Resource Reuse for D2D Communication in LTE Networks by Efficient Grouping

Wireless Personal Communications - Device to device (D2D) communication is a key technology of 5G mobile communications. It allows devices to communicate by using direct links, rather than...     

极低信噪比下对偶序列跳频信号的随机共振检测方法

针对对偶序列跳频(DSHF)在极低信噪比(SNR)下无法通信的问题,该文充分利用对偶序列跳频信号时、频域物理特征,提出一种随机共振(SR)检测方法,极大扩展该信号的应用场景。首先,通过分析对偶序列跳频的发射、接收信号及超外差解调的中频(IF)信号,构建随机共振系统,采用尺度变换调整中频信号;然后,引入判决时刻,将无定态解的非自治福克普朗克方程(FPE)转化为可解的自治方程,从而推导出含时间参量的概率密度周期定态解;其次,以最大后验概率为准则,得到检测概率、虚警概率和接收机工作特性(ROC)曲线;最后,得出以下结论：(1) 应用匹配随机共振检测对偶序列跳频信号的信噪比最低可达–18 dB;(2)对偶序列跳频与匹配随机共振结合,适用于信噪比在–18～–14 dB的信号检测;(3)应用匹配随机共振检测对偶序列跳频信号在信噪比为–14 dB时,检测性能提升了25.47%。仿真实验验证了理论的正确性。     

A 1-V 10.7-MHz fourth-order bandpass /spl Delta//spl Sigma/ modulators using two switched op amps

A 1-V 10.7-MHz fourth-order bandpass delta-sigma modulator using two switched opamps (SOPs) is presented. The 3/4 sampling frequency and the double-sampling techniques are adapted for this modulator to relax the required clocking rate. The presented modulator can not only reduce the number of SOPs, but also the number of capacitors. It has been implemented in 0.25-/spl mu/m 1P5M CMOS process with MIM capacitors. The modulator can receive 10.7-MHz IF signals by using a clock frequency of 7.13 MHz. A dynamic range of 62 dB within bandwidth of 200 kHz is achieved and the power consumption of 8.45 mW is measured at 1-V supply voltage. The image tone can be suppressed by 44 dB with respect to the carrier. The in-band third-order intermodulation (IM3) distortion is -65 dBc below the desired signal.     

More investigations of leakage and nonleakage conductor-backedcoplanar waveguide

Through rigorous full-wave analysis, the effective dielectric constant, normalized attenuation constant, characteristic impedance, and radiation pattern of two types of conductor-backed coplanar waveguides are obtained. The analytic results show that the leakage effect is not only controlled by the thickness and dielectric constant of the substrate but also by the slot width. The leakage power transforms to a radiation space wave and a surface wave, the transverse electric field diagrams in the substrate and the far-zone radiation pattern verify the leakage phenomenon. The first structure has the maximum radiation intensity in the endfire direction, while the second one which has more leaky waves radiates into the air, is better served as a radiating device. For both structures under the nonleakage condition, the characteristic impedance is sensitive to the change of the strip width but not the slot width. Using these properties, the nonleaky and leaky circuits can exist on the same circuit board by choosing appropriate circuit dimensions     

A graphic approach to performance analysis of multistage linear interference canceller in long-code CDMA systems

The signal-to-interference-plus-noise-ratio performance of the multistage linear parallel and successive interference cancellers (LPIC and LSIC) in a long-code code-division multiple-access system is analyzed using a graphical approach. The decision statistic is modeled as a Gaussian random variable, whose mean and variance can be expressed as functions of moments of R for the LPIC and L for the LSIC, respectively, where R is the correlation matrix of signature sequences and L is the strict lower triangular part of R. Since the complexity of calculating these moments increases rapidly with the growth of the stage index, a graphical representation of moments is developed to facilitate the computation. Propositions are presented to relate the moment calculation problem to several well-known problems in graph theory, i.e., the coloring, the graph decomposition, the biconnected component finding, and the Euler tour problems. It is shown that the derived analytic results match well with simulation results.     

Improved priority access, bandwidth allocation and traffic scheduling for DOCSIS cable networks

The Data Over Cable Service Interface Specifications (DOCSIS) is intended to support IP flows over HFC (hybrid fiber/coax) networks with significantly higher data rates than analog modems and Integrated Service Digital Network (ISDN) links for high quality audio, video and interactive services. To support quality-of-service (QoS) for such applications, it is important for HFC networks to provide effective media access and traffic scheduling mechanisms. In this paper, we first present a multilevel priority collision resolution scheme with adaptive contention window adjustment. The proposed collision resolution scheme separates and resolves collisions for different traffic priority classes (such as delay-sensitive and best effort streams), thus achieving the capability for preemptive priorities. Second, a novel MAC (media access control) scheduling mechanism and a new bandwidth allocation scheme are proposed to support multimedia traffic over DOCSIS-compliant cable networks. It is shown through simulation results that throughput and delay performance have been improved for the transmission of real-time VBR (variable bit rate) traffic as compared to current DOCSIS specifications.     

物理层安全约束下的AF双向中继系统波束赋形和人工干扰联合设计

波束赋形和人工干扰是现有研究中最为常见的两种物理层安全增强技术,本文针对AF （放大转发）双向中继模型,探讨了两者的联合设计问题。在已知理想信道状态信息的条件下,本文提出了一种波束赋形和人工干扰的混合协同传输方案,推导了总功率受限条件下的和安全速率,通过两步迭代搜索算法得到了其最佳联合方案,并与一种低复杂度的次佳联合方案进行比较。仿真结果验证了所得联合方案优于次佳联合方案,并进一步改善了AF双向中继系统的安全性能。     

Structural Aspects of P2-Type Na0.67Mn0.6Ni0.2Li0.2O2 (MNL) Stabilization by Lithium Defects as a Cathode Material for Sodium-Ion Batteries

A known strategy for improving the properties of layered oxide electrodes in sodium-ion batteries is the partial substitution of transition metals by Li. Herein, the role of Li as a defect and its impact on sodium storage in P2-Na_0.67Mn_0.6Ni_0.2Li_0.2O₂ is discussed. In tandem with electrochemical studies, the electronic and atomic structure are studied using solid-state NMR, operando XRD, and density functional theory (DFT). For the as-synthesized material, Li is located in comparable amounts within the sodium and the transition metal oxide (TMO) layers. Desodiation leads to a redistribution of Li ions within the crystal lattice. During charging, Li ions from the Na layer first migrate to the TMO layer before reversing their course at low Na contents. There is little change in the lattice parameters during charging/discharging, indicating stabilization of the P2 structure. This leads to a solid-solution type storage mechanism (sloping voltage profile) and hence excellent cycle life with a capacity of 110 mAh g^-1 after 100 cycles. In contrast, the Li-free compositions Na_0.67Mn_0.6Ni_0.4O₂ and Na_0.67Mn_0.8Ni_0.2O₂ show phase transitions and a stair-case voltage profile. The capacity is found to originate from mainly Ni³⁺/Ni⁴⁺ and O^2-/O^2-δ redox processes by DFT, although a small contribution from Mn⁴⁺/Mn⁵⁺ to the capacity cannot be excluded.     

Ultrafast Responsive and Low-Energy-Consumption Poly(3-hexylthiophene)/Perovskite Quantum Dots Composite Film-Based Photonic Synapse

Emulation of photonic synapses through photo-recordable devices has aroused tremendous discussion owing to the low energy consumption, high parallel, and fault-tolerance in artificial neuromorphic networks. Nonvolatile flash-type photomemory with short photo-programming time, long-term storage, and linear plasticity becomes the most promising candidate. Nevertheless, the systematic studies of mechanism behind the charge transfer process in photomemory are limited. Herein, the physical properties of APbBr₃ perovskite quantum dots (PQDs) on the photoresponsive characteristics of derived poly(3-hexylthiophene-2,5-diyl) (P3HT)/PQDs-based photomemory t hrough facile A-site substitution approach are explored. Benefitting from the lowest valance band maximum and longest exciton lifetime of FAPbBr₃ quantum dot (FA-QDs), P3HT/FA-QDs-derived photomemory not only exhibits shortest photoresponsive characteristic time compared to FA_0.5Cs_0.5PbBr₃ quantum dots (Mix-QDs) and CsPbBr₃ quantum dots (Cs-QDs) but also displays excellent ON/OFF current ratio of 2.2 upon an extremely short illumination duration of 1 ms. Moreover, the device not only achieves linear plasticity of synapses by optical potentiation and electric depression, but also successfully emulates the features of photon synaptic such as pair-pulse facilitation, long-term plasticity, and multiple spike-dependent plasticity and exhibits extremely low energy consumption of 3 × 10⁻¹⁷ J per synaptic event.     

Cooperative Communications in Resource-Constrained Wireless Networks

Cooperative communications have been proposed to exploit the spatial diversity gains inherent in multiuser wireless systems without the need of multiple antennas at each node. This is achieved by having the users relay each others messages and thus forming multiple transmission paths to the destination. In resource constrained networks, such as wireless sensor networks, the advantages of cooperation can be further exploited by optimally allocating the energy and bandwidth resources among users based on the available channel state information (CSI) at each node. In the first part of this article, we provide a tutorial survey on various power allocation strategies for cooperative networks based on different cooperation strategies, optimizing criteria, and CSI assumptions. In the second part, we identify the similarities between cooperative networks and several sensor network applications that utilize collaboration among distributed sensors to achieve the system goal. These applications include decentralized detection/estimation and data gathering. The techniques developed in cooperative communications can be used to solve many sensor network problems