Structural properties of phosphorous-doped polycrystalline silicon

The structural properties and hydrogen bonding of undoped and phosphorous doped polycrystalline silicon produced by step-by-step laser dehydrogenation and crystallization technique were investigated using Raman spectroscopy and hydrogen effusion measurements. At low laser fluences, E_L, a two-layer system is created. This is accompanied by the change in hydrogen bonding. The intensity of the Si–H vibration mode at 2000 decreases faster than the one at 2100 cm⁻¹. This is even more pronounced in phosphorous-doped specimens. The laser crystallization results in an increase of the hydrogen binding energy by approximately 0.2–0.3 eV compared to the amorphous starting materials.     

Evaluating hyperspectral imaging of wetland vegetation as a tool for detecting estuarine nutrient enrichment

Nutrient enrichment and eutrophication are major concerns in many estuarine and wetland ecosystems, and the need is urgent for fast, efficient, and synoptic ways to detect and monitor nutrients in wetlands and other coastal systems across multiple spatial and temporal scales. We integrated three approaches in a multi-disciplinary evaluation of the potential for using hyperspectral imaging as a tool to assess nutrient enrichment and vegetation responses in tidal wetlands. For hyperspectral imaging to be an effective tool, spectral signatures must vary in ways correlated with water nutrient content either directly, or indirectly via such proxies as vegetation responses to elevated nitrogen. Working in Elkhorn Slough, central California, where intensive farming practices generate considerable runoff of fertilizers and pesticides, we looked first for long- and short-term trends among temporally ephemeral point data for nutrients and other water quality characters collected monthly at 18 water sampling stations since 1988. Second, we assessed responses of the dominant wetland plant, Salicornia virginica (common pickleweed) to two fertilizer regimes in 0.25 m² experimental plots, and measured changes in tissue composition (C, H, N), biomass, and spectral responses at leaf and at canopy scales. Third, we used HyMap hyperspectral imagery (126 bands; 15–19 nm spectral resolution; 2.5 m spatial resolution) for a synoptic assessment of the entire wetland ecosystem of Elkhorn Slough. We mapped monospecific Salicornia patches (～ 56–500 m²) on the ground adjacent to the 18 regular water sampling sites, and then located these patches in the hyperspectral imagery to correlate long-term responses of larger patches to water nutrient regimes. These were used as standards for correlating plant canopy spectral responses with nitrogen variation described by the water sampling program. There were consistent positive relationships between nitrogen levels and plant responses in both the field experiment and the landscape analyses. Two spectral indices, the Photochemical Reflectance Index (PRI) and Derivative Chlorophyll Index (DCI), were correlated significantly with water nutrients. We conclude that hyperspectral imagery can be used to detect nutrient enrichment across three spatial and at least two temporal scales, and suggest that more quantitative information could be extracted with further research and a greater understanding of physiological and physical mechanisms linking water chemistry, plant properties and spectral imaging characteristics.     

Sandia National Laboratories Validation Workshop: Structural dynamics application

This article specifies a virtual structural dynamic subsystem and some systems, as well as mathematical models that approximately simulate them. The purpose is to define a setting for model validations conceived by participants in the Sandia National Laboratories Validation Workshop. Some broad guidelines for the model validations are set, as well as a regulatory requirement to be satisfied by the target system. Participants are directed to present techniques for subsystem model validation, to analytically predict whether or not the regulatory requirement will be met, and to estimate the likelihood of accuracy of the prediction.     

Thomson scattering diagnostic systems in the ITER divertor

A diagnostic array has been developed for studying the operating modes of the divertor in the ITER tokamak-reactor using the Thomson scattering technique. The aim of this study is to measure the spatial profiles of the electron temperature and density. The structure of the diagnostic setup was selected on the basis of a classical diagnostic geometry and the high-resolution LIDAR system, which provide access to different regions of the divertor plasma. A severe radiation environment, limited access to the plasma in the ITER divertor, and a high-dust environment (the divertor plate erosion material) in the divertor volume pose many problems for performing diagnostics under unique conditions having no analogs in the tokamaks that are now in operation. Different methods for protecting optical surfaces from plasma-enriched deposition are proposed and analyzed. The efficiency of these methods has been demonstrated in bench tests. The concept of laser and detector systems and diffraction polychromators capable of operating at different electron temperatures with a lower limit of 1 eV, has been justified and approved.     

A Nonvolatile Organic Memory Device Using ITO Surfaces Modified by Ag‐Nanodots

We report on a single‐layer organic memory device made of poly(N‐vinylcarbazole) embedded between an Al electrode and ITO modified with Ag nanodots (Ag‐NDs). Devices exhibit high ON/OFF switching ratios of 10⁴. This level of performance could be achieved by modifying the ITO electrodes with some Ag‐NDs that act as trapping sites, reducing the current in the OFF state. Temperature dependence of the electrical characteristics suggest that the current of the low‐resistance state can be attributed to Schottky charge tunnelling through low‐resistance pathways of Al particles in the polymer layer and that the high‐resistance state can be controlled by charge trapping by the Al particles and Ag‐NDs.     

Performance modeling and evaluation of data/voice services in wireless networks

Application-level performance is a key to the adoption and success of the CDMA 2000. To predict this performance in advance, a detailed end-to-end simulation model of a CDMA network is built to include application traffic characteristics, network architecture, network element details using the proposed simulation methodology. We assess the user-perceived application performance when a RAN and a CN adopt different transport architectures such as ATM and IP. To evaluate the user-perceived quality of voice service, we compare the end-to-end packet delay for different vocoder schemes such as G.711, G.726 (PCM), G.726 (ADPCM), and vocoder bypass scheme. By the simulation results, the vocoder bypass scenario shows 30% performance improvement over the others. We also compare the quality of voice service with and without DPS scheduling scheme. We know that DPS scheme keep the voice delay bound even if the service traffic is high. For data packet performance, HTTP v.1.1 shows better performance than that of HTTP v.1.0 due to the pipelining and TCP persistent connection. We may conclude that IP transport technology is better solution for higher FER environment since the packet overhead of IP is smaller than that of ATM for web browsing data traffic, while it shows opposite effect to the small size voice packet in RAN architecture. We show that the 3G-1X EV-DO system gives much better packet delay performance than 3G-1X RTT. The main conclusion is that end-to-end application-level performance is affected by various elements and layers of the network and thus it must be considered in all phases of the development process. Jae-Hyun Kim He received the B.S., M.S., and Ph.D. degrees, all in computer science and engineering, from Hanyang University, Ansan, Korea, in 1991, 1993, and 1996 respectively. In 1996, he was with the Communication Research Laboratory, Tokyo, Japan, as a Visiting Scholar. From April 1997 to October 1998, he was a post-doctoral fellow at the department of electrical engineering, University of California, Los Angeles. From November 1998 to February 2003, he worked as a member of technical staff in Performance Modeling and QoS management department, Bell laboratories, Lucent Technologies, Holmdel, NJ. He has been with the department of electrical engineering, Ajou University, Suwon, Korea, as an assistant professor since 2003. His research interests include QoS issues and cross layer optimization for high-speed wireless communication. Dr. Kim was the recipient of the LGIC Thesis Prize and Samsung Human-Tech Thesis Prize in 1993 and 1997, respectively. He is a member of the Korean Institute of Communication Sciences (KICS), Korea Institute of Telematics and Electronis (KITE), Korea Information Science Society (KISS), and IEEE. Hyun-Jin Lee received the B.S. degree in electrical engineering from Ajou University, Suwon, Korea, in 2004, and is working toward the M.S. degree and Ph. D. degree in electrical engineering at Ajou University. He has been awarded Samsung Human-Tech Thesis Prize in 2004. His research interests QoS, especially network optimization and wireless packet scheduling. He is a member of the KICS. Sung-Min Oh received the B.S. and M. S. degrees in electrical engineering form Ajou University, Suwon, Korea, in 2004, and is working toward the Ph. D. degree in electrical engineering at Ajou University. His research interests QoS performance analysis and 4G network. He is a member of the KICS. Sung-Hyun Cho received his B.S., M.S., and Ph.D. in computer science and engineering from Hanyang University, Korea, in 1995, 1997, and 2001, respectively. From 2001 to 2005, he has been with Samsung Advanced Institute of Technology, where he has been engaged in the design and standardization of MAC and upper layers of B3G, IEEE 802.16e, and WiBro systems. He is currently a MAC part leader in the telecommunication R&D center of Samsung Electronics. His research interests include 4G air interface design, radio resource management, cross layer design, and handoff in wireless systems.     

Is there a direct relationship between oral astringency and human salivary protein binding?

For decades, it is believed that astringency is due to the polyphenol-induced complexation of proline-rich salivary proteins in the oral cavity. In order to compare for the first time the human sensory threshold concentrations and the salivary protein binding activity of a series of astringent stimuli, human saliva protein was incubated for 5 min at 37 °C in the presence of astringent food-derived compounds and, after micro-centrifugation, the amount of the target molecules in the supernatant was quantitatively determined by HPLC-UV/Vis. Significant protein binding was observed for (−)-epigallocatechin-3-gallate, (−)-gallocatechin-3-gallate, (+)-gallocatechin, and (−)-catechin-3-gallate, all of which containing at least one galloyl moiety in the molecule and exhibiting rather high sensory thresholds of more than 200 μmol/L. In comparison, (+)-catechin and procyanidin B2, both lacking in any galloyl function, showed only comparatively low binding activity and, most interestingly, quercetin-3-O-α-l-rhamnopyranosyl-(1 → 6)-β-d-glucopyranoside and 3-carboxymethyl-indole-1-N-β-d-glucopyranoside did not show any protein binding at all, although the later N- and O-glycosides exhibited extraordinarily low sensory threshold concentrations of less than 0.001 and 0.0003 μmol/L, respectively. The data give some first evidence that the quantity of the non-bound, “free” astringent stimulus in the saliva liquid might be more closely related to the sensory perception of astringency than the amount complexed or precipitated by proteins. It is therefore questionable as to whether oral perception of astringency is related to the complexation and/or precipitation of salivary proteins.     

Übergangene Nachbarn; Erlangung der Parteistellung; Sachlichkeitsgebot

Die Regelung über die Erlangung der Parteistellung übergangener Nachbarn durch Geltendmachung von Einwendungen bis l?ngstens drei Monate nach dem angezeigten Baubeginn ist wegen der Anknüpfung an einen untauglichen Zeitpunkt verfassungswidrig.     

Tunable laser-based design and analysis for fractional lambda switches

Fractional lambda switching (FlambdaS) is a novel approach for traffic management over all-optical networks with sub-wavelength provisioning capability. The unique characteristic of FlambdaS is the utilization of UTC (coordinated universal time) for switching with minimum or no buffers. Several central research issues are still open in FlambdaS and need to be formally defined and analyzed. In this paper, we introduce three novel switch designs that are based on the use of tunable lasers (which can be replaced in the future with wavelength converters). First, the paper presents analytical results of scheduling feasibility, which measures the total number of possible different schedules for each switch design. Then it is shown that the architecture with the highest scheduling feasibility is strictly non blocking in the space domain. Next, the paper provides a closed form analysis of the blocking probability in the time domain, which is applicable for any strictly non-space blocking switch, using combinatorics. In addition, the paper provides measures of the switching hardware complexity, which, for the strictly non-blocking architecture, has the same switching complexity as Clos interconnection network, i.e., O(N'radic(N')) where N' is the number of optical channels.