Fe2O3–TiO2 Nano‐heterostructure Photoanodes for Highly Efficient Solar Water Oxidation

Harnessing solar energy for the production of clean hydrogen by photo­electrochemical water splitting represents a very attractive, but challenging approach for sustainable energy generation. In this regard, the fabrication of Fe₂O₃–TiO₂ photoanodes is reported, showing attractive performances [≈2.0 mA cm⁻² at 1.23 V vs. the reversible hydrogen electrode in 1 M NaOH] under simulated one‐sun illumination. This goal, corresponding to a tenfold photoactivity enhancement with respect to bare Fe₂O₃, is achieved by atomic layer deposition of TiO₂ over hematite (α‐Fe₂O₃) nanostructures fabricated by plasma enhanced‐chemical vapor deposition and final annealing at 650 °C. The adopted approach enables an intimate Fe₂O₃–TiO₂ coupling, resulting in an electronic interplay at the Fe₂O₃/TiO₂ interface. The reasons for the photocurrent enhancement determined by TiO₂ overlayers with increasing thickness are unraveled by a detailed chemico‐physical investigation, as well as by the study of photo­generated charge carrier dynamics. Transient absorption spectroscopy shows that the increased photoelectrochemical response of heterostructured photoanodes compared to bare hematite is due to an enhanced separation of photogenerated charge carriers and more favorable hole dynamics for water oxidation. The stable responses obtained even in simulated seawater provides a feasible route in view of the eventual large‐scale generation of renewable energy.     

Structural and magnetic properties of pure and Ca-doped LaCoO3 nanopowders obtained by a sol-gel route

Pure and Ca-doped LaCoO3 nanopowders were prepared by a non-alkoxidic sol-gel route using cobalt(II) acetate, lanthanum(III) nitrate and calcium(II) acetate as oxide precursors. The structural evolution and magnetic properties of the samples were studied as a function of thermal treatments in air up to 1273 K. In particular, the microstructure and composition of the systems were analyzed by X-ray Diffraction (XRD), Transmission Electron Microscopy (TEM), and X-ray Photoelectron Spectroscopy (XPS). Both pure and calcium-doped samples annealing at 973 K resulted in the formation of cubic LaCoO3 (average crystallite size <30 nm). This phase was fully retained in the calcium-doped materials even after annealing at higher temperatures, whereas a transition to the rhomboedral polymorph was detected in the pure samples at 1073 K. The magnetic behavior of the nanopowders was investigated as a function of temperature and applied field using both dynamic and static susceptibility measurements. Pure lanthanum cobaltite samples underwent a transition to an ordered state at 88 K, and their magnetic properties changed as a function of thermal treatments. As concerns calcium-doped samples, they ordered ferromagnetically at 171 and 185 K depending on the annealing temperature and displayed open hysteresis loops with coercive fields as large as 1.75 T at low temperatures.     

Development of antiviral fusion inhibitors: short modified peptides derived from the transmembrane glycoprotein of feline immunodeficiency virus

Feline immunodeficiency virus (FIV) is a naturally occurring pathogen that causes an AIDS-like syndrome in domestic cats and is a valuable model system by which criteria for antiviral vaccines and drugs development can be tested. The cell-entry step of the lentivirus life cycle is regarded as a promising target for the development of new generation inhibitors. We have previously described potent in vitro anti-FIV activity associated with a synthetic octapeptide, termed C8 (Ac-Trp-Glu-Asp-Trp-Val-Gly-Trp-Ile-NH2), containing the Trp-rich motif of FIV transmembrane glycoprotein, which shares a common structural framework with the corresponding molecule of HIV and appears to play a similar role in cell entry. In this report, in an attempt to develop simpler potential fusion inhibitors to be tested in vivo, we describe further studies focused on synthetic peptide analogues of C8. Since C8 inhibitory activity is dependent upon the Trp motif, we systematically replaced these residues with bulky and/or aromatic natural and unnatural amino acids, in order to develop a rational structure-activity relationship. Furthermore, the amino acids located between the Trp residues, which are not crucial for inhibitory activity, were replaced by simple alkyl spacers of appropriate length. Design, NMR structural analysis, in vitro anti-FIV activity in lymphoid cell cultures, and serum stability of these new analogues are reported. The final results indicate that a simpler hexapeptide (Ac-Nal2-Ape-Nal2-Ape-Nal2-Ile-NH2; Nal2 = 3-naphthalen-2-yl-L-alanine, Ape = 5-aminopentanoic acid), almost entirely made up of unnatural amino acid residues, has markedly increased enzymatic stability, while maintaining strong antiviral potency in vitro.     

Responsiveness to Hedgehog Pathway Inhibitors in T-Cell Acute Lymphoblastic Leukemia Cells Is Highly Dependent on 5′AMP-Activated Kinase Inactivation

Numerous studies have shown that hedgehog inhibitors (iHHs) only partially block the growth of tumor cells, especially in vivo. Leukemia often expands in a nutrient-depleted environment (bone marrow and thymus). In order to identify putative signaling pathways implicated in the adaptive response to metabolically adverse conditions, we executed quantitative phospho-proteomics in T-cell acute lymphoblastic leukemia (T-ALL) cells subjected to nutrient-depleted conditions (serum starvation). We found important modulations of peptides phosphorylated by critical signaling pathways including casein kinase, mammalian target of rapamycin, and 5′AMP-activated kinase (AMPK). Surprisingly, in T-ALL cells, AMPK signaling was the most consistently downregulated pathway under serum-depleted conditions, and this coincided with increased GLI1 expression and sensitivity to iHHs, especially the GLI1/2 inhibitor GANT-61. Increased sensitivity to GANT-61 was also found following genetic inactivation of the catalytic subunit of AMPK (AMPKα1) or pharmacological inhibition of AMPK by Compound C. Additionally, patient-derived xenografts showing high GLI1 expression lacked activated AMPK, suggesting an important role for this signaling pathway in regulating GLI1 protein levels. Further, joint targeting of HH and AMPK signaling pathways in T-ALL cells by GANT-61 and Compound C significantly increased the therapeutic response. Our results suggest that metabolic adaptation that occurs under nutrient starvation in T-ALL cells increases responsiveness to HH pathway inhibitors through an AMPK-dependent mechanism and that joint therapeutic targeting of AMPK signaling and HH signaling could represent a valid therapeutic strategy in rapidly expanding tumors where nutrient availability becomes limiting.     

Muscle Proteomic Profile before and after Enzyme Replacement Therapy in Late-Onset Pompe Disease

Mutations in the acidic alpha-glucosidase (GAA) coding gene cause Pompe disease. Late-onset Pompe disease (LOPD) is characterized by progressive proximal and axial muscle weakness and atrophy, causing respiratory failure. Enzyme replacement therapy (ERT), based on recombinant human GAA infusions, is the only available treatment; however, the efficacy of ERT is variable. Here we address the question whether proteins at variance in LOPD muscle of patients before and after 1 year of ERT, compared withhealthy age-matched subjects (CTR), reveal a specific signature. Proteins extracted from skeletal muscle of LOPD patients and CTR were analyzed by combining gel based (two-dimensional difference gel electrophoresis) and label-free (liquid chromatography-mass spectrometry) proteomic approaches, and ingenuity pathway analysis. Upstream regulators targeting autophagy and lysosomal tethering were assessed by immunoblotting. 178 proteins were changed in abundance in LOPD patients, 47 of them recovered normal level after ERT. Defects in oxidative metabolism, muscle contractile protein regulation, cytoskeletal rearrangement, and membrane reorganization persisted. Metabolic changes, ER stress and UPR (unfolded protein response) contribute to muscle proteostasis dysregulation with active membrane remodeling (high levels of LC3BII/LC3BI) and accumulation of p62, suggesting imbalance in the autophagic process. Active lysosome biogenesis characterizes both LOPD PRE and POST, unparalleled by molecules involved in lysosome tethering (VAMP8, SNAP29, STX17, and GORASP2) and BNIP3. In conclusion this study reveals a specific signature that suggests ERT prolongation and molecular targets to ameliorate patient’s outcome.     

Cr (VI) adsorption from aqueous solutions on grafted chitosan

Chitosan was grafted on the surface of a cotton gauze (20, 50, and 100 mg chitosan g⁻¹ cotton) to improve its stability in aqueous solutions. The adsorption of hexavalent chromium ions from water on the grafted chitosan was evaluated to determine, by means of linear and nonlinear models, the kinetic and isotherm adsorption of the process. The kinetics of pseudo second-order, pseudo first-order, and adsorption isotherms type II were obtained, that is, a monolayer adsorption on nonporous adsorbents with physical adsorption was present. The most probable energy of adsorption corresponded to a physisorption with hydrogen bond interactions between chromium ions and ammonium groups. Moreover, three different cross-sectional areas of hexavalent chromium ions were calculated and used to estimate the specific surface area employed by active sites to adsorb metal ions in terms of chitosan or cotton mass. Finally, the percentage of the area occupied by chromium ions on the surface was estimated by dividing the resulting specific surface area in terms of cotton mass by the specific surface area of cotton reported in literature. As a result, it was determined that the occupied area is between 6% (for 20 mg chitosan g⁻¹ cotton)-24% (for 100 mg chitosan g⁻¹ cotton) from the total area of cotton.     

Effects of Conformal Nanoscale Coatings on Thermal Performance of Vertically Aligned Carbon Nanotubes

The high aspect ratio and the porous nature of spatially oriented forest‐like carbon nanotube (CNT) structures represent a unique opportunity to engineer a novel class of nanoscale assemblies. By combining CNTs and conformal coatings, a 3D lightweight scaffold with tailored behavior can be achieved. The effect of nanoscale coatings, aluminum oxide (Al₂O₃) and nonstoichiometric amorphous silicon carbide (a‐SiC), on the thermal transport efficiency of high aspect ratio vertically aligned CNTs, is reported herein. The thermal performance of the CNT‐based nanostructure strongly depends on the achieved porosity, the coating material and its infiltration within the nanotube network. An unprecedented enhancement in terms of effective thermal conductivity in a‐SiC coated CNTs has been obtained: 181% compared to the as‐grown CNTs and Al₂O₃ coated CNTs. Furthermore, the integration of coated high aspect ratio CNTs in an epoxy molding compound demonstrates that, next to the required thermal conductivity, the mechanical compliance for thermal interface applications can also be achieved through coating infiltration into foam‐like CNT forests.     

MicroMAIS: executing and orchestrating Web services on constrained mobile devices

Mobile devices with their more and more powerful resources allow the development of mobile information systems in which services are not only provided by traditional systems but also autonomously executed and controlled in the mobile devices themselves. Services distributed on autonomous mobile devices allow both the development of cooperative applications without a back‐end infrastructure and the development of applications blending distributed and centralized services. In this paper, we propose MicroMAIS: an integrated platform for supporting the execution of Web service‐based applications natively on a mobile device. The MicroMAIS platform is composed of mAS and μ‐BPEL. The former allows the execution of a single Web service, whereas the latter permits the orchestration of several Web services according to the WS‐BPEL standard. Copyright © 2011 John Wiley & Sons, Ltd.     

The application of scalable distributed memory computers to the finite element modeling of electromagnetic scattering

Large-scale parallel computation can be an enabling resource in many areas of engineering and science if the parallel simulation algorithm attains an appreciable fraction of the machine peak performance, and if undue cost in porting the code or in developing the code for the parallel machine is not incurred. The issue of code parallelization is especially significant when considering unstructured mesh simulations. The unstructured mesh models considered in this paper result from a finite element simulation of electromagnetic fields scattered from geometrically complex objects (either penetrable or impenetrable.) The unstructured mesh must be distributed among the processors, as must the resultant sparse system of linear equations. Since a distributed memory architecture does not allow direct access to the irregularly distributed unstructured mesh and sparse matrix data, partitioning algorithms not needed in the sequential software have traditionally been used to efficiently spread the data among the processors. This paper presents a new method for simulating electromagnetic fields scattered from complex objects; namely, an unstructured finite element code that does not use traditional mesh partitioning algorithms. © 1998 This paper was produced under the auspices of the U.S. Government and it is therfore not subject to copyright in the U.S.     

LC/ESI–MS/MS method for the identification and quantification of spinosad residues in olive oils

This paper reports the use of liquid chromatography/electrospray ionisation tandem mass spectrometry (LC/ESI-MS/MS) method for the identification and quantification of residues of the natural insect control agent Spinosad in olive oils. The method determines the active ingredients Spinosyns A and D and two minor metabolites Spinosyns B and K without laborious sample treatment. All four analytes are determined simultaneously in a single injection using positive electrospray ionisation LC–MS with multiple reaction monitoring (MRM). For the quantitative analysis of samples an external calibration curve was built. The calibration curves for each analyte were linear in the concentration range 20–500 ng/mL with a correlation coefficient ranging between 0.995 and 0.999. Results from spike and recovery experiments at levels of 100 and 200 ng/mL gave mean recoveries ranging from 87–116% with satisfactory precision (relative standard deviation (RSD) from 1–8%). The excellent selectivity and sensitivity allows quantification and identification of low levels of Spinosad in olive oils (limits of quantification (LOQs) 0.004–0.073).