Adaptive relationships of epoxide hydrolase in herbivorous arthropods

Epoxide hydrolase catalyzes a simple hydrolysis of reactive cyclic ethers that may otherwise alkylate and impair critical proteins and nucleic acids required for life. Although much less studied than the cytochrome P-450 monooxygenases that produce epoxides, differences in subcellular, tissue, pH, substrate, and inhibitor specificities argue for at least three forms of insect epoxide hydrolase. Increasing numbers of epoxides are being identified as plant allelochemicals, antifeedants, and essential hormones or precursors for herbivorous arthropods, and in many cases an associated alkene to diol pathway of metabolism is found. A role for epoxide hydrolase in arthropod-plant interactions is strongly supported by species comparisons and by age-activity and induction studies. Two major limitations for study in biochemical ecology of epoxide hydrolase are the lack of an effective in vivo inhibitor and a range of commercially available radiolabeled substrates for the enzymes.     

The significance of defect chemistry for the rate of gas–solid reactions: three examples

Three examples are revisited in which the reaction rate could be reliably correlated with point defect chemistry highlighting the role of point defects as acid–base active centers. In the case of dehydrohalogenation of tertiary butyl chloride, AgCl becomes increasingly active as heterogeneous catalyst, if AgCl is homogeneously or heterogeneously doped. By such a procedure the silver vacancy concentration is adequately increased. The oxygen incorporation into SrTiO₃ offers an example in which the surface mechanism in terms of adsorbed species, oxygen vacancies and electronic centers has been elucidated. Appropriate surface coatings give rise to significant catalytic effects. Increasing iron (acceptor) doping not only changes the point defect chemistry but also the nature of the rate determining step. Lastly, the electrocatalytic function of Sr-doped LaMnO₃ is considered as regards oxygen reduction reaction and O²⁻ incorporation into Y-doped ZrO₂ in the context of solid oxide fuel cells. Again the defect chemistry is of prime importance for the reaction rate.     

Hydrogenation of 3,4-epoxy-1-butene over Cu–Pd/SiO2 catalysts prepared by electroless deposition

Electroless deposition has been used to prepare Cu–Pd/SiO₂ bimetallic catalysts wherein initial Cu coverages are limited only to the pre-existing Pd surface. Cu loading on the Pd surface can be systematically varied by modification of deposition kinetic parameters. In this case deposition time was used as the kinetic variable for the preparation of a series of Cu–Pd catalysts. These materials have been characterized using atomic absorption, CO chemisorption, and FT-IR (adsorption of CO), and then evaluated for the hydrogenation of 3,4-epoxy-1-butene, a functionalized olefin having many potential reaction pathways. Catalyst performance and characterization results suggest that Cu is not distributed in a monodisperse manner on the Pd surface, indicating the existence of autocatalytic deposition of Cu on Cu sites. The FT-IR results suggest that although CO adsorption on all sites is suppressed by Cu addition, initial Cu deposition occurs more readily on certain sites. The bimetallic Cu–Pd sites that are formed exhibit unusually high activity for EpB conversion and formation of unsaturated alcohols and aldehydes. This bimetallic effect on catalyst activity and selectivity is best explained, not by the existence of either ligand or ensemble effects, but rather by the bifunctional nature of the Cu–Pd sites present on the surface of these catalysts.     

Atomization of metal fluorides for enhanced flow characteristics of a multicomponent powder

The National Aeronautics and Space Administration's (NASA's) PS304 coating is a plasma spray deposited tribological coating with feedstock composed of NiCr, Cr₂O₃, Ag and BaF₂-CaF₂ powders. The effects of rounded BaF₂-CaF₂ particles on the gravity-fed flow characteristics of PS304 feedstock have been investigated. The BaF₂-CaF₂ powder was fabricated by water atomization using four sets of process parameters. Each of these powders was then characterized by microscopy and classified by screening to obtain 45-106 μm particles and added incrementally from 0-10 wt.% to the other constituents of the PS304 feedstock, namely nichrome, chromia and silver powders. The relationship between feedstock flow rate, measured with the Hall flowmeter, and concentration of fluorides was found to be linear in each case. The slopes of the lines were between those of the linear relationships previously reported using angular and spherical fluorides and were closer to the relationship predicted using the rule of mixtures. The results offer a fluoride fabrication technique potentially more cost-effective than gas atomization processes or traditional comminution processes.     

'Polymorph Method' Determination of Monoclinic Zirconia in Partially Stabilized Zirconia Ceramics

The polymorph method, which provides phase analysis from a small number of integrated intensities in a powder diffraction scan, is adapted for the determination of monoclinic zirconia in a mixture with cubic, tetragonal. and orthorhombic zirconias and the γ-phase (Mg₂Zr₅O₁₂). Such a mixture is representative of Mg-PSZ after subeutectoid aging. The quantitative determination of the monoclinic depends in principle on a knowledge of the relative amounts of the other phases present in the mixture. It is demonstrated, however, that without this knowledge, even in complex mixtures, the traditional polymorph method analysis gives an acceptable estimate of the monoclinic fraction in the sample.     

Methods of Modifying the Brittle Behavior of Cementitious Composites

We put forward effective methods of increasing the tensile strain of cementitious composites with 2% PVA fiber and high fly ash content. The test results show that curing condition has a significantly effect on the tensile performance. It is approved that the specimens incorporated appropriate volume fraction rubber powder and lightweight aggregate greatly increase the tensile strain of composites at medium-term age, but indefinitely at long-term age. To a certain extent, EVA can limitedly enhance the tensi...     

Mass Transport in the Presence of Internal Defect Reactions—Concept of Conservative Ensembles: IV, Tracer Diffusion and Intercorrelation with Chemical Diffusion and Ion Conductivity

The tracer diffusion coefficient is analyzed for the case in which internal ionization equilibria have to be considered, using the concept of conservative ensembles. The relationships of the tracer diffusion coefficient with other phenome-nological parameters, viz., the chemical diffusion coefficient and the diffusion coefficient derived from the ionic conductivity, as well as with the defect diffusivities are given. The importance of mobile partially ionized or neutral defects is highlighted. In this respect the formulation of the tracer diffusion as an ambipolar diffusion of the different isotopes is helpful.     

Organoiron Polyelectrolytes: Synthesis and Characterization of Cationic Cyclopentadienyliron Complexes of Polyarylether-Imines

The synthesis of an aromatic ether complex of cyclopentadienyliron containing two terminal aldehyde groups was achieved via metal-mediated nucleophilic aromatic substitution reactions. This dialdehyde monomer was subsequently reacted with a variety of aliphatic and aromatic diamines to produce the corresponding soluble cationic organoiron polyether-imines. These cationic organometallic polymers were characterized using IR, ¹H, and ¹³C NMR, viscosity and thermogravimetric analysis. Viscosity measurements showed that these polymers exhibited polyelectrolyte effects in DMSO solutions. Thermogravimetric analysis showed that decoordination of the iron moieties occurred at about 300°C for polymers with aliphatic spacers in their backbones, while the cyclopentadienyliron moieties were cleaved from the polymers with aromatic spacers in their backbones at about 200°C. Photolytic demetallation of the organoiron polymers resulted in the removal of the pendent cyclopentadienyliron moieties and allowed for the isolation of their organic analogs. While the organoiron polymers were soluble in polar organic solvents, the corresponding organic polymers exhibited very limited solubilities or were insoluble. The organic polymers had glass transition temperatures between 101 and 120°C     

Kinetics of Thermal Dehydroxylation and Carbonation of Magnesium Hydroxide

The kinetics of simultaneous dehydroxylation and carbonation of precipitated Mg(OH)₂ were studied using isothermal and nonisothermal thermogravimetric analyses. Specimens were analyzed using X-ray diffraction, transmission electron microscopy, and through measurements of the volume of carbon dioxide evolved in a subsequent reaction with hydrochloric acid. From 275° to 475°C, the kinetics of isothermal dehydroxylation in helium were best fit to a contracting-sphere model, yielding an activation energy of 146 kJ/mol, which was greater than values reported in the literature for isothermal dehydroxylation under vacuum (53–126 kJ/mol). The carbonation kinetics were complicated by the fact that dehydroxylation occurred simultaneously. The overall kinetics also could be fit to a contracting-sphere model, yielding a net activation energy of 304 kJ/mol. The most rapid carbonation kinetics occurred near 375°C. At this temperature, Mg(OH)₂ underwent rapid dehydroxylation and subsequent phase transformation, whereas thermodynamics favored the formation of carbonate. During carbonation, MgCO₃ precipitated on the surface of disrupted Mg(OH)₂ crystals acting as a kinetic barrier to both the outward diffusion of H₂O and the inward diffusion of CO₂.     

A corpus of Schlieren photography of speech production: potential methodology to study aerodynamics of labial,nasal and vocalic processes

Language Resources and Evaluation - This report presents a corpus of articulations recorded with Schlieren photography, a recording technique to visualize aeroflow dynamics for two purposes. First,...