Modelling an insulated gate bipolar transistor using bond graph techniques

Simulators in power electronics are less developed than in other electronic fields. The main modelling methods are between the numerical simulation of semiconductor device equations that hardly simulate circuits, and equivalent circuit models that show poor accuracy. We propose the application of the bond graph techniques to model modular power semiconductor devices. Furthermore, the IGBT is a new power device which combines a bipolar transistor with a MOSFET transistor. We develop a new IGBT bond graph model. The bond graph techniques give us good primary simulation results. We present in this paper the principle and the results of this modelling method.     

Kinetic and Quality Study of Mushroom Drying under Microwave and Vacuum

Abstract

The aim of this work is to model the drying kinetics of mushrooms under several operational conditions, to evaluate the effective diffusivity coefficient of moisture removing by a drying model and inverse calculus method in finite differences and to study the effect on the final quality of dehydrated mushrooms. Different ways of microwave vacuum drying were compared to freeze-drying. Results show that a decrement of the applied pressure produces a certain increase in the drying rate together with a lower moisture in the dehydrated product at the end. Temperature control inside the sample helps to ensure a better quality in the dehydrated product, than when controlled at the surface. Diffusivity coefficients show a correspondence with product temperature during drying. The microwave dried samples obtained with moderate power and temperature control of product shown an important degree of quality similar to that obtained by freeze-drying.     

Cold compaction of polyether-etherketone and nickel powder blends

This study deals with the cold compaction of polyether-etherketone (PEEK) and nickel powder blends. Four different types of PEEK powders which are commercially available from Imperial Chemical Industries (ICI) were utilized for this investigation. These PEEK powders included fine and coarse size powders of a low viscosity grade (150PF and 150P) and similar powders of a high viscosity grade (450PF and 450P). Each of the four different PEEK powders were blended with about 10 vol?% nickel powder (Novamet) using a dry mixing technique. These PEEK/nickel powder blends were then successfully compacted at room temperature. Green strengths as high as 39.5 MPa and 26.3 MPa were measured on nickel filled 150 grade and 450 grade compacts, respectively. The higher strength values of the nickel filled compacts compared to their respective unfilled ones were attributed to a higher degree of mechanical interlocking and plastic deformation, which was induced in the polymer particles during compaction by the hard nickel filler. These composites also exhibited lower viscoelastic recoveries than their respective unfilled compacts. Electrical resistivities as low as 0.06 ohm-cm were achieved by compacting 150P/nickel powder blends. This resistivity value agreed well with the calculated value predicted from the literature.     

New formulation of GNSS acquisition with CFAR detection

This paper deals with the analysis of the acquisition process performed by a global navigation satellite system (GNSS) receiver with a pilot and data channel or in case of GNSS hybrid receiver. Signal acquisition decides the presence or absence of GNSS signal by comparing signal under test with a fixed threshold and provides a code delay and a Doppler frequency estimation, but in low signal conditions or in a noisy environment; acquisition systems are vulnerable and can give a high false alarm and low detection probability. Firstly, we introduce a cell‐averaging‐constant false alarm rate (CFAR) then a data‐pilot cell‐averaging‐CFAR detector fusion based to deal with these situations. In this context, we use a new mathematical derivation to develop a closed‐form analytic expressions for the probabilities of detection and false alarm. The performances of the proposed detector are evaluated and compared with a non‐CFAR case through an analytical and numerical results validated by Mont Carlo simulations. Copyright © 2016 John Wiley & Sons, Ltd.     

High-Performance Work Systems and Organizational Performance in Emerging Economies: Evidence from MNEs in Turkey

This study examines the association between the usage of high-performance work systems (HPWS) by subsidiaries of multinational enterprises (MNEs) in Turkey and employee and subsidiary level outcomes. The study is based on a survey of 148 MNE subsidiaries operating in Turkey. The results show that the usage of HPWS has a significant positive impact on employee effectiveness. However, their impact on employee skills and development, and organizational financial performance are far less clear. Our findings highlight the extent to which HWPS need to be adapted to take account of context-specific institutional realities.     

Encapsulation of nano Disperse Red 60 via modified miniemulsion polymerization. I. Preparation and characterization

Nanocolorant, nano Disperse Red 60, was successfully prepared via modified miniemulsion polymerization process. Transmission electron microscopy was employed to determine the droplet and particle sizes. The effects of the speed and the time of homogenization, the surfactant nature and its amount, the presence of dye, the initiator nature, and the presence of a crosslinker on the morphology and particle size of nanocolorant were studied. UV–vis absorption spectra of nanocolorant with respect to the commercial corresponding dye showed a hypsochromic shift confirming the decrease in particle size. Fourier transform infrared spectra proved the chemical composition of nanocolorant particles assisting the incorporation of the dye within the polystyrene particles. The monomer conversion, surface tension, and apparent sedimentation stability also were measured. The relative electrical conductivity of the suspension was used for determining the polymerization mechanism. The kinetic polymerization was investigated using a pseudofirst-order and it is found that the rate constant of polymerization equals 0.01358 min⁻¹. Zeta potential measurements were employed for miniemulsion which showed that it has good stability at all range of pH. © 2012 Wiley Periodicals, Inc. J Appl Polym Sci, 2012     

HIx system thermodynamic model for hydrogen production by the Sulfur–Iodine cycle

The HI_x ternary system (H₂O–HI–I₂) is the latent source of hydrogen for the Sulfur–Iodine thermo-chemical cycle. After analysis of the literature data and models, a homogeneous approach with the Peng–Robinson equation of state used for both the vapor and liquid phase fugacity calculations is proposed for the first time to describe the phase equilibrium of this system. The MHV2 mixing rule is used, with UNIQUAC activity coefficient model combined with of hydrogen iodide solvation by water. This approach is theoretically consistent for HI_x separation processes operating above HI critical temperature. Model estimation is done on selected literature vapor–liquid, liquid–liquid, vapor–liquid–liquid and solid–liquid equilibrium data for the ternary system and the three binaries subsystems. Validation is done on the remaining literature data. Results agree well with the published data, but more experimental effort is needed to improve modeling of the HI_x system.     

Combined microwave and enzymatic treatments for ��-lactoglobulin and bovine whey proteins and their effect on the IgE immunoreactivity

Effect of combined microwave (MW) and enzymatic hydrolysis on the human immunoglobulin E (IgE)-binding properties of ??-lactoglobulin (??-lg) and other whey proteins (WP) was investigated. Separated ??-lg and full whey protein isolate (WPI) were hydrolyzed with trypsin, chymotrypsin, mixture of trypsin/chymotrypsin, and pepsin at three microwave power levels: 50?W during 1 and 5?min, 100 and 200?W during 1 and 3?min. The immunoreactivity of the obtained hydrolysates resulting from combined microwave protease treatment was assessed using sera of young patients allergic to bovine whey proteins. The application of microwave treatment at 200?W enhances the hydrolysis of ??-lg by pepsin in 3?min and decreases significantly its immunoreactivity. The extensive hydrolysis of the microwave-treated ??-lg and WPI with trypsin, chymotrypsin, and the mixture of trypsin with chymotrypsin did not have an impact on the IgE binding of the products obtained in all the studied conditions.     

A practical approach for modelling and control of biomass pyrolysis pilot plant with heat recovery from combustion of pyrolysis products

A pilot plant of biomass pyrolysis using pyrolysis products as fuel has been tested and shown to improve energy balance of the process and to be environmentally friendly by avoiding rejection of pyrolysis pollutants fumes into the atmosphere. The high number of parameters involved in a pyrolysis process makes it difficult to specify an optimum procedure for charcoal yield and pyrolysis cycle durability. So the knowledge of the essential parameters which govern the kinetics mechanisms of the biomass thermal decomposition and the combustion of pyrolysis gases is very useful to understand the operating cycle of the plant. In the present study a thermochemical model is developed in order to simulate and control the operating cycle of the system. The effect of the inlet molar air flow rate on the temporal evolution of biomass mass loss rate and temperatures in the different active zones of the pilot plant as well as the determination of the critical inlet molar air flow rate for which accidental runaway of combustion reactions occurs are presented. To avoid this accidental phenomenon a Proportional-Integral-Derived (PID) anticipated regulation is used in order to control temperatures evolution in the different zones of the device and avoid the runaway of combustion reactions.