An attempt to compare the performance of bioscrubbers and biotrickling filters for degradation of ethyl acetate in gas streams

This study presents a comparison of the efficiency of a bioscrubber and a biotrickling filter (BTF) for the removal of ethyl acetate (EA) vapour from a waste gas stream, under the same operating conditions. The maximum EA elimination capacity achieved in the bioscrubber was 550 g m^?3 h^?1 with removal efficiency higher than 96%. For higher EA loadings the bioscrubber was oxygen limited, which caused incomplete EA biodegradation. When pure oxygen was fed to the bioscrubber at a rate of 0.02 L min^?1, the bioscrubber recovered and could treat higher EA loadings without any oxygen limitation. The BTF achieved EA elimination capacity of 600 g m^?3 h^?1 with removal efficiency higher than 97% and the dissolved oxygen concentration remained substantially higher than in the bioscrubber. However, severe channelling and blockage of the spray nozzle occurred due to the excessive biomass growth. Overall, the bioscrubber system was easier to operate and control than the BTF, while an enhancement of the oxygen mass transfer in the bioscrubber could potentially increase its performance by up to three times. Copyright © 2005 Society of Chemical Industry     

Guest Editors' Introduction: Social Media and Search

The past few years have seen a rapid rise in social media Web sites. As user content becomes the dominant content form on the Web, various questions arise about the most effective approach to processing it.     

The radiation crosslinking and scission of ethylene-propylene copolymers studied by solid-state nuclear magnetic resonance

Methyl groups from chain scission and H-crosslinks have been identified by solid-state nuclear magnetic resonance in amorphous ethylene-propylene copolymers containing 23 and 36 mole % propylene after γ-irradiation to 10 MGy at 30°C. G (scission) and G (crosslink) values determined from the n.m.r. spectra and by extraction are in agreement, which suggests that the crosslinks are not clustered. This may differ from the situation in polyethylene where there is a substantial crystalline content. G(S). G(X) and the ratio G(S)/G(X) increase with increasing propylene content of the copolymers.     

Kinetic analysis of the crystallization of poly(p-phenylene sulphide)

Growth rates of spherulites were measured in poly(p-phenylene sulphide) crystallized from the melt and the quenched glass over the temperature range 100°C–280°C, possibly the most extensive overall range yet reported for any polymer and, as such, most propitious for study of régime III crystallization. For a medium M.wt. polymer, a régime II → III transition was obtained at 208°C using values of transport parameters common to many polymers ($\text{U1 = 1400}\text{cal mol}{}^{\mathrm{?1}}$, T_∞ ? T_g = 30°C) together with experimentally determined values of T⁰_m(315°C) and T_g(92°C). Under these conditions, the régime III/II slope ratio was found to be 2.07 (i.e. only 3.5% higher than predicted by régime theory), and reasonable estimates of surface free energies and of the work of chain folding were obtained. Other choices of the transport terms, including WLF and zero values, did not allow successful kinetic analyses. Although a régime I → II transition is predicted to occur at the high-temperature end of our growth-rate data, we found no experimental evidence for it. For a low M.wt. polymer, our analysis showed that régime III kinetics is obeyed at low temperatures, while at higher ones there is a continuous departure from that behaviour without, however, full attainment of régime II kinetics.     

PROBABILISTIC MODELLING OF LIGNIN LIQUEFACTION

The results of the thermal and catalytic reactions of lignin model compounds are used in the a priori prediction of its liquefaction. Lignin was defined probabilistically as an ensemble of single ring aromatics with substituents on each of their six ring positions. Elements in a substituent vector x¹, for each ring position i, were matched into all possible combinations to describe lignin. Initial number fractions, or probabilities, for each vector element were ascertained through inspection of lignin structural data. The reaction of lignins altered the probabilities within each substituent vector, and reaction products were also calculated by matching all combinations of vector elements for each ring position. Model compound results provided the identities and rates of change of vector elements.

This simulation of lignin liquefaction predicted the yields of permanent gases, aqueous liquids, single- and two-ring phenolic products, and a carbonaceous residue. The impact of the distribution of oligomeric sizes on catalyst effectiveness was probed.     

Continuous Renal Replacement Therapy for Liver Disease

Continuous renal replacement therapy (CRRT) is becoming the treatment of choice for critically ill patients with acute renal failure around the world. In particular, CRRT is used for patients with combined liver and acute renal failure, because they are often hemodynamically unstable. The question arises as to whether the use of CRRT should be extended to those patients with acute and chronic liver failure who do not have dialysis-dependent renal failure. CRRT could potentially allow some detoxification by removing water-soluble toxins and also allow regulation of intravascular volume and correction of sodium and other electrolyte and acid–base imbalances. By providing homeostatic control, CCRT could potentially help support patients by bridging to liver transplantation and managing those who eventually recover with hepatic regeneration.     

Measurement of Energy Expenditure in Elite Athletes Using MEMS-Based Triaxial Accelerometers

Fitness development and performance assessment of elite athletes requires an understanding of many physiological factors, many of these are direct and indirect measures of athlete energy expenditure. Many methods are physiological factor assessments and require the athlete to be constrained by laboratory equipment or periodic interruption of activity to take measurements such as blood samples are required to be taken. This paper presents a method that is entirely ambulatory and noninvasive, using microelectromechanical systems (MEMS) accelerometers. The commonly used output of commercial accelerometer-based devices (known as "counts") cannot discriminate activity intensity for the activities of interest. This, in conjunction with variability in output from different systems and lack of commonality across manufacturers, limits the usefulness of commercial devices. This paper identifies anthropometric and kinematic sources of inter-athlete variability in accelerometer output, leading to an alternate energy expenditure estimator based mainly on step frequency modified by anthropometric measures. This energy expenditure estimator is more robust and not influenced by many sources of variability that affect the currently used estimator. In this system, low-power signal processing was implemented to extract both the energy estimator and other information of physiological and statistical interest     

Individual differences in self-assessed health: An information-processing investigation of health and illness cognition.

In 2 studies, the relation between measures of self-assessed health (SAH) and automatic processing of health-relevant information was investigated. In Study 1, 84 male and 86 female undergraduate students completed a modified Stroop task. Results indicated that participants with poorer SAH showed enhanced interference effects for illness versus non-illness words. In Study 2, 27 male and 30 female undergraduate students completed a self-referent encoding task. Results offered a conceptual replication and extension of Study 1 by confirming the specificity of the relation between SAH measures and automatic processing of health (vs negative or positive general trait) information. These studies provide evidence that individual differences in SAH are reflected in schematic processing of health-relevant information. (PsycINFO Database Record (c) 2010 APA, all rights reserved)