Aspirin-loaded electrospun poly(ε-caprolactone) tubular scaffolds: potential small-diameter vascular grafts for thrombosis prevention

Thrombosis is the main cause of failure of small-diameter synthetic vascular grafts when used for by-pass procedures. The development of bioresorbable vascular scaffolds with localized and sustained intra-luminal antithrombotic drug release could be considered a desirable improvement towards a valuable solution for this relevant clinical need. For this aim, we present the fabrication and characterization of aspirin-loaded electrospun poly(ε-caprolactone) tubular scaffolds as a vascular drug-delivery graft. Three different drug concentrations were considered (i.e., 1, 5 or 10 % w/w). Although a fibrous structure was clearly observed for all the collected scaffolds, aspirin content was directly implied in the final microstructure leading to a bimodal fiber diameter distribution and fused fibers at crossing-points (5 or 10 % w/w). Mechanical response highlighted a direct relationship for modulus and stress at break with the aspirin content, while the elongation at break was not remarkably different for the investigated cases. The temporal drug release was strongly dependent from the amount of loaded aspirin, reaching a steady state release after about 50 h. Finally, the adhesion assay confirmed the capability of the electrospun scaffolds to reduce platelet adhesion/aggregation onto aspirin loaded polymeric fibers. Aspirin-loaded electrospun tubular scaffold could represent a feasible candidate to develop a novel bioresorbable drug-releasing graft for small-diameter vessel replacements.     

Ferritic stainless steel welding with the A-TIG process

The main advantage of the TIG with flux process (A-TIG welding) is the possibility of obtaining greater penetration of the weld bead while employing the same welding parameters as conventional TIG welding. Various studies have shown the influence of active fluxes on the geometric characteristics of stainless steel austenitic welds. However, little is known about the influence of this process on the geometric and metallurgical characteristics of the weld beads in ferritic stainless steels. In this work, different types of flux are applied when welding ferritic stainless steel with the objective of verifying possible influences on the weld bead's profile, on its visual appearance, on the microstructure, on the hardness of the welded zone and on the impact resistance (Charpy test). The bead-on-plate welds were produced without using any addition metal. Six types of flux were used – one being an oxide produced in a laboratory (TiO₂) and five commercial fluxes. The results showed that use of the flux allows an increase in penetration with significant changes in the appearance of the weld bead. It was also confirmed that the microstructure and the hardness of the weld bead for the steel studied were not affected by the type of flux used, with the microstructure analysed under an optical microscope. The steel in the study showed a high degree of fragility at ambient temperature.     

Effect of olive fruit freezing on oxidative stability of virgin olive oil

Several studies have suggested that the phenolic fraction plays an important role during storage and therefore in the shelf life of virgin olive oil. This investigation examines the effect of freezing olives (–18 °C) before processing into oil on the transfer of the phenolic compounds into the subsequent oil, and the consequential changes in oxidative stability. Oil samples obtained from frozen olives (24 h at –18 °C), crushed with and without preliminary thawing, were compared to a control sample; both oils were obtained using a two‐phase low‐scale mill. The oxidative stability in different samples was assessed in terms of primary and secondary oxidation products as measured by peroxide values and oxidative stability index times, respectively. The quality of the oil samples was also checked through the percentage of free acidity and the phenolic content. Phenols were determined by both spectrophotometric assays (total phenols and o‐diphenols) and HPLC‐DAD/MSD. The antiradical capacity of the phenolic fraction was determined by DPPH and ABTS spectrophotometric tests. These analyses showed that thawing of olives before oil extraction led to a significant loss of oxidative stability and phenols; in contrast, samples obtained from frozen olives that were not thawed before crushing showed qualitative characteristics similar to control samples.     

Matrix-assisted laser desorption/ionization-ion mobility separation-mass spectrometry imaging of vinblastine in whole body tissue sections

During early-stage drug development, drug and metabolite distribution studies are carried out in animal tissues using a range of techniques, particularly whole body autoradiography (WBA). While widely employed, WBA has a number of limitations, including the following: expensive synthesis of radiolabeled drugs and analyte specificity and identification. WBA only images the radiolabel. MALDI MSI has been shown previously to be advantageous for imaging the distribution of a range of drugs and metabolites in whole body sections. Ion mobility separation (IMS) adds a further separation step to imaging experiments; demonstrated here is MALDI-IMS-MS whole body imaging of rats dosed at 6 mg/kg i.v. with an anticancer drug, vinblastine and shown is the distribution of the precursor ion m/z 811.4 and several product ions including m/z 793, 751, 733, 719, 691, 649, 524, and 355. The distribution of vinblastine within the ventricles of the brain is also depicted. Clearly demonstrated in these data are the removal of interfering isobaric ions within the images of m/z 811.4 and also of the transition m/z 811-751, resulting in a higher confidence in the imaging data. Within this work, IMS has shown to be advantageous in both MS and MS/MS imaging experiments by separating vinblastine from an endogenous isobaric lipid.     

Impedimetric thrombin aptasensor based on chemically modified graphenes

Highly sensitive biosensors are of high importance to the biomedical field. Graphene represents a promising transducing platform for construction of biosensors. Here for the first time we compare the biosensing performance of a wide set of graphenes prepared by different methods. In this work, we present a simple and label-free electrochemical impedimetric aptasensor for thrombin based on chemically modified graphene (CMG) platforms such as graphite oxide (GPO), graphene oxide (GO), thermally reduced graphene oxide (TR-GO) and electrochemically reduced graphene oxide (ER-GO). Disposable screen-printed electrodes were first modified with chemically modified graphene (CMG) materials and used to immobilize a DNA aptamer which is specific to thrombin. The basis of detection relies on the changes in impedance spectra of redox probe after the binding of thrombin to the aptamer. It was discovered that graphene oxide (GO) is the most suitable material to be used as compared to the other three CMG materials. Furthermore, the optimum concentration of aptamer to be immobilized onto the modified electrode surface was determined to be 10 μM and the linear detection range of thrombin was 10-50 nM. Lastly, the aptasensor was found to demonstrate selectivity for thrombin. Such simply fabricated graphene oxide aptasensor shows high promise for clinical diagnosis of biomarkers and point-of-care analysis.     

High Resolution Crystal Structures of the Cerebratulus lacteus Mini-Hb in the Unligated and Carbomonoxy States

The nerve tissue mini-hemoglobin from Cerebratulus lacteus (CerHb) displays an essential globin fold hosting a protein matrix tunnel held to allow traffic of small ligands to and from the heme. CerHb heme pocket hosts the distal TyrB10/GlnE7 pair, normally linked to low rates of O(2) dissociation and ultra-high O(2) affinity. However, CerHb affinity for O(2) is similar to that of mammalian myoglobins, due to a dynamic equilibrium between high and low affinity states driven by the ability of ThrE11 to orient the TyrB10 OH group relative to the heme ligand. We present here the high resolution crystal structures of CerHb in the unligated and carbomonoxy states. Although CO binds to the heme with an orientation different from the O(2) ligand, the overall binding schemes for CO and O(2) are essentially the same, both ligands being stabilized through a network of hydrogen bonds based on TyrB10, GlnE7, and ThrE11. No dramatic protein structural changes are needed to support binding of the ligands, which can freely reach the heme distal site through the apolar tunnel. A lack of main conformational changes between the heme-unligated and -ligated states grants stability to the folded mini-Hb and is a prerequisite for fast ligand diffusion to/from the heme.     

Production,Characterization and Synthetic Application of a Purine Nucleoside Phosphorylase from Aeromonas hydrophila

Purine nucleoside phosphorylase (PNP) from Aeromonas hydrophila encoded by the deoD gene has been over‐expressed in Escherichia coli, purified, characterized about its substrate specificity and used for the preparative synthesis of some 6‐substituted purine‐9‐ribosides. Substrate specificity towards natural nucleosides showed that this PNP catalyzes the phosphorolysis of both 6‐oxo‐ and 6‐aminopurine (deoxy)ribonucleosides. A library of nucleoside analogues was synthesized and then submitted to enzymatic phosphorolysis as well. This assay revealed that 1‐, 2‐, 6‐ and 7‐modified nucleosides are accepted as substrates, whereas 8‐substituted nucleosides are not. A few transglycosylation reactions were carried out using 7‐methylguanosine iodide ( 4 ) as a D ‐ribose donor and 6‐substituted purines as acceptor. In particular, following this approach, 2‐amino‐6‐chloropurine‐9‐riboside ( 2c ), 6‐methoxypurine‐9‐riboside ( 2d ) and 2‐amino‐6‐(methylthio)purine‐9‐riboside ( 2g ) were synthesized in very high yield and purity.     

Structure-quality relationship in commercial pasta: a molecular glimpse

Presence and stability of a protein network was evaluated by fluorescence spectroscopy, by protein solubility studies, and by assessing the accessibility of protein thiols in samples of commercial Italian semolina pasta made in industrial plants using different processes. The pasting properties of starch in each sample were evaluated by means of a viscoamylograph. Magnetic resonance imaging (MRI) was used to evaluate water distribution and water mobility in dry pasta, and at various cooking times. The molecular information derived from these studies was related to sensory indices, indicating that protein reticulation was dependent on the process conditions, which affected water penetration, distribution, and mobility during cooking. Products with a crosswise gradient of water mobility once cooked had the best sensory scores at optimal cooking time, whereas products with a less compact protein network performed better when slightly overcooked.     

How to increase the safety and efficacy of compounds against neurodegeneration? A multifunctional approach

Successful drug design requires not only the detailed knowledge of the pharmacokinetic and pharmacodynamic profiles of the drug candidate portfolio but also a thorough documentation of the possible toxic effects on humans and the environment. Thus, experimental and computational strategies able to measure or predict specific profiles of designed compounds related to their potential toxicity are highly desired. Moreover, a strategy to avoid toxic effects thus enhancing the potential efficacy of drug candidates is of great interest. To fulfil this aim, the pharmacochemistry research unit at the EPGL has recently developed and improved methodologies that detect the potential human health and environmental hazards of compounds active against neurodegeneration at an early stage. A three-step strategy is presented herein. In particular, i) an alternative index to model the bioconcentration of chemicals in the environment was determined; ii) the antioxidant activity of chemical species against free radicals was evaluated. Moreover, since antioxidants play a key role in both toxicity prevention and neuroprotection, iii) the potential interaction of such compounds with enzymatic targets involved in the neurodegenerative cascade was investigated in silico.     

Development of a real-time PCR assay for the detection of cow and donkey milk

A real-time PCR allelic discrimination TaqMan assay based on the analysis of a single nucleotide polymorphism enabling the differentiation of cow (Bos taurus) and donkey (Equus asinus) milk was developed. Specific primers and probes were designed on the mitochondrial cytochrome c oxidase subunit I gene. The primers were designed upstream and downstream the chosen diagnosis site in a conserved region. Two probes were designed to specifically hybridise to B. taurus and E. asinus sequences. The test allowed the discrimination of bovine and donkey DNA in all blood and pure milk samples giving an unambiguous result plot of rapid and easy interpretation. The detection threshold was 2?% of cow milk in donkey milk. The applicability of the method to matrices containing degraded DNA was demonstrated by analysing samples of raw donkey and cow milk autoclave-treated (121?°C for 15?min). Finally, the assay when applied to milk samples collected from the retail trade has confirmed the species indicated in the label. Furthermore, the assay represents a potentially valuable diagnostic tool for species identification in dairy products for allergic people.