Evaluation of stability and functionality of BaCe1–x Inx O3–δelectrolyte in a wider range of indium concentration

The properties of BaCe_1–xIn_xO_3–δ(x=0.05,0.10,0.15,0.20,0.25,0.30,0.35,and 0.40) as proton conducting electrolyte are examined.The dense electrolyte is formed after sintering at 1300℃for 5 h in air.The samples with In content≥25 mol%contain In₂O₃ as a secondary phase.The highest total conductivity is around 5×10^–3 S/cm for BaCe_0.75In_0.25O_3–δ in the wet hydrogen atmosphere at 700℃.After exposure to p...     

Characterization of γ and γ′ phases in 2<Superscript>nd</Superscript> and 4<Superscript>th</Superscript> generation single crystal nickel-base superalloys

A Ni based single crystal superalloy from the 2^nd generation, PWA 1484, and one from the 4^th generation, PWA 1497, were comparatively studied by scanning electron microscopy, energy dispersive X-ray spectroscopy and nanoindentation technique in an atomic force microscope (NI-AFM) after high temperature creep deformation. During primary creep of both generations of superalloys, γ′ precipitates start to coalesce and grow directionally. Further creep deformation leads to the topological inversion and coarsening of the rafted microstructure. The NI-AFM technique was used for measurements of the hardness of the γ and γ′ phases in as-received and creep deformed samples in various conditions. The g matrix of the PWA 1497 superalloy is on average 0.8 GPa harder than that of PWA 1484 that can be explained by higher content of Re and Ru, since they partition predominantly to the matrix phase.     

The effectiveness of the SEA process in Slovenia

This article focuses on the analysis of strategic environmental assessment (SEA) effectiveness in Slovenia. Apart from some general information on the SEA legal framework and guidance, the article mainly explores the political context, substantive, transactive, normative, knowledge/learning and pluralist effectiveness of SEA in Slovenia. An online questionnaire was prepared to collect information and views related to the stated aspects of SEA effectiveness from key stakeholders involved in the process. The survey results indicate that SEA in Slovenia is only partially effective. The most commonly recognised problems related to the substantive effectiveness of SEA are linked to weak control over the implementation of the mitigation measures and their effectiveness. With regard to transactive effectiveness, the SEA extends the planning process and is mostly assessed to have a low cost–benefit ratio. Personnel and organisations involved in SEA processes have very diverse skills and efficiency. In relation to normative effectiveness, neglect of social and economic components occurs. SEA does not seem to be very successful in changing the way of thinking, which has a negative impact on knowledge effectiveness. Pluralist effectiveness could be also improved, especially with regard to better integration of views from the public into the planning process.     

Synthesis and Anticancer Activity of Mitotic-Specific 3,4-Dihydropyridine-2(1H)-thiones

Most anticancer drugs target mitosis as the most crucial and fragile period of rapidly dividing cancer cells. However the limitations of classical chemotherapeutics drive the search for new more effective and selective compounds. For this purpose structural modifications of the previously characterized pyridine analogue (S1) were incorporated aiming to obtain an antimitotic inhibitor of satisfactory and specific anticancer activity. Structure-activity relationship analysis of the compounds against a panel of cancer cell lines allowed to select a compound with a thiophene ring at C5 of a 3,4-dihydropyridine-2(1H)-thione (S22) with promising antiproliferative activity (IC₅₀ equal 1.71 ± 0.58 µM) and selectivity (SI = 21.09) against melanoma A375 cells. Moreover, all three of the most active compounds from the antiproliferative study, namely S1, S19 and S22 showed better selectivity against A375 cells than reference drug, suggesting their possible lower toxicity and wider therapeutic index. As further study revealed, selected compounds inhibited tubulin polymerization via colchicine binding site in dose dependent manner, leading to aberrant mitotic spindle formation, cell cycle arrest and apoptosis. Summarizing, the current study showed that among obtained mitotic-specific inhibitors analogue with thiophene ring showed the highest antiproliferative activity and selectivity against cancer cells.     

Bioactive Titanium Surfaces Enriched with Silver Nanoparticles Through an In Situ Reduction: Looking for a Balance Between Cytocompatibility and Antibacterial Activity

This research aims toward an antibacterial and osteoconductive Ti₆Al₄V surface by chemical etching–oxidation treatment and in situ reduction of silver nanoparticles. Starting from a previously developed process, already proved to enhance the osteoinductive ability of titanium, different parameters are changed to tailor the amount of silver and its distribution across the surface oxide layer thickness. The samples are characterized by scanning and transmission electron microscopy, energy-dispersive X-ray spectroscopy, release of silver, biofilm formation (Staphylococcus aureus), and cytocompatibility toward human osteoblasts progenitor cells. The total amount of silver in the surface oxide layer depends only on the concentration of the silver precursor. The time of the addition of the silver precursor, during the oxidation treatment, affects the oxide layer thickness, dimension, and distribution of the nanoparticles across the surface oxide: they are larger and accumulate on the outermost layer, if the addition occurs early. The maximum ion release occurs after 24 h and lasts up to 14 days; the later addition of silver precursors leads to sustaining the silver release for a longer time. The samples prepared with the higher concentration of the silver precursor are bactericide, but highly cytotoxic, whereas the other ones are bacteriostatic and moderately cytotoxic.     

Solid-State 13C CP/MAS NMR for Alkyl-O-Aryl Bond Determination in Lignin Preparations

Several lignin preparations (Freudenberg lignin, Björkman lignin, and Pepper lignin), technical lignins (soda, soda-AQ, Kraft, Kraft-AQ, and hydrolysis), dimeric lignin model compounds, and different polysaccharides (galactoglucomannan, arabinogalactan, xylan, and arabinan) were analyzed by means of solid-state ¹³C CP/MAS NMR. Signals assignment in solid-state NMR lignin spectra was performed on the basis of the conducted studies and earlier published data. It was established that there exists strong linear correlation (r = 0.985) between Alkyl-O-Aryl inter-unit bond content in lignin and integral signals intensity in NMR spectra in the range of chemical shifts of 96–68 ppm. The integral signals intensity was measured in correlation with the reference integral signals in the range of chemical shifts of 162–102 ppm, typical for aromatic carbon atoms. To eliminate the effect, caused by carbohydrates contained in lignin, the correction factor of 0.67% of the area of integration per 1% of carbohydrates was determined. It was shown that the solid-state ¹³C CP/MAS NMR method allowed to determine Alkyl-O-Aryl bond content in both soluble and insoluble lignin preparations, and also to determine methoxyl groups content in soluble preparations.     

Antioxidant Capacity of Rapeseed Extracts Obtained by Conventional and Ultrasound‐Assisted Extraction

Ultrasound‐assisted extraction (UAE) and conventional solid–liquid extraction were applied to extract total antioxidants from two rapeseed varieties. The antioxidant capacities (AC) of winter and spring rapeseed cultivars were determined by four different analytical methods: ferric reducing antioxidant power (FRAP), cupric reducing antioxidant capacity (CUPRAC), 2,2′‐diphenyl‐1‐picrylhydrazyl (DPPH), 2,2′‐azino‐bis‐3‐ethylbenzothiazoline‐6‐sulfonic acid (ABTS). The average AC of the studied rapeseed cultivars ranged between 4.21–10.03 mmol Trolox (TE)/100 g, 7.82–10.61 mmol TE/100 g, 8.11–51.59 mmol TE/100 g, 22.48–43.13 mmol TE/100 g for FRAP, CUPRAC, DPPH and ABTS methods, respectively. There are positive correlations between total phenolics (TPC = 804–1625 mg sinapic acid (SA)/100 g) and AC of the studied rapeseed extracts (r = 0.2650–0.9931). Results of the principal component analysis (PCA) indicate that there are differences between the total amounts of antioxidants in rapeseed samples extracted by different extraction techniques. Rapeseed extracts obtained after 18 min of ultrasonication revealed the highest content of total antioxidants. The UAE is a very useful, efficient and rapid technique of oilseed samples preparation for determination of AC by different analytical methods.     

The Study of Ethanol/Water Vapors Permeation through Sulfuric Acid Cross-Linked Chitosan Magnetic Membranes

Sulfuric acid cross-linked chitosan membranes filled with a different amount of magnetite, were prepared. The permeation behavior of ethanol and water vapors in vapor permeation experiments were studied. Permeation rates were measured. Mass transport coefficients were evaluated. The study has been carried out to determine the influence of magnetic powder dispersed inside of the chitosan membrane on ethanol-water separation. The diffusion, fluxes, and permeation coefficients increased with greater amount of magnetite content. The separation factor increased with increasing flux and the best results were achieved for the membrane containing 15% w/w magnetite. The research allows optimizing the preparation procedure of chitosan magnetic membranes cross-linked by sulfuric acid with the best permeation properties.     

Magnetic Mixed Matrix Membranes Consisting of PPO Matrix and Magnetic Filler in Gas Separation

Poly(2,6-dimethyl-1,4-phenylene oxide) (PPO) and magnetic neodymium powder particles MQP-14-12 have been used for the preparation of magnetic mixed matrix membranes. Permeability diffusion and sorption coefficients of O₂, N₂, and synthetic air components were estimated for homogeneous and heterogeneous membranes using the Time Lag method based on dynamic experiments in a constant pressure system. The influence of magnetic field and magnetic powder particles on the gas transport properties of MMMs was studied. The results showed that the membrane permeation properties were improved with the magnetic neodymium particle filling. It was observed that the magnetic ethylcellulose and poly(2,6-dimethyl-1,4-phenylene oxide) membranes showed higher gas permeability, while their permselectivity and solubility were rather maintained or slightly increased. The results also showed that the magnetic powder addition enhanced gas diffusivity significantly in EC and PPO membranes.     

Metallated conjugated polymers as a new avenue towards high-efficiency polymer solar cells

Bulk heterojunction solar cells have been extensively studied owing to their great potential for cost-effective photovoltaic devices. Although recent advances resulted in the fabrication of poly(3-hexylthiophene) (P3HT)/fullerene derivative based solar cells with efficiencies in the range 4.4-5.0%, theoretical calculations predict that the development of novel donor materials with a lower bandgap is required to exceed the power-conversion efficiency of 10%. However, all of the lower bandgap polymers developed so far have failed to reach the efficiency of P3HT-based cells. To address this issue, we synthesized a soluble, intensely coloured platinum metallopolyyne with a low bandgap of 1.85 eV. The solar cells, containing metallopolyyne/fullerene derivative blends as the photoactive material, showed a power-conversion efficiency with an average of 4.1%, without annealing or the use of spacer layers needed to achieve comparable efficiency with P3HT. This clearly demonstrates the potential of metallated conjugated polymers for efficient photovoltaic devices.