SiCf/O′-SiAlON composite: properties and oxidation retained properties

A composite of O′SiAlON (Si_2-xAl_xN_2-xO_1+x, with x 0.14) reinforced with 20 vol.% SiC monofilaments was fabricated by hot-pressing, at 1600°C, for 2 h under 34 MPa pressure. The mechanical and interfacial properties of the composites, as-fabricated as well as post-oxidized, were, investigated. The composite exhibited a significant improvement in ultimate flexure strength (640 MPa) and work of fracture (42 kJ m⁻²) compared with that (350 MPa and 1.8 kJ m⁻², respectively) of the monolithic material. These mechanical properties were slightly increased after the composite was heat treated for 24 h in air at 1200 and 1300°C. However, the composite exhibited a significant degradation in ultimate strength, while the work of fracture (WOF) remained unchanged after exposure in air at temperatures beyond 1400°C. The as-fabricated composite revealed a low interfacial shear strength (6.2 MPa) and a frictional sliding stress (3.2 MPa). After the composite was oxidized at elevated temperatures, the interfacial bonding and sliding stresses were reduced to noticeable extents, resulting from the degradation of the carbon coating layer of the SiC monofilaments.     

激光辐照40Cr钢组织结构的穆斯堡尔谱分析

４０Ｃｒ钢试样经不同热处理后在空气中用ＣＯ２连续激光束进行辐照，以穆斯堡尔谱学研究试样在辐照后的组织结构变化。试验结果表明，调质预处理后再进行激光辐照的试样，不仅残作产奥氏体含量较低，而且其中碳的含量最低。     

Parasitic Bipolar Junction Transistors in a Floating-Gate MOSFET for Fluorescence Detection

In this letter, we examined whether the parasitic bipolar junction transistors (BJTs) in the MOSFET fabricated by the standard CMOS process can play a role as a fluorescence detector. To suppress the action of two vertical parasitic BJTs, the gate and n-well were tied in the parasitic BJTs, and the body node was connected to the drain. The proposed device was compared with the inherent and the parasitic diodes in the MOSFET. It had 100 times higher photocurrents than the diodes in the MOSFET. In addition, it was applied for the detection of the fluorescent signal, and could detect near 10 nM of Alexa 546. Therefore, CMOS-process-compatible parasitic BJTs can be used as a photodetector in an integrated fluorescence detector.     

微波感应式电力线防盗在线监测系统

研制了一种微波感应式配电线路防盗在线监测系统，简述了其系统构成、技术特点和应用效果。整个系统由监测分机、监控中心、巡检人员组成，借助该系统进行了一系列实验。结果表明，当有大型移动物体靠近或攀登杆塔时，安装在杆塔上10 m左右的微波感应监测分机感应到移动物体信号，一方面进行语音警示，另一方面通过短信服务及时向监控中心发送短信，监控中心及时通知巡检人员，赶到事故现场，以最大限度地保证输电线路的安全。     

纤维表面处理对植物纤维增强水泥的物理力学性能影响

植物纤维增强水泥的力学性能具有湿敏感性，随湿度增加弯曲强度下降幅度较大。本文工作采用的几种浸渍处理纤维表面的方法，有效地改善了这种状况，其中一种经处理的纤维增强水泥较没有处理的对比试样在饱水状态下的弯曲强度提高了67％，气干状态提高了18％，缩小了二者间的差距。     

微波在免疫组织化学中的应用

本文综述微波技术在免疫组织化学中的应用两头及其进展，着重介绍了微波在组织固定、抗原恢复和免疫染色方面的应用，并对微波免疫组织化学的应用前景进行了展望 。     

用潜坝对抚州市南区水厂取水口淤沙进行治理

多沙河流中的水厂取水口，枯水期经常存在淤沙，影响抽水。以往的治理方法多是采用丁坝群束水冲沙，但坝田淤高有碍行洪，对城市防洪不利．南区水厂采用潜坝方案，兼顾防洪．通航等要求，缩小治理范围，用十分简易的方法获得成功，且投资更省，值得在类似工程中推广运用．     

高精度合成地震记录制作技术研究

制作高精度的合成地震记录是精细储层描述的基础，本文在分析合成地震记录原理的基础上，从地震剖面的极性判断、平均速度的选取，反射系数的准确提取，子波的精确估算等方面对制作合成记录的要点进行了分析，通过提高以上四方面的精度，提高了制作合成地震记录的精度，并提出了一套可行的合成地震记录的检查方法。     

碱土金属氧化物催化氧化异丙苯反应研究

考察了碱土金属氧化物CaO、MgO和SrO在催化氧化异丙苯合成过氧化氢异丙苯 (CHP)反应中的性能。3种催化剂的活性顺序为 :CaO >MgO >SrO。采用Hammett指示剂分别表征了碱土金属氧化物的碱强度。碱强度H-=15 0～ 18 4的碱性中心有利于异丙苯过氧化合成CHP反应。采用红外光谱分析了异丙苯在MgO、CaO催化剂表面的吸附态。异丙苯通过异丙基叔碳原子上的氢原子与CaO催化剂表面碱中心发生化学吸附 ,弱化了异丙基叔碳原子上的C—H键 ,从而有利于催化异丙苯氧化合成CHP的反应。MgO与异丙苯的异丙基叔碳上的氢原子的相互作用弱于CaO与异丙苯的异丙基叔碳上的氢原子的相互作用 ,使MgO催化异丙苯氧化的反应活性低于CaO催化异丙苯氧化的反应活性