed to be a deep donor.     

Transient and steady state crack growth kinetics for stress corrosion cracking of a cold worked 316L stainless steel in oxygenated pure water at different temperatures

The stress corrosion cracking (SCC) growth kinetics for a cold worked 316L stainless steel was continuously monitored in high purity water at different temperatures and dissolved oxygen (DO) levels under a K (or K_max) of 30 MPa m^0.5. The total SCC test time was more than 8000 h to make sure the steady state crack growth rate under each test condition could be reached. Crack growth rate (CGR) increases with increasing temperature in the range 110-288 °C. A typical intergranular-cracking mode is identified. Depending on the previous test condition, especially the temperature, three kinds of crack growth kinetics, i.e., increasing with testing time then becoming steady, being constant during the whole period, or decreasing with test time then becoming steady, are identified and discussed. Time-dependent and testing history-dependent crack growth modes were confirmed in two series of tests in 2 ppm DO and 7.5 ppm DO pure water. The apparent activation energies are calculated and compared with other data in different environments under different applied loading levels for understanding the cracking mechanism.     

Enhancement of low density lipoprotein binding to both low density lipoprotein receptor-positive and- negative cells by tetracycline antibiotics

Some tetracycline (TC) antibiotics, including TC and anhydrotetracycline, have been found to enhance specific binding of low density lipoprotein (LDL) to both LDL receptor-positive and-negative cells at relatively higher concentrations. When incubated at 37°C, the ability of LDL receptor-negative human fibroblasts to bind ¹²⁵I-LDL was increased from<2 to 45 ng/mg by 170 μM TC. In normal human fibroblasts and Hep G2 cells, ¹²⁵I-LDL binding was elevated 1.4- to 2-fold by 113 μM TC. The ¹²⁵I-LDL binding in the presence of TC was diminished by both heparin and EDTA. The enhancement by TC was not observed when ¹²⁵I-LDL binding was assayed at 4°C. TC enhanced LDL binding to paraformaldehyde-fixed Hep G2 cells, excluding LDL receptor induction in the mechanism. These results demonstrated that TC enhanced cellular LDL binding through a process not involving functional LDL receptors.     

Gas entrainment rate and flow pattern of vertical plunging liquid jets

For a vertical plunging liquid jet system using various liquids, the effects of the operating conditions including the nozzle length-to-diameter ratio on the gas entrainment rate Q_g were evaluated experimentally. The differences in Q_g were related to the changes in the jet shape before plunging and the velocity of the plunging liquid jet at the point where the gas sheath breaks up. Empirical relationships were also presented to predict the maximum depth Z of bubbles entrained by the diffusing jet. The changes of Z were further discussed in terms of the downward liquid velocity distribution in the submerged two-phase region, which depends mainly on the size of entrained bubbles.     

Synthesis of ordered mesoporous carbon thin films at various temperatures in vapor infiltration method

Mesoporous carbon thin films with ordered structures were prepared by using resorcinol-surfactant self-assembly. A mixture of resorcinol, surfactant, and ethanol coated on silicon substrates was exposed to formaldehyde vapor as a cross-linking agent to form structured resorcinol/formaldehyde resin films. The films were then carbonized at 800 °C in an inert atmosphere to remove the surfactant and to obtain structured carbon materials. With this vapor infiltration method, thin films with several structures were obtained from the same precursor solution by employing different vapor infiltration temperatures. The results were interpreted from the transformation of the self-assembly during the vapor infiltration process.