On the dynamic self-diffraction in methylene blue-sensitised gelatine

Dynamic self-diffraction processes have been observed and analysed for methylene blue-sensitised water-swollen gelatine (MBSG). A degenerate two-wave mixing experiment performed on thick samples of MBSG with 10 mW, 632.8 nm wavelength He Ne laser light allowed for the formation of phase- and amplitude-transient holographic gratings. Single-beam propagation characteristics through MBSG were measured with a Mach-Zehnder interferometer. The observed energy transfer between the writing beams in the two-beam coupling experiment and the considerable temporal oscillations of diffraction efficiency are explained by simple formulae. Two processes are considered: the time-dependent phase shift between the writing beams and the transverse self-phase modulation effects (self-focusing and interference ring formation).     

Residual stresses in epoxy systems by 3-D photoelastic method

The new 3-D photoelastic method was applied to the studies of residual stresses around spherical inclusion in polymeric matrices. Full stress tensor for several model samples was measured. The extent of significant stresses is not greater than three radii of an inclusion. It was found that the stress follows the 1/R³ rule at distances far from the inclusion, while in the narrow zone at the interface a plateau is observed. The level of stress ranges from few MPa up to the plastic yield of the polymeric matrix. The radial stress component is usually twice as large as the tangential stress component. Radial negative stress and tangential positive stresses are found in configuration with a hard inclusion, while radial positive stress and tangential negative stresses are in the systems with soft inclusion. The pressure in the matrix at points around inclusions calculated from the stress tensor is always near zero MPa, which indicates the action of purely deviatoric stresses in the matrix.     

Influence of Nb5+ ions on phase transitions and polar disorder above TC in PbZrO3 studied by Raman spectroscopy

Micro-Raman light scattering experiments on PbZrO₃ (PZO) single crystal doped with Nb⁵⁺ have been investigated. Special attention was paid to the paraelectric (PE) phase in which nominally forbidden first-order Raman spectra were detected at temperatures far above the phase transition T_C. Complex Raman spectra were observed in the vicinity of three structural phase transitions. These results mainly from the coexistence of phases with different symmetries in a wide temperature range below T_C. The Raman measurements have been compared with dielectric and optical observations and proved that polar nanoregions in a centrosymmetric lattice appear well above T_C. It was shown that doping ABO₃ perovskites with heterovalent ions like Nb⁵⁺ unbalances charge neutrality of the lattice and strongly extends the temperature range of polar regions. The investigations performed point out that in the PE matrix the interaction between electrons and lattice vibrations, as recently suggested for pure PZO, plays an important role.     

Hydrostatic pressure influence on electric relaxation response of bismuth manganite ceramics

Electrical impedance of bismuth manganite ceramics was studied under ambient and high hydrostatic pressure. Local disorder of crystal lattice was confirmed using XRD and DSC. Two relaxation processes were discerned. One was attributed to small polarons, which showed a changeover from variable range hopping features related to Fermi glass and structural disorder to the nearest neighbor hopping behavior in higher temperature range related to uniform distribution of energy levels. Hydrostatic pressure shortened relaxation times that would be interesting for applications. The second process, which was assigned to the nearest neighbor hopping of polarons, also exhibited a changeover to glassy features in a high-temperature range.     

New lake district in Europe: origin and hydrochemical characteristics

This article presents a new lake district in Southern Poland created as a result of human activity in the Upper Silesian region. The area has been named the Upper Silesian Anthropogenic Lake District. The lake density of the Lake District as delineated by the authors (with an area of 6766 km²) is 2.74%. It includes 4773 water bodies of various origins – reservoirs retained by dams, flooded mineral workings, water bodies formed in subsidence basins and hollows, levee ponds, residual water bodies following river regulation and other water bodies. These are located in urban‐industrial, rural‐agricultural or quasi‐natural areas. The hydrochemical diversity of water bodies is conditioned by their origin, location in the catchment and function. Studies have shown the widespread occurrence of eutrophication processes in limnic waters within the Lake District. The diverse origin and hydrochemical properties of water bodies within the Upper Silesian Anthropogenic Lake District make it special among other anthropogenic lake districts.     

Fluorine-Containing Drug Administration in Rats Results in Fluorination of Selected Proteins in Liver and Brain Tissue

In many pharmaceuticals, a hydrogen atom or hydroxyl group is replaced by a fluorine to increase bioavailability and biostability. The fate of fluorine released from fluorine-containing drugs is not well investigated. The aim of this study was to examine possible fluorination of proteins in rat liver and brain after administration of the fluorinated drug cinacalcet. We assigned 18 Wistar rats to a control group (n = 6) and a group treated with cinacalcet (2 mg kg⁻¹/body weight, 5 days/week), divided into 7 day (n = 6) and 21 day (n = 6) treatment subgroups. Fluorinated proteins were identified using a free proteomics approach; chromatographic separation and analysis by high-resolution mass spectrometry; peptide/protein identification using the Mascot search algorithm; manual verification of an experimentally generated MS/MS spectrum with the theoretical MS/MS spectrum of identified fluorinated peptides. Three fluorinated proteins (spectrin beta chain; carbamoyl-phosphate synthase [ammonia], mitochondrial; 6-phosphofructo-2-kinase/fructose-2, 6-bisphosphatase 1) were identified in the liver and four (spectrin beta chain, dihydropyrimidinase-related protein 4, prominin-2, dihydropyrimidinase-related protein 4) in the brain tissue after 21 days of cinacalcet treatment, but not in the control group. Introduction of fluorine into an organism by administration of fluorinated drugs results in tissue-specific fluorination of proteins.     

Multi-level backcalculation algorithm for robust determination of pavement layers parameters

The backcalculation procedure applied to a mechanical characterization of the road pavement is usually limited to an identification of the elastic modulus of each layer only. The remaining parameters of the model are usually set as known, while performing an inverse analysis. Among assumed parameters are thicknesses of the model layers and frequently considered as constants on a homogeneous section of the road. This is an obvious simplification, because sections in general are inhomogeneous, i.e. the thickness of each layer changes slightly along each road section. Thus the precise and possibly nondestructive estimation of the layers thicknesses is very important and crucial in the inverse procedure. Here, a hybrid form of the optimization algorithm, where the condition of a constant thickness does not need to be fulfilled is described. Further on, the objective function is formed as a discrepancy between reference and computed deflection derivative instead of a deflection curve. In consequence, the values of backcalculated parameters are several per cent more precise compared to a standard procedure. Whenever the thickness of the asphalt layer of the pavement structure cannot be assumed a priori as a constant, the proposed here method appears to be necessary if one does not want to perform costly and destructive in situ drilling tests.     

Evaluation of the mechanical behavior of W7-X central support connections by means of semi-automated FE analysis

The stellarator Wendelstein 7-X is under construction at the Max-Planck-Institut für Plasmaphysik in Greifswald. Its superconducting coil system is fixed by a massive structure. During machine operation the coils exert high forces and moments against each other and the central support structure (CSS). Therefore, the detailed analysis of the coil to CSS connections, the so-called central support elements (CSE), is a critical item. The major details of the design have been frozen; nevertheless, there is still need for detailed analysis of the CSEs due to assembly issues, and later on for exploring operational limits of the machine. These analyses have to be performed quickly, reliably, and shall provide results in a standardized form to enable timely responses to the assembly team. Special numerical tools – finite element (FE) parametric models of CSEs – have been developed for the purpose of such analyses. In the models, the geometry, material properties, contact conditions, loads as well as results presentation are defined in a parametric way. The use of the developed models for the definition of the final weld parameters, bolt preloads, assessment of acceptable tolerances, and optimal positions of the CSE-wedges before welding is also discussed.