A GC-EI-MS/MS Method for the Determination of 15 Polybrominated Diphenyl Ethers (PBDEs) in Fish and Shellfish Tissues

This paper describes the development and validation of an analytical method to determine 15 polybrominated diphenyl ethers (PBDEs) in fish and shellfish tissues with gas chromatography coupled to triple quadrupole mass spectrometry using electron impact source (GC-EI-MS/MS). A QuEChERS (Quick, Easy, Cheap, Effective, Rugged, and Safe)-like procedure was applied; the extract was cleaned up on an acidic Extrelut-NT3 column connected on top of a silica cartridge and further purified with gel permeation chromatography (GPC). The SIM acquisition proved to yield better results than traditional MRM approach for octa-, nona-, and deca-brominated congeners. The validation study was carried out in inter-laboratory conditions. The average recoveries were in the range 66–118%, with relative standard deviations generally lower than or equal to 22%. Quality assurance and quality control practices were thoroughly described and highlighted. These long and tedious practices are fundamental to obtain reliable quantitative data during food monitoring programs and, therefore, to support daily intake assessments. Finally, the procedure was applied to the analysis of marine fish samples collected in local markets. Mackerel and mullet were the most contaminated species.     

Relationship Between Chemical Markers and Sensory Score of Traditional Balsamic Vinegars Using a Screening Approach Combined with Rapid Assessment Methods

In this study, 200 samples of traditional balsamic vinegar (TBV) of Reggio-Emilia, a typical Italian “aged dressing” with Protected Denomination of Origin, were analyzed to model the relationship between sensory scores with some pre-selected compounds/parameters, such as Brix value, water activity (a _w), titratable acidity, color, polymeric compounds, and electronic nose signal. Statistical techniques, such as nonlinear regression and Principal Component Analysis (PCA) were used to model the relationship among vinegars composition. The sensory score of panelists was mainly correlated with Brix (r?=?0.85) followed by brown color at 445 nm (r?=?0.74) and water activity (a _w) (r?=??0.79), whereas the polymeric compounds content showed a negative correlation with water activity (r?=?–0.73). In particular, the water activity of TBVs at different Brix values followed a nonlinear trend with good fitting (r?=?0.857) with K?=?3.10 that was consistent with the value reported in the literature for fructose and glucose. Electronic nose (enose) data from TBVs and six marker compounds (acetic acid, butyric acid, vanillin, ethyl-phenylacetate, phenylethyl alcohol, and furfural) combined with PCA revealed a pattern related to the ageing of TBVs.     

In vitro antifungal activity of several antimicrobial compounds against Penicillium expansum

Fungicides used in the prevention and control of mold rots in stored apples are subjected to legal, social, and biological limitations. The aim of this study was to find an alternative to postharvest fungicides currently used in the prevention and control of blue mold rot caused by Penicillium expansum in apples. For this purpose, the antimicrobial activity and MIC of several substances against P. expansum were evaluated in vitro using different end point methods: agar diffusion assay, volatility method, and agar dilution and broth dilution MIC assays. Most of the substances tested are common food ingredients and have a recognized antimicrobial activity. Essential oils, such as thymol, eugenol, citral and cineole, vanillin, sodium hypochlorite, acetic acid, potassium sorbate, and hydrogen peroxide, were the substances evaluated. Thymol and citral were the essential oil components that showed the greatest inhibitory effects. The effectiveness of 5 and 10% hydrogen peroxide in growth inhibition of P. expansum in the agar diffusion assay was total, and its MIC as determined by the agar and broth dilution assays was less than 0.025%. These results indicate that the application of small quantities of hydrogen peroxide to the apple skin might be an alternative to fungicides in the elimination of P. expansum.     

De nouveaux stannures ternaires de rhodium et d'elements des terres rares : TR2Rh3Sn5 OU TR = Y,Gd, Tb,Dy, Ho. structure cristalline et proprietes electriques et magnetiques de Y2Rh3Sn5

New ternary stannides are reported : RE₂Rh₃Sn₅ (RE = Y, Gd, Tb, Dy, Ho). Y₂Rh₃Sn₅ has been studied by single - crystal X-ray diffraction analysis. Its structure is of a new type with space group Cmc2₁ and Z = 4 : a = 4,387(2), b = 26,212(4), $\text{c}\text{= 7,1550(8)}\text{A}\text{?}$, D_x = 8,71 Mgm^?3, μ(AgK_α) = 17 mm^?1, F(000) = 1851, R = 0,045 for 478 independant reflexions (R_w = 0,046). This structure is characterized by a tridimensionnal lattice of RhSn covalent bonds with two very different sites for yttrium. Y₂Rh₃Sn₅ is diamagnetic and semimetallic according to its electrical properties.     

Exploiting transition locality in automatic verification of finite-state concurrent systems

In this paper we show that statistical properties of the transition graph of a system to be verified can be exploited to improve memory or time performances of verification algorithms.We show experimentally that protocols exhibit transition locality. That is, with respect to levels of a breadth-first state space exploration, state transitions tend to be between states belonging to close levels of the transition graph. We support our claim by measuring transition locality for the set of protocols included in the Mur verifier distribution .We present a cache-based verification algorithm that exploits transition locality to decrease memory usage and a disk-based verification algorithm that exploits transition locality to decrease disk read accesses, thus reducing the time overhead due to disk usage. Both algorithms have been implemented within the Mur verifier.Our experimental results show that our cache-based algorithm can typically save more than 40% of memory with an average time penalty of about 50% when using (Mur) bit compression and 100% when using bit compression and hash compaction, whereas our disk-based verification algorithm is typically more than ten times faster than a previously proposed disk-based verification algorithm and, even when using 10% of the memory needed to complete verification, it is only between 40 and 530% (300% on average) slower than (RAM) Mur with enough memory to complete the verification task at hand. Using just 300 MB of memory our disk-based Mur was able to complete verification of a protocol with about 10⁹ reachable states. This would require more than 5 GB of memory using standard Mur .     

Optical properties of high-density dispersions of particles: application to intralipid solutions

We propose to study the scattering properties of dense distributions of spherical scatterers by resorting to an iterative solution of the Foldy-Twersky equation for the propagation of the coherent field. As a result of the first step of the iterative procedure, the host medium is substituted by an effective medium of complex refractive index to account for the multiple-scattering processes that occur among the particles. Although we truncate the above-mentioned iterative procedure to the second step, the results of our calculations are in excellent agreement with previous experimental results of Zaccanti et al. ("Measurement of optical properties of high-density media," to be published in Applied Optics) for the scattering coefficient of Intralipid solutions up to a volume density of 15% and show a limited disagreement at a volume density of 22%.     

Bio-inspired solutions for locomotion in the gastrointestinal tract: background and perspectives

This paper illustrates a bio-inspired approach to effective, smooth and safe navigation in the human body and, in particular, in the gastrointestinal tract. This idea originates from the medical need to develop more powerful tools for microendoscopy, which is one of the most challenging frontiers of modern medicine. Understanding motion and perception systems of lower animal forms, such as parasites, worms, insects and snakes, can help to design and fabricate bio-inspired robots able to navigate in tortuous, slippery and difficult-to-access cavities of the human body. A preliminary study of a biomimetic adhesion system for the human tissues is presented in this work and some technological implementations are illustrated and discussed. Finally, some issues concerning the goals of smart and reactive locomotion are considered and the most promising and relevant enabling technologies are discussed.     

Usage of SoS methodologies in production system design

Production systems design is a multifaceted task, due to a variety of aspects such as the mutual interdependency between the sub-systems, the variety of configurations and alternative system control strategies, the multiple managerial and “soft” aspects that cast an influence on the behavior of the system. A reasonable number of modeling tools can be applied to production system design, but they tend to divide the problem into unconnected sub-problems whose individual solutions may result in a poor global one. This is despite the fact that production design encompasses all aspects of manufacturing operations, and needs a systemic approach, as clearly shown in practitioner-oriented literature. This paper proposes to apply the “System of Systems” approach to production system design in order to represent their main aspects and support the rational definition of the path leading from corporate strategy to system (re)design.     

Characterization of soil deformation due to blast-induced liquefaction by UAV-based photogrammetry and terrestrial laser scanning

ABSTRACT

Soil liquefaction due to an earthquake can lead to permanent soil deformation and reduction of load-bearing capacity that in turn could act on building stability. Since a quantitative evaluation of post-liquefaction settlements is often very difficult, field scale liquefaction tests, carried out under controlled conditions, such as blast tests, are used to perform a correct quantitative analysis of the liquefaction phenomena. Among the significant parameters related to a blast test, there are the geometric ones, i.e. the extension of the area affected by the blast-induced liquefaction and the corresponding vertical displacements. This article shows the results of a blast test carried out at a trial site located in Mirabello (Ferrara, Italy) from a remote-sensing perspective. Data provided by aerial Structure-from-Motion photogrammetry, supported by terrestrial laser scanning measurements, were used to evaluate the soil deformation that, in the specific case study, aided a geological/geotechnical interpretation of the blast test results. In general, the proposed method can be used to characterize areas affected by blast-induced liquefaction, including those cases where blasting is used as ground improvement technique aimed at mitigating the seismic hazard.