Sodium silicate as a coke inhibitor during naphtha pyrolysis

Rates of coke formation during steam pyrolysis of naphtha have been investigated in a jet-stirred reactor both for sodium silicate coated and uncoated Inconel 600 surfaces in the temperature range of 1078–1108 K. Coke formation rates were significantly reduced on sodium silicate coated plates due to the passivation of the metal surface. However, the coking rates gradually increased with successive decokings of the coated surface.     

Experience with Applying Formal Methods to Protocol Specification and System Architecture

In the last three years or so we at Enterprise Platforms Group at Intel Corporation have been applying formal methods to various problems that arose during the process of defining platform architectures for Intel's processor families. In this paper we give an overview of some of the problems we have worked on, the results we have obtained, and the lessons we have learned. The last topic is addressed mainly from the perspective of platform architects.     

Superplasticity in a high strength powder aluminum

The superplastic properties of a rapidly solidified, high strength P/M Al alloy and the same alloy reinforced with SiC particulates (SiC _p ) have been studied. To prepare superplastic test materials, a matrix alloy powder of composition 7.2Zn-2.4Mg-2Cu-0.2Zr-0.12Cr-0.2Co (Kaiser PM-64) and the powder mixed with 10 to 20 vol pct SiC _p (~5 μm diameter) were thermomechanically processed to very fine equiaxed grain structures of ~6 μm and ~8 μm, respectively. Superplasticity in these materials was evaluated by characterizing (1) high temperature stability, (2) dynamic grain growth, (3) strain rate sensitivity, (4) flow stress behavior, (5) cavitation and cavitation control, and (6) total superplastic strain. It was observed that the PM-64 alloy could achieve a total elongation of over 800 pct, while the SiC_p reinforced alloy could attain an elongation greater than 500 pct before failure. Also, it was shown that with the use of hydrostatic pressure during superplastic flow, cavitation could be controlled. Observations were made of the effect SiC _p reinforcement particles had on the superplastic flow stress behavior. Interpretations are proposed to explain the role of particulates during superplastic straining.     

On the improvement of detection characteristics of trans-stilbene crystals by improving crystal perfection

Organic molecular scintillating crystals are noted for their good timing and particle discrimination process. Trans-stilbene is one such candidate noted for its good particle detection characteristics for the past five decades. Progressive strengthening of detection characteristics of trans-stilbene has been attempted by improving crystal perfection. A series of timing resolution studies have been carried out for the Bridgman grown trans-stilbene crystals under different experimental conditions. The results were compared with the previously reported values. Pulse shape discrimination process has been carried out for ²⁴¹Am and ²⁵²Cf sources and good discrimination has been obtained for gamma-alpha and gamma-neutron sources from the grown organic phosphor crystal. Electronic Publication     

Development of nano indium tin oxide (ITO) grains by alkaline hydrolysis of In(III) and Sn(IV) salts

Indium tin oxide (ITO) nano powders of different compositions (In: Sn = 90: 10, 70: 30 and 50: 50) were prepared by heat treatment (300-450°C) of mixed hydroxides of In(III) and Sn(IV). The hydroxides were obtained by the reaction of aq. NH₃ with mixed aq. solutions of In(NO₃)₃ and SnCl₄. FTIR and TG/DTA studies revealed that powders existed as In(OH)₃H₂O—SnO₃H₂H₂O in the solid state and then they transformed to In₂O₃—SnO₂ via some metastable intermediates after 300°C. Cubic phase of In₂O₃ was identified by XRD for the oxides up to 30% of Sn. Particle size measurements of the solid dispersed in acetone and SEM study for microstructure showed that the oxides were in the nano range (55-75 nm) whereas the size range determined from Debye-Scherrer equation were 11–24 nm.     

Stability and throughput analysis of unslotted CDMA‐ALOHA with finite number of users and code sharing

We consider a system comprising a finite number of nodes, with infinite packet buffers, that use unslotted ALOHA with Code Division Multiple Access (CDMA) to share a channel for transmitting packetised data. We propose a simple model for packet transmission and retransmission at each node, and show that saturation throughput in this model yields a sufficient condition for the stability of the packet buffers; we interpret this as the capacity of the access method. We calculate and compare the capacities of CDMA‐ALOHA (with and without code sharing) and TDMA‐ALOHA; we also consider carrier sensing and collision detection versions of these protocols. In each case, saturation throughput can be obtained via analysis of a continuous time Markov chain. Our results show how saturation throughput degrades with code‐sharing. Finally, we also present some simulation results for mean packet delay. Our work is motivated by optical CDMA in which “chips” can be optically generated, and hence the achievable chip rate can exceed the achievable TDMA bit rate which is limited by electronics. Code sharing may be useful in the optical CDMA context as it reduces the number of optical correlators at the receivers. Our throughput results help to quantify by how much the CDMA chip rate should exceed the TDMA bit rate so that CDMA‐ALOHA yields better capacity than TDMA‐ALOHA. This revised version was published online in June 2006 with corrections to the Cover Date.