In vitro cytotoxicity of oxide nanoparticles: comparison to asbestos, silica, and the effect of particle solubility

Early indicators for nanoparticle-derived adverse health effects should provide a relative measure for cytotoxicity of nanomaterials in comparison to existing toxicological data. We have therefore evaluated a human mesothelioma and a rodent fibroblast cell line for in vitro cytotoxicity tests using seven industrially important nanoparticles. Their response in terms of metabolic activity and cell proliferation of cultures exposed to 0-30 ppm nanoparticles (microg g(-1)) was compared to the effects of nontoxic amorphous silica and toxic crocidolite asbestos. Solubility was found to strongly influence the cytotoxic response. The results further revealed a nanoparticle-specific cytotoxic mechanism for uncoated iron oxide and partial detoxification or recovery after treatment with zirconia, ceria, or titania. While in vitro experiments may never replace in vivo studies, the relatively simple cytotoxic tests provide a readily available pre-screening method.     

A Cassava Starch–Chitosan Edible Coating Enriched with <Emphasis Type="Italic">Lippia sidoides</Emphasis> Cham. Essential Oil and Pomegranate Peel Extract for Preservation of Italian Tomatoes (<Emphasis Type="Italic">Lycopersicon esculentum</Emphasis> Mill.) Stored at Room Temperature

The effect of edible cassava starch–chitosan coatings incorporated with rosemary pepper (Lippia sidoides Cham.) essential oil and pomegranate peel extract on the shelf-life of tomatoes during storage at 25 °C for 12 days was investigated. Sixteen formulations, containing 10 g L^?1 cassava starch and various concentrations of chitosan (5, 10, 20, 30 g L^?1), essential oil (0, 2.5, 5, 10 mL L^?1) and pomegranate peel extract (0, 5, 10, 20 mL L^?1) were prepared and applied to tomatoes. Physical–chemical and microbiological analyses were performed on days 1, 4, 8 and 12. Most of the coatings delayed the ripening of tomatoes, lowering the total soluble solids (38?44 g sucrose kg^?1) and weight loss (93?128 g kg^?1) and maintaining constant firmness compared to the uncoated tomatoes (45 g sucrose kg^?1, 175 g kg^?1) at 12 days of storage. Conversely, except red intensity (a*), which was higher for the uncoated samples, the colour parameters (L*, b*) of the coated and control tomatoes were similar at the end of storage. Uncoated and coated tomatoes showed no contamination during storage. The coatings showed potential to maintain the quality of tomatoes during storage at 25 °C for 12 days. In this context, tomatoes coated with the formulation comprising 10 g L^?1 cassava starch, 10 g L^?1 chitosan, 10 mL L^?1 essential oil and 20 mL L^?1 pomegranate peel extract showed the lowest weight loss and reduced total soluble solids content compared with uncoated ones.     

HXT5 expression is determined by growth rates in Saccharomyces cerevisiae

In the yeast Saccharomyces cerevisiae, hexose transporter (Hxt) proteins transport glucose across the plasma membrane. The Hxt proteins are encoded by a multigene family with 20 members, of which Hxt1-4p and Hxt6-7p are the major hexose transporters. The remaining Hxt proteins have other or unknown functions. In this study, expression of HXT5 under different experimental set-ups is determined. In glucose-grown batch cultures, HXT5 is expressed prior to glucose depletion. Independent of the carbon source used in batch cultures, HXT5 is expressed after 24 h of growth and during growth on ethanol or glycerol, which indicates that growth on glucose is not necessary for expression of HXT5. Increasing the temperature or osmolarity of the growth medium also induces expression of HXT5. In fed-batch cultures, expression of HXT5 is only observed at low glucose consumption rates, independent of the extracellular glucose concentration. The only common parameter in these experiments is that an increase of HXT5 expression is accompanied by a decrease of the growth rate of cells. To determine whether HXT5 expression is determined by the growth rate, cells were grown in a nitrogen-limited continuous culture, which enables modulation of only the growth rate of cells. Indeed, HXT5 is expressed only at low dilution rates. Therefore, our results indicate that expression of HXT5 is regulated by growth rates of cells, rather than by extracellular glucose concentrations, as is the case for the major HXTs. A possible function for Hxt5p and factors responsible for increased expression of HXT5 upon low growth rates is discussed.     

A concept of the multipurpose liquid metallic-fueled fast reactor system (MPFR)

Against fossil fuels, the nuclear energy is the only alternative energy source in the next century. Such energy source as the future nuclear power plant is expected to meet the following requirements. First, high temperature output for the multiple energy conversion capability as the electricity generation and the production of alternative fuels (hydrogen), which can be used widely in transportation systems. Second, the capability for siting close to the energy consumption area without onsite refueling. Third, the capability for nuclear fuel breeding and incineration of long-lived fission products, and fourth, the harmonization between active and passive safety features. This paper describes the basic concept of the Multipurpose liquid metallic-fueled Fast Reactor system (MPFR), which satisfies all mentioned requirements with introducing the U-Pu-x (x: Mn, Fe, Co) liquid metallic alloys for the fuel. We can obtain such characteristics as high operational temperature of the reactor (between 550 °C and 1200 °C) and elongation of the core operational lifetime by the inherent fission product separation in the liquid fuel by using these alloys. The enhanced self-controllability is achieved by the thermal expansion of liquid fuel; and the re-criticality phenomenon at the core compaction events can be eliminated by discharging of the liquid fuel from the core.     

Stable Isotopes of Carbon and Oxygen as a Possible New Tool for Estimating Firing Temperatures of Ancient Pottery

The ratios of the stable isotopes of carbon (¹³C/¹²C) and oxygen (¹⁸O/¹⁶O) in calcite in clays that contain carbonate and that were fired at temperatures between 500 and 700 °C displayed a good correlation with the firing temperature for both isotopes. The isotopic composition indicated that the original carbonate was either completely decomposed or that it exchanged with environmental CO₂ to obliterate the original isotopic signature. The isotopic effects seem to be kinetically controlled. The isotope thermometer is used to compare refiring temperatures of pottery which was fired under controlled conditions. The differences between calculated and actual temperatures did not exceed 132 °C and in most cases was about 50 °C or less. Isotopic analysis of pottery from Tel Miqne-Ekron and Deir el Balah, dated to the 13th–12th centuries BC, gave an average ancient firing temperature of about 600 °C. If shown to be of general validity, then perhaps this technique can be used also for estimating preparation temperatures of ancient mortar, especially when preserved in dry climates where later changes would be minimized.     

In situ electrochemical impedance spectroscopy/synchrotron radiation grazing incidence X-ray diffraction—A powerful new technique for the characterization of electrochemical surfaces and interfaces

A marriage of electrochemical impedance spectroscopy (EIS) and in situ synchrotron radiation grazing incidence X-ray diffraction (SR-GIXRD) has provided a powerful new technique for the elucidation of the mechanistic chemistry of electrochemical systems. In this study, EIS/SR-GIXRD has been used to investigate the influence of metal ion buffer calibration ligands, along with natural organic ligands in seawater, on the behaviour of the iron chalcogenide glass ion-selective electrode (ISE). The SR-GIXRD data demonstrated that citrate - a previously reported poor iron calibration ligand for the analysis of seawater - induced an instantaneous and total dissolution of crystalline GeSe and Sb₂Se₃ in the modified surface layer (MSL) of the ISE, while natural organic ligands in seawater and a mixture of ligands in a mimetic seawater ligand system protected the MSL's crystalline inclusions of GeSe and Sb₂Se₃ from oxidative attack. Expectedly, the EIS data showed that citrate induced a loss in the medium frequency time constant for the MSL of the ISE, while seawater's natural organic ligands and the mimetic ligand system preserved the medium frequency EIS response characteristics of the ISE's MSL. The new EIS/SR-GIXRD technique has provided insights into the suitability of iron calibration ligands for the analysis of iron in seawater.     

Coronary artery perforation with rotational coronary atherectomy]

We tried to determine whether women with a urinary tract infection (UTI) were more likely to have had a recent pelvic examination than were women seen for other reasons. We compared 56 women who were diagnosed as having a UTI with 49 controls who had an unrelated complaint (sinusitis). Significantly more women with UTIs had received a pelvic examination within the preceding 2 months (43% vs 16%, P = .01). We conclude that having a pelvic examination is associated with an increased risk of a UTI developing within the following 2 months. This may be due to physical factors related to the examination or to risk factors related to the patients' reasons for obtaining a pelvic examination. Further study is needed to determine if the pelvic examination is an independent risk factor. If so, established preventive measures could reduce this risk.     

Introduction to the special issue on the self and social identity.

This article describes the special issue of the Journal of Personality and Social Psychology (JPSP), which is the result of a joint undertaking by the three sections of JPSP. This makes it different from previous special sections or issues of the journal in that rather than relying on the generous services of a guest editor, the same editorial team that handles the regular journal issues has originated this special issue, as well, thus conveying a sense of "business as usual." Our major reason for the present initiative was to highlight the essential unity of personality and social psychology as a field of science. The topic choice for the present special issue was dictated by its relevance and interest to the field of personality and social psychology as a whole, across its various partitions and subdivisions. The articles in the special issue amply reflect the naturalness with which the self and social identity theme transcends the boundaries of JPSP sections. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Drag reduction characteristics of graft copolymers prepared by the gamma irradiation of poly(oxyethylene) in the presence of acrylic acid

Graft copolymers were prepared by irradiation of poly(oxyethylene), PEO, aqueous solutions in presence of acrylic acid. Chain transfer to PEO controls the graft length, the measured chain transfer constant of the acrylic acid radicals to PEO being 4.11 × 10^?4 at 25°C. The drag reduction characteristics of the graft copolymers were measured in the Reynolds number range 10⁴–10⁵ in a smooth-walled tube, 0.635 cm inside diameter. The drag reduction falls to near zero as the solution pH is lowered to 3, evidence of the formation of a PEO-poly(acrylic acid) coacervate.     

Learning and classification of monotonic ordinal concepts

Ordinal reasoning plays a major role in human cognition. This paper identifies an important class of classification problems of patterns taken from ordinal domains and presents efficient, incremental algorithms for learning the classification rules from examples. We show that by adopting a monotonicity assumption of the output with respect to the input, inconsistencies among examples can be easily detected and the number of possible classification rules substantially reduced. By adopting a conservative classification criterion, the required number of rules further decreases. The monotonicity and conservatism of the classification also enable the resolution of conflicts among inconsistent examples and the graceful handling of don't knows and don't cares during the learning and classification phases. Two typical examples in which the suggested classification model works well are given. The first example is taken from the financial domain and the second from machining.