Potent,Metabolically Stable 2‐Alkyl‐8‐(2H‐1,2,3‐triazol‐2‐yl)‐9H‐adenines as Adenosine A2A Receptor Ligands

Inhibition of adenosine A_2A receptors has been shown to elicit a therapeutic response in preclinical animal models of Parkinson’s disease (PD). We previously identified the triazolo‐9H‐purine, ST1535, as a potent A_2AR antagonist. Studies revealed that ST1535 is extensively hydroxylated at the ω‐1 position of the butyl side chain. Here, we describe the synthesis and evaluation of derivatives in which the ω‐1 position has been substituted (F, Me, OH) in order to block metabolism. The stability of the compounds was evaluated in human liver microsomes (HLM), and the affinity for A_2AR was determined. Two compounds, (2‐(3,3‐dimethylbutyl)‐9‐methyl‐8‐(2H‐1,2,3‐triazol‐2‐yl)‐9H‐purin‐6‐amine ( 3 b ) and 4‐(6‐amino‐9‐methyl‐8‐(2H‐1,2,3‐triazol‐2‐yl)‐9H‐purin‐2‐yl)‐2‐methylbutan‐2‐ol ( 3 c ), exhibited good affinity against A_2AR (K_i=0.4 nM and 2 nM , respectively) and high in vitro metabolic stability (89.5 % and 95.3 % recovery, respectively, after incubation with HLM for two hours).     

Microwave-assisted synthesis of isosorbide-derived diols for the preparation of thermally stable thermoplastic polyurethane

In order to prepare thermally stable isosorbide-derived thermoplastic polyurethane, the synthesis of two new chiral exo–exo configured diols, prepared from isosorbide, and two types of diphenols (bisphenol A and thiodiphenol) was described. The synthesis conditions were optimized under conventional heating and microwave irradiations. To prove their suitability in polymerization, these monomers were successfully polymerized using 4,4′-diphenylmethane diisocyanate (MDI) and hexamethylene diisocyanate (HDI). Both monomers and polymers have been studied by NMR, FT-IR, TGA, DSC; intrinsic viscosity of polymers has also been determined. The results showed the effectiveness of the synthetic strategy proposed; moreover, a dramatic reduction of the reaction time and an important improvement of the monomers yield using microwave irradiation have been demonstrated. The monomers, as well as the polymers, showed excellent thermal stability both in air and nitrogen. It was also shown that the introduction of sulphur in the polyurethane backbone was effective in delaying the onset of degradation as well as the degradation rate.     

An experimental comparison of a graphite electrode and a gas diffusion electrode for the cathodic production of hydrogen peroxide

This work studies the production of hydrogen peroxide through the cathodic reduction of oxygen in acidic medium, by comparing the results obtained using a commercial graphite and a gas diffusion electrode. A low pH was required to allow the application of hydrogen peroxide generation to an electro-Fenton process. The influence of applied potential and the gas flow composition were investigated. The gas diffusion electrode demonstrates a higher selectivity for hydrogen peroxide production, without significantly compromising the iron regeneration, thus making its successful application to a cathodic Fenton-like treatment, possible. Unlike the graphite cathode, the gas diffusion cathode also proved to be effective in the air flow.     

Rheological Properties of Different Film Blowing Polyethylene Samples Under Shear and Elongational Flow

Summary: The rheological behavior of polyethylenes is mainly dominated by the molecular weight, the molecular weight distribution and by the type, the amount and the distribution of the chain branches. In this work a linear metallocene catalyzed polyethylene (m‐PE), a branched metallocene catalyzed polyethylene (m‐bPE), a conventional linear low density polyethylene (LLDPE) and a low density polyethylene (LDPE) have been investigated in order to compare their rheological behavior in shear and in elongational flow. The four samples have similar melt flow index and in particular a value typical of film blowing grade. The melt viscosity has been studied both in shear and in isothermal and non‐isothermal elongational flow. The most important features of the results are that in shear flow the m‐PE sample shows less pronounced non Newtonian behavior while in the elongational flow the behavior of m‐PE is very similar to that of the linear low density polyethylene: the narrower molecular weight distribution and the better homogeneity of the branching distribution are reasonably responsible for this behavior. Of course the most pronounced non‐linear behavior is shown, as expected, by the LDPE sample and by the branched metallocene sample. This similar behavior has to be attributed to the presence of branching. Similar comments hold in non‐isothermal elongational flow; the LDPE sample shows the highest values of the melt strength and the other two samples show very similar values. As for the breaking stretching ratio the opposite is true for LDPE while m‐PE and LLDPE show higher values. The transient isothermal elongational viscosity curves show that the branched samples show a strain hardening effect, while LLDPE and m‐PE samples present a linear behavior.

Dimensionless flow curves of different polyethylene samples.     

Chromium (VI) removal by methylated biomass of Spirulina platensis: The effect of methylation process

Biosorption of heavy metals is an interesting approach to treat industrial wastewaters by an environmentally friendly system. Spirulina platensis biomass, an effective biosorbent for cations, cannot be used to adsorb chromate due to its negatively charged surface close to neutral conditions; therefore, methylation of biomass was performed to increase its adsorption capacity under these conditions. Batch adsorption tests carried out varying both Cr(VI) and methylated biomass concentrations showed that 2–4 g l^?1 of biosorbent were able to remove Cr(VI) with efficiency ≥80%, while higher Cr(VI) levels (43–50 mg l^?1) showed low removal efficiency. The model of Langmuir was shown to describe the adsorption phenomenon better than the Freundlich one. The values of the overall adsorption capacity of methylated biomass suggested that increased biosorbent availability does not necessarily correspond to larger amount of adsorbed metal. FT-IR spectra of dried and methylated biomass of S. platensis allowed us monitoring the efficiency of the methylation process through the analysis of CH and COO^? vibrational stretching modes, taken as diagnostic of this process.     

Feasibility study of the cut and weld operations by RH on the cooling pipes of ITER NB components

The maintenance operations of ITER NB components inside the vessel - Beam Line Components (BLC's) involve the removal of the faulty component, its transport to the hot cell as well as the reverse operations of transport of the repaired/new component and its reinstallation inside the vessel. Prior to the removal of the BLC's the cooling pipes must be detached from the component following a procedure that applies to the cutting of the pipes and subsequent welding when the component is re-installed. The purpose of this study, conducted in the framework of EFDA, is to demonstrate the feasibility of the cut and weld operations on the water pipes of the BLC's using fully remote handling techniques. Viable technologies for the cut and weld operations have been identified within the study; in particular the following aspects will be presented in the paper:

• Different strategies can be pursued in the detachment of the components depending on the number of cut and weld operations to be performed on the pipes. The selected strategy will impact on the procedure to be followed likewise on important aspects as the requirements of the flexible joints assembled on the pipes.

• The existing cutting techniques have been examined in the light of the remotely performed pipe cutting at the NB cell. Modifications of commercial tools have been proposed in order to adapt them to the BLC's pipes requirements. The debris produced during the cutting process must be controlled and collected, therefore a cleaning system has been integrated in the adapted cutting tool referred above.

• The existing welding techniques have been also examined and compared based on different criteria such as complexity, reliability, alignment tolerances, etc. TIG welding is the preferred technique as it stands out for its superior performance. The commercial tools identified need to be adapted to the NB environment.

• The alignment of the pipes is a critical issue concerning the remote welding. A proper alignment system has been proposed taking into account the pre-selected welding technique.

An X-ray absorption spectroscopy study of Mo oxidation in Pb at elevated temperatures

The corrosion of fuel cladding and structural materials by lead and lead-bismuth eutectic in the liquid state at elevated temperatures is an issue that must be considered when designing advanced nuclear systems and high-power spallation neutron targets. In this work, lead corrosion studies of molybdenum were performed to investigate the interaction layer as a function of temperature by X-ray absorption spectroscopy. In situ X-ray absorption measurements on a Mo substrate with a 3-6 μm layer of Pb deposited by thermal evaporation were performed at temperatures up to 900 °C and at a 15° angle to the incident X-rays. The changes in the local atomic structure of the corrosion layer are visible in the difference extended X-ray absorption fine structure and the linear combination fitting of the X-ray absorption near-edge structure to as-deposited molybdenum sample and molybdenum oxide (MoO₂ and MoO₃) standards. The data are consistent with the appearance of MoO₃ in an intermediate temperature range (650-800 °C) and the more stable MoO₂ phase dominating at high and low temperatures.     

Diabetes and Ischemic Stroke: An Old and New Relationship an Overview of the Close Interaction between These Diseases

Diabetes mellitus is a comprehensive expression to identify a condition of chronic hyperglycemia whose causes derive from different metabolic disorders characterized by altered insulin secretion or faulty insulin effect on its targets or often both mechanisms. Diabetes and atherosclerosis are, from the point of view of cardio- and cerebrovascular risk, two complementary diseases. Beyond shared aspects such as inflammation and oxidative stress, there are multiple molecular mechanisms by which they feed off each other: chronic hyperglycemia and advanced glycosylation end-products (AGE) promote ‘accelerated atherosclerosis’ through the induction of endothelial damage and cellular dysfunction. These diseases impact the vascular system and, therefore, the risk of developing cardio- and cerebrovascular events is now evident, but the observation of this significant correlation has its roots in past decades. Cerebrovascular complications make diabetic patients 2–6 times more susceptible to a stroke event and this risk is magnified in younger individuals and in patients with hypertension and complications in other vascular beds. In addition, when patients with diabetes and hyperglycemia experience an acute ischemic stroke, they are more likely to die or be severely disabled and less likely to benefit from the one FDA-approved therapy, intravenous tissue plasminogen activator. Experimental stroke models have revealed that chronic hyperglycemia leads to deficits in cerebrovascular structure and function that may explain some of the clinical observations. Increased edema, neovascularization, and protease expression as well as altered vascular reactivity and tone may be involved and point to potential therapeutic targets. Further study is needed to fully understand this complex disease state and the breadth of its manifestation in the cerebrovasculature.     

Ficolin-2 Plasma Level Assesses Liver Fibrosis in Non-Alcoholic Fatty Liver Disease

Fibrosis is the strongest predictor for disease-specific mortality in non-alcoholic fatty liver diseases (NAFLD), but the need for liver biopsy limits its diagnosis. We assessed the performance of plasma ficolin-2 (FCN-2) as a biomarker of fibrosis identified by an in silico discovery strategy. Two hundred and thirty-five morbidly obese (MO) subjects with biopsy-proven NAFLD stratified by fibrosis stage (F0, n = 44; F1, n = 134; F2, n = 46; F3/F4, n = 11) and 40 cirrhotic patients were enrolled. The cohort was subdivided into discovery (n = 76) and validation groups (n = 159). The plasma level of FCN-2 and other candidate markers was determined. FCN-2 was inversely correlated with the stage of liver fibrosis (ρ = −0.49, p < 0.001) independently of steatosis (p = 0.90), inflammation (p = 0.57), and ballooning (p = 0.59). In the global cohort, FCN-2 level decreased significantly in a stepwise fashion from F0/F1 (median 4753 ng/mL) to F2–F3–F4 (2760 ng/mL) and in cirrhotic subjects (1418 ng/mL). The diagnostic performance of FCN-2 in detecting F ≥ 2 was higher than other indexes (APRI, FIB-4) (AUROC 0.82, 0.68, and 0.6, respectively). The accuracy improved when combined with APRI score and HDL values (FCNscore, AUROC 0.85). Overall, the FCN-2 plasma level can accurately discriminate liver fibrosis status (minimal vs. moderate/advanced) significantly improving the fibrosis diagnostic algorithms.