Theoretical Evalution of Signatures and CNR Penalties Caused by Modem Impairments in Multilevel QAM Digital Radio Modems

A calculation method for symbol error probability is proposed for multilevel QAM systems. Carrier-to-noise ratio penalties are estimated by this method for seven typical impairment factors, including recovered carrier phase error, timing error, receive filter residual delay, etc. The validity of the method is verified by experiments on penalties caused by recovered carrier phase error and timing error. Based on the new method of analysis, signatures of a 64 QAM modem are estimated theoretically, using a pseudo-two-ray model of multipath fading. The dependence of signatures on the above-mentioned impairment factors is investigated in detail. A qualitative deduction of impairment factors from a measured signature is demonstrated. The measured signature agrees well with a calculated one in which reasonable values of the impairment factors are assumed.     

Change in the molecular weight distribution of poly(ethylene oxide) caused by the complexation with poly(acrylic acid)

The complexation between poly(ethylene oxide) (PEO) and poly(acrylic acid) (PAA) was made by using double the molar quantity of either polymer component at pH 2 where the resulting complex completely precipitates. After the removal of the precipitate, PEO or PAA remaining in the supernatant was subjected to gel permeation chromatography to investigate the change in the molecular weight distribution (MWD) caused by the complexation. No remarkable difference is observed in the MWD curves for PEO[1] (M_w=1.37 × 10⁴) before and after the complexation with PAA[1] (M_w=1.10 × 10³) and PAA[2] (M_w=4.16 × 10⁵). However, the MWD curves of PEO[2] (M_w=1.26 × 10⁵) and PAA[2] become shortened and shift to the low molecular weight side after the complexation with PAA[1] or [2] and PEO[2], respectively. This tendency is enhanced by increasing the complexation temperature. From these results, it is indicated that the complexation between PEO and PAA deals with an equilibrium reaction, and the equilibrium constant is dependent on the chain length of both polymer components and also on the complexation temperature.     

Comparison of isolation methods using commercially available kits for obtaining extracellular vesicles from cow milk

Extracellular vesicles (EV) are important for delivering biologically active substances to facilitate cell-to-cell communication. Milk-derived EV are widely known because of their potential for immune enhancement. However, procedures for isolating milk-derived EV have not been fully established. To obtain pure milk-derived EV and accurately reveal their function, such procedures must be established. The aim of the present study was to compare methods using commercially available kits for isolating milk-derived EV. Initially, we investigated procedures to remove casein, which is the major obstacle in determining milk-derived EV purity. We separated whey using centrifugation only, acetic acid precipitation, and EDTA precipitation. Then, we isolated milk-derived EV by ultracentrifugation, membrane affinity column, size exclusion chromatography (SEC), polymer-based isolation, or phosphatidylserine-affinity isolation. Using EV count per milligram of protein, which is a good indicator of purity, we determined that acetic acid precipitation was the best method for removing casein. Using nanoparticle tracking analysis, protein quantity analysis, and RNA quantity analysis, we comprehensively compared each isolation method for its purity and yield. We found that SEC-based qEV column (Izon Science) could collect purer milk-derived EV at higher quantities. Thus, a combination of acetic acid precipitation and qEV can effectively isolate high amounts of pure extracellular vesicles from bovine milk.     

Estimation of concentrations of antifungal agents allowed as food additives in foods and their daily intake based on official inspection results in Japan in fiscal year 1998

The mean concentrations and daily intake of four antifungal agents were estimated based on the results of an analysis of 7,005 samples of food obtained in official inspections by Japanese local governments in fiscal year 1998. The mean concentration of diphenyl was 0.0004% of the allowable limit, and those of imazalil, o-phenylphenol, and thiabendazole were 14.0%, 3.5%, and 5.7%, respectively. The daily intakes of these antifungal agents per person, estimated from their concentrations and the daily consumption of the foods, were 0.000326, 1.89, 11.5, and 23.3 micrograms, respectively, and assuming a body weight of 50 kg, the amounts of these antifungal agents consumed were 0.000013%, 0.15%, 0.12%, and 0.47% of the acceptable daily intake, respectively. These values are similar to the values obtained on the basis of the results of the official inspection in fiscal years 1994 and 1996, except that the amount of diphenyl is much lower (1/100).     

Study on the determination of pesticide residues in crops by ion-trap GC/MS/MS

Ion-trap GC/MS/MS was evaluated for the multi-residue determination of pesticides in agricultural products. Matrices were extracted from samples (spinach, carrot, onion and brown rice) with acetone and submitted to gel permeation chromatography, followed by a clean-up step through a graphite carbon cartridge. Thirty-five pesticides were added to either matrix, and analyzed by GC/MS/MS. Detection limits of pesticides by GC/MS/MS was almost the same as those by GC/MS (SIM). Coefficients of variation of peak area in 5 measurements of each pesticide at 0.1 microgram/mL or 0.05 microgram/mL with or without matrices were mostly acceptable, though those of 20 pesticides out of 35 were higher than 10% at a concentration of 0.02 microgram/mL. It was indicated that matrix artifacts, which interfere with GC/MS-Scan analysis, could be eliminated in some cases by using GC/MS/MS.     

Purification and molecular cloning of an intracellular 3-hydroxybutyrate-oligomer hydrolase from Paucimonas lemoignei

An intracellular 3-hydroxybutyrate-oligomer hydrolase was purified from a poly(3-hydroxybutyrate)-degrading bacterium, Paucimonas lemoignei. It hydrolyzed the 3-hydroxybutyrate dimer with the highest specific activity of any of the enzymes reported so far. The gene was cloned and sequenced. The deduced amino acid sequence showed that the enzyme is a homolog of the PhaZc of Ralstonia eutropha H16.     

Convergence of solutions of the MHD stability code ERATO

Convergence of solutions of the ERATO code is studied numerically. Some irregularities of the computed data points on a convergence curve are observed in our investigation. It is conjectured that these irregularities are due to inaccuracy of the equilibrium or to inappropriate choice of the equilibrium calculation meshes.     

Structural determination of subsidiary colors in commercial Food Green No. 3 (fast green FCF, FD & C Green No. 3).

HPLC analysis revealed that eight subsidiary colors existed in commercial Food Green No. 3 (fast green FCF, FD & C Green No. 3). Among them, four subsidiary colors C, F, G, and H were isolated by using preparative HPLC and their structures were determined by MS and NMR. They were the disodium salt of 2-[[4-[N-ethyl-N-(3- sulfophenylmethyl)amino]phenyl][4-[N-ethyl-N-(4- sulfophenylmethyl)amino]phenyl]methylio]-4-hydroxybenzenesulfonic acid (abbreviated as m,p-G-3), the sodium salt of 2-[[(4-N-ethylamino)phenyl][4-[N-ethyl-N-(3- sulfophenylmethyl)amino]-phenyl]methylio]-4-hydroxybenzenesulfonic acid [abbreviated as HSBA-(EA) (m-EBASA)], the sodium salt of 2-[[(4-N-diethylamino)phenyl][4-[N-ethyl-N-(3- sulfophenylmethyl)amino]phenyl]-methylio]-4-hydroxybenzenesulfonic acid [abbreviated as HSBA-(di-EA) (m-EBASA)], and the sodium salt of 2-[[4-[N-ethyl-N-(phenylmethyl)amino]phenyl][4-[N-ethyl-N-(3- sulfophenylmethyl)-amino]phenyl]methylio]-4-hydroxybenzenesulfonic acid [abbreviated as HSBA-(EBA)(m-EBASA)], respectively. HSBA-(di-EA) (m-EBASA) was a subsidiary color newly found in commercial Food Green No. 3.     

Voltage Control of Static Var Compensator for a Remote System Interconnected by Long‐Distance AC Cables

The voltage variation in a remote system is large when the system is connected by long‐distance AC cables due to the cable capacitance. In Japan, the longest 54‐km 66‐kV AC submarine cable interconnection between the Kyushu mainland and Goto Islands was commissioned in 2005. It was requested to mitigate the voltage variation caused by switching off and on one circuit of the two circuits in the AC cables when a fault occurs. Since the conventional voltage control methods such as transformer tap changer or shunt capacitor and reactor banks are not sufficient because of their slow response time, a static var compensator (SVC) was installed on the Goto Islands. In such an application, an SVC control method should be developed so as not to override the existing voltage control systems. This paper describes the SVC control method developed for the Goto Islands AC interconnection project, which can be applied to similar situations. The effectiveness of the control method was verified by the results of effective value simulation and of field testing, which was implemented before the SVC was commissioned in 2007. © 2013 Wiley Periodicals, Inc. Electr Eng Jpn, 186(3): 19–30, 2014; Published online in Wiley Online Library ( wileyonlinelibrary.com ). DOI 10.1002/eej.22337