Intra- and interspecific mineral composition variability of commercial instant coffees and coffee substitutes: Contribution to mineral intake

The present paper reports the amount and estimated daily mineral intake of nine elements (Ca, Mg, K, Na, P, Fe, Mn, Cr and Ni) in commercial instant coffees and coffee substitutes (n = 49). Elements were quantified by high-resolution continuum source flame (HR-CS-FAAS) and graphite furnace (HR-CS-GFAAS) atomic absorption spectrometry, while phosphorous was evaluated by a standard vanadomolybdophosphoric acid colorimetric method.Instant coffees and coffee substitutes are rich in K, Mg and P (>100 mg/100 g dw), contain Na, Ca and Fe in moderate amounts (>1 mg/100 g), and trace levels of Cr and Ni. Among the samples analysed, plain instant coffees are richer in minerals (p < 0.001), except for Na and Cr. Blends of coffee substitutes (barley, malt, chicory and rye) with coffee (20–66%) present intermediate amounts, while lower quantities are found in substitutes without coffee, particularly in barley.From a nutritional point of view the results indicate that the mean ingestion of two instant beverages per day (total of 4 g instant powder), either with or without coffee, cannot be regarded as important sources of minerals to the human diet, although providing a supplementation of some minerals, particularly Mg and Mn in instant coffees. Additionally, and for authentication purposes, the correlations observed between some elements and the coffee percentage in the blends, with particular significance for Mg amounts, provides a potential tool for the estimation of coffee in substitute blends.     

Multiple metastatic infections in a hemodialysis patient with untunneled internal jugular catheter

We present an end‐stage renal disease patient on dialysis with fever. The primary source was right internal jugular vein catheter which had metastatic infections in the body probably via an arteriovenous communication in a cavity in left lung. Patient had right psoas muscle abscess and a left kidney abscess. An ¹⁸F‐fluorodeoxyglucose‐positron emission spectroscopy scan was done to find out left kidney abscess. A search of literature did not reveal many patients of psoas abscess secondary to infection of hemodialysis access.     

Multinational Enterprises and the Geographical Clustering of Innovation

Research on the geographic clustering of economic activity dates back to the early twentieth century. It is recognized that in spite of advances in transportation and communications, clustering remains most critical, and is consequently prevalent, in knowledge-intensive fields. Multinational enterprises (MNEs) that increasingly base their value creation and competitive advantage on knowledge-intensive activities are key participants in clusters, affecting both the nature and intertemporal evolution of local innovative activities. However, the role of MNEs in clusters remains under-researched. This paper traces the origins of research on geographic clusters, identifies the seminal contributions focusing on the role of MNEs, discusses potential problems inherent to this area of inquiry and develops an organizing framework for new research.     

Performance modeling of DTN routing with heterogeneous and selfish nodes

The performance modeling study of Delay-Tolerant Network routing, in general, assumes the nodes to be homogeneous (in terms of features such as the coverage range) and uncompromised (in terms of forwarding messages). However, in realistic settings this may not be the case. The routing performance modeling of such realistic scenarios that involve multifariously-featured and egotistic nodes would be interesting and insightful. To this end, in this paper, we analytically model the routing behavior of such nodes using Ordinary Differential Equations for two different routing protocols namely, Epidemic Routing and Two-Hop Routing. Furthermore, we also study the degradation in the routing performance caused by an increase in the fraction of selfish nodes present in the heterogeneous node population. The proposed analytical model is validated via extensive simulations.     

An energy efficient middleware for an ad-hoc AAL wireless sensor network

DIA (Dispositivo Inteligente de Alarma, in Spanish) is an AAL (Ambient Assisted Living) system that allows to infer a potential dangerous action of an elderly person living alone at home. This inference is obtained by a specific sensorisation with sensor nodes (portables and fixes) and a reasoning layer embedded in a PC that learns of the users behaviour patterns and advices when actual one differs significantly of the normal patterns. In AAL systems, energy is a limited resource therefore sensor devices need to be properly managed to conserve energy. In this paper, we introduce the design and implementation of innovative and specific mechanisms at the sensory layer middleware which is capable of, first to discriminate spurious motion detections assuming that these signals do not resemble the patterns of real motion detections and, second to reduce the dynamics of messages by a sensor signal processing in order to compress the whole information in one single event. The middleware achieves power saving by modifying the raw information from sensors and adapting it to the predefined semantic of the reasoning layer. It manages the important task of data processing from sensors (raw information), and transfers the pre-processed information into the top layer of reasoning in a more energy efficient way. We also address the trade-off between reducing power consumption and reducing delay for incoming data. We present results from experiments using our implementation of these mechanisms at the middleware that comprises from node firmware to the PC driver. The number of messages of the proposed method with respect to the raw data is reduced by approximately 98.5%. The resources used in the PIR signal processing is reduced by approximately 85%. The resulting delay introduced is small (10–19 s) but system dynamics is slow enough to avoid contextualisation errors or reduction of system performance. We consider these results as very satisfactory.     

Predicting cetane number,kinematic viscosity,density and higher heating value of biodiesel from its fatty acid methyl ester composition

Biodiesel is a renewable bio-fuel derived from natural fats or vegetable oils, and it is considered as a promising alternative to substitute diesel fuels. Cetane number, viscosity, density, and higher heating value are important properties to affect the utilization of biodiesel fuels, because they are involved in the definition of fuel quality and are required as input data for predictive engine combustion models. This work presents the characterization of two biodiesel samples made from beef tallow and soybean oil through their fatty acid methyl esters (FAMEs) profile. Empirical equations were developed to estimate four physical properties of methyl esters; and an average absolute deviation (AAD) of 5.95%, 2.57%, 0.11% and 0.21% for the cetane number, kinematic viscosity, density, and higher heating value were founded. Cetane number, viscosity, and higher heating value increases because of the increase of molecular weight and these physical properties decrease as the number of double bonds increases. Unlike that of above properties, density decreases as molecular weight increases and density increases as the degree of unsaturation increases. Two general mixing rules and five biodiesel samples were used to study the influence of FAMEs over the physical properties of biodiesel. The prediction of the cetane number, kinematic viscosity, density and higher heating value of biodiesel is very close to the experimental values.     

Determination of deuterium site occupancy in ZrCoD3 and its role in improved durability of Zr–Co–Ni deuterides against disproportionation

In the present study, we have for the first time reported the occupancy of deuterium in a new interstitial site of ZrCoD₃ which explain the hydrogen induced disproportionation behavior of ZrCo alloy. We have also reported the effect of Ni substitution on interstitial site occupancy of deuterium in ZrCo_1−xNi_xD₃, which in turn explains the improved durability of these Ni substituted deuterides against disproportionation. The crystal structure of the ZrCo_1−xNi_x (x = 0.0, 0.1, 0.2, 0.3) deuterides was investigated by X-ray powder diffraction and neutron diffraction methods. The XRD data reveals a single phase formation for all deuterides with varying Ni content (x). The neutron diffraction study shows that deuterium occupies a new site 8e in addition to 4c₂ and 8f₁. Additionally, the Zr–D distance in 8e site is shorter than that in ZrD₂. Therefore, increase in 8e site occupancy will in turn decreases the durability against disproportionation and vice-versa. Furthermore, the neutron diffraction reveals that occupancy of new 8e site decreases and its Zr–D distance increases with increase in Ni content, which explicate the higher durability against disproportionation for Ni rich compound.     

Conversion efficiency of glucose/xylose mixtures for ethanol production using Saccharomyces cerevisiae ITV01 and Pichia stipitis NRRL Y‐7124

BACKGROUND: Efficient conversion of glucose/xylose mixtures from lignocellulose is necessary for commercially viable ethanol production. Oxygen and carbon sources are of paramount importance for ethanol yield. The aim of this work was to evaluate different glucose/xylose mixtures for ethanol production using S. cerevisiae ITV‐01 (wild type yeast) and P. stipitis NRRL Y‐7124 and the effect of supplying oxygen in separate and co‐culture processes. RESULTS: The complete conversion of a glucose/xylose mixture (75/30 g L^?1) was obtained using P. stipitis NRRL Y‐7124 under aerobic conditions (0.6 vvm), the highest yield production being Y_p/s = 0.46 g g^?1, volumetric ethanol productivity Q_pmax = 0.24 g L^?1 h^?1 and maximum ethanol concentration P_max = 34.5 g L^?1. In the co‐culture process and under aerobic conditions, incomplete conversion of glucose/xylose mixture was observed (20.4% residual xylose), with a maximum ethanol production of 30.3 g L^?1, ethanol yield of 0.4 g g^?1 and Q_pmax = 1.26 g L^?1 h^?1. CONCLUSIONS: The oxygen present in the glucose/xylose mixture promotes complete sugar consumption by P. stipitis NRRL Y‐7124 resulting in ethanol production. However, in co‐culture with S. cerevisiae ITV‐01 under aerobic conditions, incomplete fermentation occurs that could be caused by oxygen limitation and ethanol inhibition by P. stipitis NRRL Y‐7124; nevertheless the volumetric ethanol productivity increases fivefold compared with separate culture. Copyright © 2011 Society of Chemical Industry