Characterization of extensional rheological filament stretching with a dual‐mode Giesekus model

A new, simple, formulation that describes capillary thinning as predicted by a two‐mode Giesekus model is derived, and its application in analyzing data from extensional rheometry (capillary thinning) experiments is discussed. An algorithm is presented that can be used to fit the expressions obtained from the Giesekus model to extensional rheometry data. Examples of data fitting are given for an idealized data set, for measurements obtained for aqueous solutions of 6 wt % 900,000 molecular weight polyethylene oxide, and for biological fluids obtained from pitchers of Nepenthes Rafflesiana. Good fits to the data were obtained, with coefficients of determination in excess of 0.98. For each data set, it was possible to calculate values of extensional viscosity and relaxation time for each of the two modes, allowing quantitative comparison of different fluids or of the same fluid as it ages. © 2016 American Institute of Chemical Engineers AIChE J, 62: 2188–2199, 2016     

Influence of FeO/SiO2 and CaO/SiO2 Ratios in Iron‐Saturated ZnO‐Rich Fayalite Slags on the Corrosion of MgO

The corrosion behavior of MgO in iron‐saturated ZnO‐rich fayalite (ZFS) slags having various FeO/SiO₂ ratio and CaO/SiO₂ ratio was investigated using MgO crucible tests for 12 h at 1200°C. The FeO/SiO₂ and CaO/SiO₂ ratios in the ZFS slags were varied from 1.0 to 2.2, and from 0.04 to 0.32, respectively. In all of the tests, it was observed that MgO dissolves into ZFS slags and that (Zn,Fe,Mg)₂SiO₄ olivine and (Zn,Fe,Mg)O solid solution are formed at the crucible/slag interface. The MgO dissolution decreased with the FeO/SiO₂ ratio up to a value of 1.7 and then slightly increased, whereas it continuously increased with the CaO/SiO₂ ratio. There is no obvious relationship between the amount of olivine and the FeO/SiO₂ ratio or CaO/SiO₂ ratio. In comparison, the formation of (Zn,Fe,Mg)O solid solution is enhanced by increasing the FeO/SiO₂ ratio or CaO/SiO₂ ratio in ZFS slags. The results suggest that MgO corrosion is the lowest for FeO/SiO₂ and CaO/SiO₂ ratios around 1.7 and 0, respectively.     

A systematic comparison of PCA‐based Statistical Process Monitoring methods for high‐dimensional,time‐dependent Processes

High‐dimensional and time‐dependent data pose significant challenges to Statistical Process Monitoring. Most of the high‐dimensional methodologies to cope with these challenges rely on some form of Principal Component Analysis (PCA) model, usually classified as nonadaptive and adaptive. Nonadaptive methods include the static PCA approach and Dynamic Principal Component Analysis (DPCA) for data with autocorrelation. Methods, such as DPCA with Decorrelated Residuals, extend DPCA to further reduce the effects of autocorrelation and cross‐correlation on the monitoring statistics. Recursive Principal Component Analysis and Moving Window Principal Component Analysis, developed for nonstationary data, are adaptive. These fundamental methods will be systematically compared on high‐dimensional, time‐dependent processes (including the Tennessee Eastman benchmark process) to provide practitioners with guidelines for appropriate monitoring strategies and a sense of how they can be expected to perform. The selection of parameter values for the different methods is also discussed. Finally, the relevant challenges of modeling time‐dependent data are discussed, and areas of possible further research are highlighted. © 2016 American Institute of Chemical Engineers AIChE J, 62: 1478–1493, 2016     

Multi-level Modeling of Silica–Template Interactions During Initial Stages of Zeolite Synthesis

Zeolite synthesis is driven by structure-directing agents, such as tetrapropyl ammonium ions (TPA⁺) for Silicalite-1 and ZSM-5. However, the guiding role of these organic templates in the complex assembly to highly ordered frameworks remains unclear, limiting the prospects for advanced material synthesis. In this work, both static ab initio and dynamic classical modeling techniques are employed to provide insight into the interactions between TPA⁺ and Silicalite-1 precursors. We find that as soon as the typical straight 10-ring channel of Silicalite-1 or ZSM-5 is formed from smaller oligomers, the TPA⁺ template is partially squeezed out of the resulting cavity. Partial retention of the template in the cavity is, however, indispensable to prevent collapse of the channel and subsequent hydrolysis.

Optimization of Mineralogy and Microstructure of Solidified Basic Oxygen Furnace Slag Through SiO2 Addition or Atmosphere Control During Hot-Stage Slag Treatment

Metallurgical and Materials Transactions B - Valorization of basic oxygen furnace (BOF) slag is of significant importance for mitigation of the steel production’s environmental impact. The...     

Adventitial Tertiary Lymphoid Organs as Potential Source of MicroRNA Biomarkers for Abdominal Aortic Aneurysm

Abdominal aortic aneurysm (AAA) is an inflammatory disease associated with marked changes in the cellular composition of the aortic wall. This study aims to identify microRNA (miRNA) expression in aneurysmal inflammatory cells isolated by laser microdissection from human tissue samples. The distribution of inflammatory cells (neutrophils, B and T lymphocytes, mast cells) was evaluated in human AAA biopsies. We observed in half of the samples that adventitial tertiary lymphoid organs (ATLOs) with a thickness from 0.5 to 2 mm were located exclusively in the adventitia. Out of the 850 miRNA that were screened by microarray in isolated ATLOs (n = 2), 164 miRNAs were detected in ATLOs. The three miRNAs (miR-15a-3p, miR-30a-5p and miR-489-3p) with the highest expression levels were chosen and their expression quantified by RT-PCR in isolated ATLOs (n = 4), M1 (n = 2) and M2 macrophages (n = 2) and entire aneurysmal biopsies (n = 3). Except for the miR-30a-5p, a similar modulation was found in ATLOs and the two subtypes of macrophages. The modulated miRNAs were then evaluated in the plasma of AAA patients for their potential as AAA biomarkers. Our data emphasize the potential of miR-15a-3p and miR-30a-5p as biomarkers of AAA but also as triggers of ATLO evolution. Further investigations will be required to evaluate their targets in order to better understand AAA pathophysiology.     

Life cycle assessment of Jatropha biodiesel as transportation fuel in rural India

Since 2003 India has been actively promoting the cultivation of Jatropha on unproductive and degraded lands (wastelands) for the production of biodiesel suitable as transportation fuel. In this paper the life cycle energy balance, global warming potential, acidification potential, eutrophication potential and land use impact on ecosystem quality is evaluated for a small scale, low-input Jatropha biodiesel system established on wasteland in rural India. In addition to the life cycle assessment of the case at hand, the environmental performance of the same system expanded with a biogas installation digesting seed cake was quantified. The environmental impacts were compared to the life cycle impacts of a fossil fuel reference system delivering the same amount of products and functions as the Jatropha biodiesel system under research. The results show that the production and use of Jatropha biodiesel triggers an 82% decrease in non-renewable energy requirement (Net Energy Ratio, NER = 1.85) and a 55% reduction in global warming potential (GWP) compared to the reference fossil-fuel based system. However, there is an increase in acidification (49%) and eutrophication (430%) from the Jatropha system relative to the reference case. Although adding biogas production to the system boosts the energy efficiency of the system (NER = 3.40), the GWP reduction would not increase (51%) due to additional CH₄ emissions. For the land use impact, Jatropha improved the structural ecosystem quality when planted on wasteland, but reduced the functional ecosystem quality. Fertilizer application (mainly N) is an important contributor to most negative impact categories. Optimizing fertilization, agronomic practices and genetics are the major system improvement options.     

Experimental and numerical investigation of a free rising droplet

A toluene droplet rising in a continuous aqueous phase is studied both experimentally and numerically. The experiments have been performed in a small scale, high-speed measuring unit with a high magnification device to image the process in all details. Numerical simulations are performed with the aid of the level set method implemented in the commercial CFD tool COMSOL Multiphysics 3.3a by COMSOL AB. A new technique for quantitative comparison of experimental and numerical results with respect to the droplet shape is presented. Both terminal velocity and droplet shape in experiments and simulations are found to be in excellent agreement. Based on the experimental and numerical data obtained, an improvement of an existing terminal velocity correlation is suggested. The adjusted correlation can be used for the design and optimisation of liquid-liquid extraction units.