Effect of silver addition on superconductivity in the Bi1.6Pb0.4Sr1.6Ca2Cu3O10−y system

Silver/superconductor composites containing 0 to 80 vol% silver have been prepared and their properties determined. Optimum heat treatment at sintering temperatures ( 800° C) under low oxygen pressures produces material with high critical current density and improves physical properties. Magnetic susceptibility measurements have been found to be consistent with resistivity results. In order to retain a single high-T _c phase with increasing silver content, decreased oxygen partial pressures are required. Using the normal-state resistivity of these composites, a percolation threshold at a silver volume fraction of 43% was observed, while zero resistivity measurements show that a continuous superconducting network can be obtained with up to 80 vol% silver. The critical current density of 21 vol% silver-doped samples was found to be 1520 A cm^–2 at 77.3 K, compared to 260 A cm^–2 for an undoped sample.     

Magnetic field dependence of the critical current density for the bismuth-based bulk high-Tc superconductors

Three types of bismuth-based bulk samples were prepared through uniaxial pressing at room temperature, hot isostatic pressing (HIP) and drawing and rolling. Transport current properties were characterized in a steady field up to 1.12 T at 77 K (T/T _c=0.75). The Josephson weak-link decoupling fields have been found to be 5 mT for the cold-pressed pellet and 30 mT for the HIPed pellet and the rolled tape. At the decoupling field the transport critical current density,J _c, drops 80% from 124 (OT) to 29 A cm^–2 (5 mT) for the cold-pressed pellet, 80% from 582 (OT) to 126 A cm^–2 (30 mT) for the HIPed sample and 50% from6500 (0 T) to 2850 A cm^–2 (30 mT) for the rolled tape. In the flux flow regime, whereB is perpendicular to thec-axis a modified Kim's modelJ _c=(/B ₀)/[(1+B/B ₀)] ⁿ can be used to describe the field dependence of the critical current density, J_c, in the field range 0.2–1.12 T. The effective upper critical fields were estimated to be 0.98, 1.54 and 1.94 T for the three types of samples, respectively. An adjustable range ofB _c2 for bismuth-based bulk highT _c superconductors is given. Flux shear may operate in these materials. The prediction of this pinning mechanism is yielded from fitting the equation qualitatively. WhenB is parallel to thec-axis, the absence of strongly intragranular flux-pinning is emphasized by the poor flux flow regime for the rolled tape sample.     

喷雾干燥法制备的Yb2O3(Al2O3)-8YSZ超细粉的性能

研究了用喷雾干燥法处理Yb2O3掺杂的氧化锆超细粉的性能。采用LS800型激光衍射粒度分析仪、JB-1型氮吸附比表面仪、Rigaku-DmaxⅡ型X射线衍射仪（XRD）和JSM-6700F型扫描电镜（SEM）分析了喷雾干燥法制备的Ybn（Al2O3）-8YSZ超细粉的粒度分布和比表面积，研究了粉末微观形貌特征。结果表明，制备的是球形颗粒、分散性好．晶粒尺寸均匀的超微细2％Yb2O3（Al2O3）-8YSZ（摩尔分数）粉末。     

β晶型成核剂改性聚丙烯纤维研究

研究了含 0 .2 5 %β晶型成核剂 (酰胺化合物 )的聚丙烯 Z3 0 S及其纤维的力学性能、晶型结构和微观形态。通过纺丝 -拉伸实验和力学性能测试、广角 X射线衍射分析、SEM观察 ,发现成核改性后生成了β晶型聚丙烯 (K值约为 75 .3 % ) ,抗冲性能大幅度提高。β晶型聚丙烯在纺丝卷绕过程中发生了β晶型→α晶型转变 ,纤维中产生约 10 %微孔隙 ,改性纤维的力学性能有所降低。     

Decolorization of reactive brilliant red X-3B by heterogeneous photo-Fenton reaction using an Fe–Ce bimetal catalyst

Decolorization of reactive brilliant red X-3B was studied by using an Fe–Ce oxide hydrate as the heterogeneous catalyst in the presence of H₂O₂ and UV. The decolorization rate was in the order of UV–Fe–Ce–H₂O₂ > UV–Fe³⁺–H₂O₂ > UV–H₂O₂ > UV–Fe–Ce ≥ Fe–Ce–H₂O₂ > Fe–Ce. Under the conditions of 34 mg l⁻¹ H₂O₂, 0.500 g l⁻¹ Fe–Ce, 36 W UV and pH 3.0, 100 mg l⁻¹ X-3B could be decolorized at efficiency of more than 99% within 30 min. The maximum dissolved Fe during the reaction was 1 mg l⁻¹. From the fact that the decolorization rate of the UV–Fe–Ce–H₂O₂ system was significantly higher than that of the UV–Fe³⁺–H₂O₂ system at Fe³⁺ = 1 mg l⁻¹, it is clear that the Fe–Ce functioned mainly as an efficient heterogeneous catalyst. UV–vis, its second derivative spectra, and ion chromatography (IC) were employed to investigate the degradation pathway. Fast degradation after adsorption of X-3B is the dominant mechanism in the heterogeneous catalytic oxidation system. The first degradation step is the breaking down of azo and CN bonds, resulting in the formation of the aniline- and phenol-like compounds. Then, the breaking down of the triazine structure occurred together with the transformation of naphthalene rings to multi-substituted benzene, and the cutting off of sulphonic groups from the naphthalene rings. The last step includes further decomposition of the aniline structure and partial mineralization of X-3B.     

非晶态化学镀Ni-Sn-P合金镀层变温晶化的研究

研究了非晶态Ni-Sn-P合金镀层的变温化过程,由实验得出Ni-Sn-P合金约在350℃开始晶化,450℃左右晶化结束,并测得Ni-Sn-P合金变温晶化激活能为233KJ·moL~(-1)。     

我国聚丙烯增韧改性研究进展

综述了目前广泛采用的聚丙烯增韧改性方法，包括共聚，接枝，交联，茂金属作聚合催化剂与共混改性，无机刚性粒子改性，成核改性等。介绍了几种增韧方法的增韧机理，并比较各方法优缺点。提出茂金属聚丙烯，纳米无机粒子增韧和β晶型成核剂改性是今后聚丙烯增韧改性的发展重点。     

Cr_2O_3对方镁石－尖晶石耐火材料抗渣性的影响

采用电熔镁砂及预合成电熔ＭＡ砂为原料，在高温下烧成方镁石－尖晶石试样，当加入少量铬矿时可提高其热震稳定性及抗渣性。用坩埚法作富ＣａＯ转炉渣对方镁石－尖晶石系耐火材料的侵蚀试验后，采用ＸＲＤ、ＳＥＭ、ＥＤＡＸ、岩相分析等方法分析Ｃｒ_２Ｏ_３对方镁石－尖晶石耐火材料抗渣性的影响。     

基于螺旋搜索机制的行星搜索算法

螺旋搜索机制的全局搜索能力强,广泛用于萤火虫算法及鲸鱼搜索算法,但其收敛速度慢,收敛精度低,局部搜索能力较差。通过改变收敛范围较小时的搜索模式,提出了局部螺旋搜索来提高其局部搜索能力,并引入变异操作提高其局部搜索能力,提出了行星搜索算法。通过对单峰及多峰值测试函数对该算法进行验证。结果表明行星搜索算法在收敛速度、搜索精度及局部搜索能力等方面较粒子群算法、萤火虫算法及鲸鱼搜索算法等有明显提升。     

一种基于角色和数据项的访问控制方式

当今社会,随着信息和通信技术的飞速发展,数字信息正在被广泛使用,为了进行数据分析以支撑基于信息的决策,政府、社会机构、公司和个人都可能会收集一些涉及个人的信息数据,然而伴随着大数据资源的正在进行越来越广泛的整合、分析和利用,使得数据治理问题,特别是数据隐私保护问题也越来越被人们重视,成为大数据研究的一个重点。本文针对如何保证数据资源在使用过程中的安全访问控制问题,在主流的基于角色的访问控制方式的思路之上进行了扩展,提出了一种基于角色和数据项的访问控制方式,即在数据库中增加角色对数据表中每一项的访问权限表。实践结果表明,与目前主流的几种访问控制模式相比,实现了对数据的精细化管理,对不同角色的用户访问实现了数据可控,对大数据环境下信息系统的数据隐私保护具有一定的指导意义。