Integration of GIS and multicriteria decision analysis for urban aquaculture development in Bangladesh

Site selection is a key factor in any aquaculture operation, affecting both success and sustainability as well as solving land or water use conflicts. This study was conducted to identify suitable sites for carp farming development in urban water bodies (UWBs) of Chittagong, Bangladesh using Geographical Information Systems (GIS) based MultiCriteria Evaluation (MCE) of water, soil and infrastructure database. ASTER imagery and 14 thematic layers were analyzed with ENVI and GIS capabilities, and developed a series of GIS models to identify and prioritize the appropriate UWBs for carp farming. The study identified 487 UWBs occupying 362 ha and revealed 280 ha (77%) is the most suitable, 36 ha (10%) is moderately suitable and 46 ha (13%) is not suitable which was consistent with field verification. The results are encouraging for extension of carp culture and diversify the economic activities of the urban dwellers.     

Design and simulation of a novel GaN based resonant tunneling high electron mobility transistor on a silicon substrate

For the first time, we have introduced a novel GaN based resonant tunneling high electron mobility transistor (RTHEMT) on a silicon substrate. A monolithically integrated GaN based inverted high electron mobility transistor (HEMT) and a resonant tunneling diode (RTD) are designed and simulated using the ATLAS simulator and MATLAB in this study. The 10% Al composition in the barrier layer of the GaN based RTD structure provides a peak-to-valley current ratio of 2.66 which controls the GaN based HEMT performance. Thus the results indicate an improvement in the current-voltage characteristics of the RTHEMT by controlling the gate voltage in this structure. The introduction of silicon as a substrate is a unique step taken by us for this type of RTHEMT structure.     

Impact of source waters,disinfectants, seasons and treatment approaches on trihalomethanes in drinking water: a comparison based on the size of municipal systems

This study compares concentrations of trihalomethanes (THMs) in municipal water for 2001–2007 from the small and large systems in two provinces in Canada (Newfoundland and Quebec) based on source waters, disinfectants, seasons and treatment approaches. Approximately 71 and 94%, respectively, of the municipal systems in Quebec and Newfoundland are small systems (serving fewer than 3000 people). The small systems serve approximately 8.6% (0.57 million) and 44.1% (0.18 million) of the populations in Quebec and Newfoundland, respectively. Concentrations of THMs and its variability are much higher in the small systems (Quebec: 0–941 μg/L; Newfoundland: 0–875 μg/L) than in the systems with populations 10 000 or more (Quebec: 0–364 μg/L; Newfoundland: 2.3–205 μg/L). The study reveals that the differences in THMs between the small and medium/large systems are because of different types of source waters, treatments, disinfection strategies and seasons. The results emphasize that regulatory agencies must focus more on the occurrence of DBPs in small systems and identify strategies to reduce their levels in drinking water.     

Poly dimethylsiloxane/carbon nanofiber nanocomposites: fabrication and characterization of electrical and thermal properties

This article presents the fabrication and characterization of poly dimethylsiloxane/carbon nanofiber (CNF)-based nanocomposites. Although silica and carbon nanoparticles have been traditionally used to reinforce mechanical properties in PDMS matrix nanocomposites, this article focuses on understanding their impacts on electrical and thermal properties. By adjusting both the silica and CNF concentrations, 12 different nanocomposite formulations were studied, and the thermal and electrical properties of these materials were experimentally characterized. The developed nanocomposites were prepared using a solvent-assisted method providing uniform dispersion of the CNFs in the polymer matrix. Scanning electron microscopy was employed to determine the dispersion of the CNFs at different length scales. The thermal properties, such as thermal stability and thermal diffusivity, of the developed nanocomposites were studied using thermogravimetirc and laser flash techniques. Furthermore, the electrical volume conductivity of each type of nanocomposite was tested using the four-probe method to eliminate the effects of contact electrical resistance during measurement. Experimental results showed that both CNFs and silica were able to impact on the overall properties of the synthesized PDMS/CNF nanocomposites. The developed nanocomposites have the potential to be applied to the development of new load sensors in the future.     

Irregular Characteristics of Bond Interface Formation in Ultrasonic Wire Wedge Bonding

The mechanism of ultrasonic wire wedge bonding, one of the die/chip interconnection methods, was investigated based on the characteristics of the ultrasonic wire bonding joints. The Al-1%Si wire of 25 μm in diameter was bonded on Au/Ni/Cu pad and the joint cross-section was analyzed by scanning electron microscopy （SEM） and energy-dispersive X-ray spectroscopy （EDX）. The results indicated that it is irregular for the ultrasonic bond formation, non-welded at the centre but joining well at the periphery, especially at the heel and toe of the joint. Furthermore, the diffusion and/or reaction at the cross-section interface are not clear at C-zone, while there exists a strip layer microstructure at P-zone, and the composition is 78.96 at. pct Al and 14.88 at. pct Ni, close to the Al3Ni intermetallic compound. All these observations are tentatively ascribed to the plastic flow enhanced by ultrasonic vibration and repeated cold deformation driving interdiffusion between AI and Ni at bond interface.     

Effects of feeding an aquatic weed Lemna trisulaca as partial replacement of fish meal on the performance of growing ducklings

Growing ducklings were fed diets containing an aquatic weed Lemna trisulaca meal (LTM) replacing, on a protein basis, either 40, 60 or 80 g kg^?1 of the fish meal (FM) from a control diet which contained 120 g FM kg^?1. Partial replacement of FM (40 and 60 g kg^?1 of the FM) by LTM on a protein basis showed good growth and low food consumption but food conversion efficiency was found to be comparable. It was concluded that LTM could be considered as a protein feed supplement for growing ducklings and also as a part replacement of animal protein (FM) in the nutrition of growing ducklings without deleterious effect on performance.     

Biological and health implications of toxic heavy metal and essential trace element interactions

Human civilization and a concomitant increase in industrial activity has gradually redistributed many toxic metals from the earth's crust to the environment and increased the possibility of human exposure. Among the various toxic elements, heavy metals cadmium, lead, and mercury are specially prevalent in nature due to their high industrial use. These metals serve no biological function and their presence in tissues reflects contact of the organism with its environment. They are cumulative poison, and are toxic even at low dose. Studies of metabolism and toxicity of these elements have revealed important interactions between them and some essential dietary elements like calcium, zinc, iron, selenium, copper, chromium, and manganese. In general, a deficiency of these essential elements increases toxicity of heavy metals, whereas an excess appears to be protective. While most of the observations are on laboratory animals, limited human data are in agreement with the results of animal experiments. These suggest that the dietary presence of the essential elements may contribute to the protection of man and animal from the effects of heavy metal exposure, while their deficiency may increase toxicity. Appropriate dietary manipulation thus may be valuable in the prevention and treatment of heavy metal toxicity.     

Validity of modified Gompertz and Logistic models in predicting cell growth of Pediococcus acidilactici H during the production of bacteriocin pediocin AcH

Data for the cell growth of Pediococcus acidilactici H during the fermentative production of bacteriocin, pediocin AcH (taken from a previous study) was modeled by two sigmoidal functions, modified Gompertz and Logistic. Results showed that the models could adequately account for the cell growth up to the growth phase, but failed to account for the stationary and death phase.