作保灵对长残效除草剂的解毒效应

利用田间试验方法研究保护剂长残效除草剂解毒效应。不同保护剂对豆磺隆解毒效应有差异，作保灵解毒效应最明显，但在除草剂高残留量时解毒作用下降。作保灵对三种长残效除草剂都具有明显的解毒作用，作物的出苗率可恢复80％～100％。解毒效应顺序为油莱＞白菜＞甜菜。     

Chemical Interactions Between Cement and E-Glass Fibers with a CaO–BaO–SiO2–TiO2 Coating

E-glass fibers were coated with a 15CaO–15BaO–20SiO₂–50TiO₂ thin film by the sol–gel method. Mechanical and chemical tests were performed on coated and uncoated fibers in cement and cement extract solutions to investigate the interactions between cement and gel-glass film. The results show that the resistance of E-glass fibers to the alkali cement medium is enhanced by the 15CaO–15BaO–20SiO₂–50TiO₂ coating. The significant roles of TiO₂, CaO, and BaO in the protection fibers from the alkaline attack of cement are described. Some evidence is presented that the alkali corrosion of the coated fibers results in the formation of a thick and compact Ti film that suppresses further corrosion reaction.     

I.L.B.装置在小电网下大型管磨机启停控制中的应用

大型管磨机启停时电压会波动，常规方法是采用一台液体电阻启动器来保证电机启动过程平滑、无冲击。而在小电网下，此法却不尽人意。在越南某水泥粉磨站的水泥磨主电机的供电系统中，成功地将I.L.B装置与液体电阻启动器结合起来，收到事半功倍的效果。     

氨法处理硫酸装置尾气生产亚铵的实践

介绍用氨法处理硫酸装置尾气生产亚硫酸铵的工艺流程、控制指标、主要设备和生产运行情况。实践表明,氨法SO2吸收率高,可实现装置尾气达标排放,但也存在产品品位较低的问题。对问题进行了分析并提出改进意见。     

超高分子相对质量部分水解聚丙烯酰胺合成研究

选择AM均聚后水解工艺路线,采用新型复配引发体系,合成作为油田驱油剂的超高相对分子质量聚丙烯酰胺(简称PAM).在所选高效的引发体系下,考察了主要聚合反应因素对产品平均分子相对质量的影响,确定了聚合工艺条件溶液的pH值为11～11.5,W(单体)为45%,W(引发剂)为70×10-6,W(链转移剂)为1.3×10-6.在优化的聚合条件下,合成了相对分子质量高达25×106,水解度在20%～30%可调,过滤比小于1.3的聚丙烯酰胺.     

硅烷交联型复合半导电塑料

对于硅烷交联型复合半导电塑料的研究表明，合理的选择EVA，炭黑，交联剂，引发剂，催化剂的种类和适宜的用量，仅仅是提高接枝和凝胶质量分散的必要条件，体系环境的酸碱度才是可以交联的充分条件，只有在体系的环境呈现出中性或弱的碱性时，硅烷才可能与PE和EVA充分接枝和交联。     

云南省硫酸磷肥工业的发展方向

论述近年来云南省硫酸磷肥工业的发展情况及今后的发展方向.到2010年,云南省硫酸产能应控制在12.5 Mt/a左右,约占全国总量的20%;磷肥产能应控制在4.1 Mt/a左右,约占全国总量的25%,其中高浓度磷复肥约占全国总量的35%以上;磷矿产量应控制在20 Mt/a左右,约占全国总量的30%,其中擦洗与浮选磷矿约占70%.     

萘降解菌的筛选及降解性能的初步研究

微生物降解是多环芳烃从土壤和水环境中消失的主要途径。本文从加油站废油排放口附近被污染土壤中筛选到两种降解萘的混合菌H1、H2并从中分离出一株纯菌C_1。研究发现,利用纯无机盐培养基加萘作为唯一碳源要比加入其它营养物质的培养基对于筛选萘降解菌更为有利。H_1、H_2和C_1均能以萘为唯一碳源生长,在萘初始浓度为1000mg/L的纯无机盐培养基中培养40h后,培养液中微生物数量分别增长10倍以上,利用气相色谱测得萘的降解率都达到99．6％以上。     

Micro-Indentation Fracture Toughness Evaluation with a Novel Microscopy

A novel microscopy is developed for evaluating the fracture toughness of thin ceramic sheets using the micro-indentation method. This microscopy overcomes the theoretical limit of measurement resolution associated with optical microscopes. Using a modified optical microscope, the crack lengths produced by micro-indentation on the surface of an as-fired ceramic sheet can now be measured. Experimental results on an 8 mol% yttria-stabilized zirconia ceramic substrate show that the accuracy of the fracture toughness evaluation is satisfactory. This micro-indentation fracture toughness evaluation method is efficient and economical for thin ceramic substrate surfaces, either polished or as-fired.     

Synthesis and characterization of maltose fatty acid monoesters as biosurfactants

Maltose long-chain fatty acid esters (MFAE), esterified at the 6 and 6′ position, were synthesized with stearic, palmitic, myristic, and oleic groups. Synthesis yields were 15–20% based on initial maltose present, and structural confirmation was obtained using plasma desorption mass spectrometry and nuclear magnetic resonance spectroscopy. These surfactants have surface tensions in the range of 34–36 dyn/cm at their critical micelle concentrations (CMC) of approximately 10⁻⁵–10⁻⁶ mol/L. The increased chain lengths have a marked effect, reducing CMC values for MFAE by approximately three orders of magnitude over similar carbohydrate-based dodecyl chain sources. Within chain lengths between 14 and 18 carbons, the rate of change in CMC is significant and decreases with increasing chain length for MFAE. The melting points of MFAE are approximately 40°C, and the heat capacities range from 1.6 to 1.9 J/g·K. These numbers are comparable to those of sucrose esters, indicating their applicability in similar uses. However, because MFAE, unlike sucrose, possess an anomeric carbohydrate carbon position, these surfactants maintain their reducing nature and are susceptible to further derivatization. They are also synthesized from renewable, economical carbohydrates and lipids and may provide an excellent alternative to pertrochemical-derived products.