Development of a specimen heating holder with an evaporator and gas injector and its application for catalyst

A specimen heating holder equipped with a gas injector and an evaporator has been developed for use with conventional transmission electron microscopes (TEMs). The developed specimen holder allows both synthesis of metal oxide support and deposition of catalyst nano-particles in situ. Since the holder is designed to be used in small gapped high-resolution objective lens pole-piece, all the procedure from the synthesis of support material to the deposition of catalyst as well as the behavior of the catalyst nano-particles on the support can be observed at near atomic resolution. The developed specimen holder was applied to the study of AuPd catalyst. First, air was injected onto heated aluminum particles via a gas injector to synthesize Al(2)O(3) support. Then, nano-particles of AuPd were deposited on the Al(2)O(3) support. After the deposition, the synthesized Al(2)O(3) support was heated and air was injected again to observe behaviors of the deposited AuPd nano-particles at elevated temperatures in the aerial environment. Behaviors of the AuPd nano-particles such as coalescence, segmentation and diffusion to the Al(2)O(3) support were dynamically observed at atomic level high resolution.     

A Low Power Dissipation Technique for a Low Voltage OTA

This paper proposes a novel low power dissipation technique for a low voltage OTA. A conventional low power OTA with a class AB input stage is not suitable for a low voltage operation (±1.5 V supply voltages), because it uses composite transistors (referred to CMOS pair) which has a large threshold voltage. On the other hand, the tail-current type OTA needs a large tail-current value to obtain a sufficient input range at the expense of power dissipation. Therefore, the conventional tail-current type OTA has a trade-off between the input range and the power dissipation to the tail-current value. The trade-off can be eliminated by the proposed technique. The technique exploits negative feedback control including a current amplifier and a minimum current selecting circuit. The proposed technique was used on Wang's OTA to create another OTA, named Low Power Wang's OTA. Also, SPICE simulations are used to verify the efficiency of Low Power Wang's OTA. Although the static power of Low Power Wang's OTA is 122 W, it has a sufficient input range, whereas conventional Wang's OTA needs 703 W to obtain a sufficient input range. However, we can say that as the input signal gets larger, the power of Low Power Wang's OTA becomes larger.     

Development of a high temperature-atmospheric pressure environmental cell for high-resolution TEM

An environmental cell for high-temperature, high-resolution transmission electron microscopy of nanomaterials in near atmospheric pressures is developed. The developed environmental cell is a side-entry type with built-in specimen-heating element and micropressure gauge. The relationship between the cell condition and the quality of the transmission electron microscopic (TEM) image and the diffraction pattern was examined experimentally and theoretically. By using the cell consisting of two electron-transparent silicon nitride thin films as the window material, the gas pressure inside the environmental cell is continuously controlled from 10(-5)?Pa to the atmospheric pressure in a high-vacuum TEM specimen chamber. TEM image resolutions of 0.23 and 0.31?nm were obtained using 15-nm-thick silicon nitride film windows with the pressure inside the cell being around 5?×?10(-5) and 1?×?10(4)?Pa, respectively.     

Transport-Coefficient Dependence of Current-Induced Cooling Effect in a Two-Dimensional Electron Gas

The dependence of the current-induced cooling effect on the electron mobility??? _e is explored for a two-dimensional electron gas (2DEG) subjected to a perpendicular magnetic field. We calculate the distributions of the electrochemical potentials and the temperatures under a magnetic field, fully taking account of thermoelectric and thermomagnetic phenomena. Whereas the electrochemical potential and the electric current remain qualitatively unchanged, the temperature distribution exhibits drastic mobility dependence. The lower-mobility system has cold and hot areas at opposite corners, which results from the heat current brought about by the Ettingshausen effect in the vicinity of the adiabatic boundaries. The cooling effect is intensified by an increase in??? _e. Intriguingly, the cold and hot areas change places with each other as the mobility??? _e is further increased. This is because the heating current on the adiabatic edges due to the Righi?CLeduc effect exceeds that due to the Ettingshausen effect in the opposite direction.     

Optimal inspection policy for a parallel redundant system

This paper considers an inspection policy for an n-unit parallel redundant system which is checked at successive times x (k=1, 2,…). The preventive maintenance is made if j units (1<j<n−1) fail at each inspection. The expected cost is derived and the optimum policy to minimize it is discussed. Two modified models are introduced. A numerical example is given when the failure times of each unit have a Weibull distribution.     

Criteria for versatile GaN MOVPE tool:high growth rate GaN by atmospheric pressure growth

Growth rate has a direct impact on the productivity of nitride LED production.Atmospheric pressure growth of GaN with a growth rate as high as 10μm/h and also Al_0.1Ga_0.9N growth of 1μm/h by using 4 inch by 11 production scale MOVPE are described.XRD of（002） and（102） direction was 200 arcsec and 250 arcsec, respectively.Impact of the growth rate on productivity is discussed.     

Atomistic origin of high-quality “novel SiON gate dielectrics”

We have investigated the effect of the oxygen incorporation into SiN films by the first principles calculations. The calculated results show that the oxygen incorporation tends to generate defect states in SiN band gap by forming dangling bonds and floating bonds of Si. Based on the calculated results, it is also indicated that the high quality SiON film can be fabricated by suppressing the incorporation of O atoms into the SiN film, reproducing the reported experiments.     

Selective Determination of Dopamine on a Boron‐Doped Diamond Electrode Modified with Gold Nanoparticle/Polyelectrolyte‐coated Polystyrene Colloids

Negatively charged gold nanoparticles (AuNPs) and a polyelectrolyte (PE) have been assembled alternately on a polystyrene (PS) colloid by a layer‐by‐layer (LBL) self‐assembly technique to form three‐dimensional (Au/PAH)₄/(PSS/PAH)₄ multilayer‐coated PS spheres (Au/PE/PS multilayer spheres). The Au/PE/PS multilayer spheres have been used to modify a boron‐doped diamond (BDD) electrode. Cyclic voltammetry is utilized to investigate the properties of the modified electrode in a 1.0 M KCl solution that contains 5.0 × 10^?3 M K₃Fe(CN)₆, and the result shows a dramatically decreased redox activity compared with the bare BDD electrode. The electrochemical behaviors of dopamine (DA) and ascorbic acid (AA) on the bare and modified BDD electrode are studied. The cyclic voltammetric studies indicate that the negatively charged, three‐dimensional Au/PE/PS multilayer sphere‐modified electrodes show high electrocatalytic activity and promote the oxidation of DA, whereas they inhibit the electrochemical reaction of AA, and can effectively be used to determine DA in the presence of AA with good selectivity. The detection limit of DA is 0.8 × 10^?6 M in a linear range from 5 × 10^?6 to 100 × 10^?6 M in the presence of 1 × 10^?3 M AA.     

Fir laser emissions from population inversion transition by TEA-CO2 laser pumping

In this paper, the numerical analysis is given which is applicable for a TEA-CO₂ laser pumping in search of effective pumping method. The analysis also can estimate the optimum pressure for a given molecule and a given pulse laser. Also we report in this work many FIR laser emissions from population inversion transition which have never observed before using a TEA-CO₂ laser.