激光脉冲编码抗有源干扰效果研究

激光脉冲编码是激光制导武器的抗干扰措施之一。角度欺骗式干扰和高重频干扰是目前半主动激光制导武器的主要有源干扰来源。为研究不同激光脉冲编码方式对激光半主动制导武器抗这两种干扰性能的影响,本文针对敌方激光告警机的识别算法与我方导引头的解码过程,提出自相关函数与归一化互相关函数评价方法,并对目前主要编码方式进行仿真,仿真结果表明:激光脉冲编码的抗角度欺骗式干扰能力受编码序列周期性与脉冲间隔随机性的影响；抗高重频激光干扰能力受编码序列脉冲间隔随机性的影响；LFSR状态码的抗角度欺骗式干扰与抗高重频干扰效果均优于其他编码方式。     

Synthesis of amino-cosubstituted polyorganophosphazenes and fabrication of their nanoparticles for anticancer drug delivery

The development of safe drug carriers is cardinal in cancer therapy, which can target the cancer cells and release the loaded drug on-demand without damaging the healthy cells of the body. In our work, we synthesized three different biodegradable polymers, poly[(ethyl aminobezoate) (ethyl glycinato) phosphazenes] (PABGPs), in different mole ratio of side groups. The successful synthesis of these PABGPs was confirmed by ¹H NMR, ³¹P NMR, FT-IR, and gel permeation chromatography. These PABGPs were fabricated into drug (camptothecin, CPT, a hydrophobic anticancer drug) loaded nanoparticles. These drug-loaded nanoparticles showed good drug release behaviors under normal physiological conditions (pH 7.4 and temperature 37°C). These PABGPs-based nanoparticles may find their application as effective drug carriers for cancer therapy.     

基于实际井眼轨迹的抽油杆柱API设计方法

目前的抽油杆柱设计方法大都基于设计井眼轨迹或经验公式，因此设计的抽油杆柱与井眼的匹配性并没有达到最优，结果可能影响了抽油杆柱的受力特性和寿命。概述了目前现有的抽油杆柱设计方法，提出了基于实际井眼轨迹的抽油杆柱API设计方法，即考虑到在三维空间中井下粘滞阻力及动载的影响，利用微单元分析方法计算出轴向载荷与轴向应力，然后在此基础上进行杆柱组合设计，并给出了设计流程。以江苏油田永21-3井为例，对几种设计方法的设计结果进行了对比分析，结果表明，江苏油田目前采用的抽油杆柱设计方法包含了人为经验因素，并不是最优的杆柱设计结果，有待进一步改进。     

Physico-chemical characterization of hybrid polymers obtained by 2-hydroxyethyl(methacrylate) and alkoxides of zirconium

Hybrid monolithic materials were prepared through polymerisation of 2-hydroxyethyl methacrylate (HEMA) mixed with zirconium alkoxides (Zr(OBuⁿ)₄, Zr(OPrⁿ)₄ and Zr(OEt)₄), modified by acetylacetonate groups. The molar ratio HEMA/Zr varied between 1 and 4. Thermo-Gravimetry coupled with Mass Spectroscopy (TG-MS) analyses, ¹³C MAS NMR and Dynamical Mechanical Thermal Analysys (DMTA) indicated the polymeric chains were interconnected by the inorganic component.The presence of zirconium alkoxides modified substantially the poly-HEMA properties. Glass transition temperature of hybrid materials derived from butoxy and propoxy was found in the range 50-80 °C, depending on the composition. The typical swelling of p-HEMA in the water, was suppressed by the presence of zirconium compounds. After immersion in distilled water, hybrid polymers showed an initial slight weight increase, followed by a small mass loss, which increases proportionally to the length of alkoxyl group (ethoxide(propoxide(butoxide) and reaches a constant value after about 40 days. The hybrids remained always rigid and transparent. Flexural modulus and strength of about 400-900 and 4-8 MPa were measured.     

小型月球探测器高精度姿态指向控制

针对小型月球探测器三轴姿态高指向精度和高稳定度的要求 ,采用欧拉动力学和四元数方法描述 ,建立了小型月球探测器环月阶段动力学模型 ,分析了由 3个轻型反作用轮正交安装组成的姿态稳定控制系统 ,给出了一种拟PD姿态指向控制规律。对所设计的指向控制律进行了数学仿真 ,结果表明可达到 0 .0 1°/s的稳定度和 0 .3°的指向精度 ,验证了该控制规律的可行性。     

Mechanical Model on Brittle Crack Initiation and Propagation

A mechanical model is presented in this paper to describe the initiating and propagating of brittle cracks. Two criteria have been deduced from the model to determine the effects of such factors as local stress state, surface and grain boundary energies as well as local grain boundary orientation on the initiating and propagating of both intergranular and transgranular brittle cracks. By which the role of adding B in Ni3Al base alloys to improve their ductility,temper and hydrogen embrittlements in steels and other alloys as well as the random feature of brittle crack initiation could be explained     

Switched-current memory circuits for high-precision applications

We discuss circuit parameters that limit the precision of basic dynamic current-memory cells. In addition to analyzing current-copying errors caused by the finite output conductances of the current sources and by the clock-feedthrough (CFT) of the feedback switches, we analyze the noise performance of the basic memory cell. To reduce CFT and noise, we propose a novel circuit based on Miller capacitance-enhancement. Measurement results of memory cells integrated in a 1-μm CMOS process confirm the theoretical findings; with our CFT and noise reduction technique based on Miller enhanced capacitance and dummy switches, we achieve a dynamic range of 11 b at clock frequencies greater than 100 kHz     

Identification of in vitro phosphorylation sites in the growth cone protein SCG10. Effect Of phosphorylation site mutants on microtubule-destabilizing activity

SCG10 is a neuron-specific, membrane-associated protein that is highly concentrated in growth cones of developing neurons. Previous studies have suggested that it is a regulator of microtubule dynamics and that it may influence microtubule polymerization in growth cones. Here, we demonstrate that in vivo, SCG10 exists in both phosphorylated and unphosphorylated forms. By two-dimensional gel electrophoresis, two phosphoisoforms were detected in neonatal rat brain. Using in vitro phosphorylated recombinant protein, four phosphorylation sites were identified in the SCG10 sequence. Ser-50 and Ser-97 were the target sites for protein kinase A, Ser-62 and Ser-73 for mitogen-activated protein kinase and Ser-73 for cyclin-dependent kinase. We also show that overexpression of SCG10 induces a disruption of the microtubule network in COS-7 cells. By expressing different phosphorylation site mutants, we have dissected the roles of the individual phosphorylation sites in regulating its microtubule-destabilizing activity. We show that nonphosphorylatable mutants have increased activity, whereas mutants in which phosphorylation is mimicked by serine-to-aspartate substitutions have decreased activity. These data suggest that the microtubule-destabilizing activity of SCG10 is regulated by phosphorylation, and that SCG10 may link signal transduction of growth or guidance cues involving serine/threonine protein kinases to alterations of microtubule dynamics in the growth cone.     

Topical laryngo-tracheal anesthesia and intraocular pressure in anesthesia for ophthalmic surgery

OBJECTIVE: The reflex response to orotracheal intubation provokes an increase of arterial pressure accompanied by an increase of chorioides volume and a consequent ocular hypertone. There are several methods to reduce the reflex response due to intubation. One of the most effective is topical anaesthesia of larynx and trachea. Experiments were directed to evaluate the efficacy of topical anaesthesia to reduce the intraocular hypertone due to orotracheal intubation. DESIGN: A prospective randomized mask study was conduct on patients undergoing ophthalmologic (anterior segment) surgery at the Eye Clinic of Florence University. METHODS: Intraocular pressure was measured by a Goldman tonometer at four times: T0 = basal, T1 = 2' minutes after induction of general anaesthesia, T2 = 2' minutes after laryngoscopy, T3 = 2' minutes after orotracheal intubation. At the same moments, systolic blood pressure, heart rate, rate pressure pro duct were measured. Patients were randomly divided in two groups: Group L (n = 10) in which was evaluated the efficacy of laryngotracheal topical spray of lidocaine 4% (2 ml) and Group F (n = 10) in which saline was used instead of anesthetic. The filling of the LTA kit (Abbott) was made by a person not involved in the experiments. DATA ANALYSIS: Student's t test for unpaired data. RESULTS: Topical anaesthesia reduces the increase of intraocular pressure, hypertension and rate pressure product due to intubation. The intraocular pressure reduces to 13% less than basal value in Group L and increase to 50% more than basal value in Group F. CONCLUSION: The topical anaesthesia of larynx and trachea is effective to reduce the intraocular hypertension due to the reflex response evoked by orotracheal intubation.