离子注入中污染的产生及防护

本文概述了离子注入过程中污染产生的原因和防止污染的措施，特别强调了对微粒污染和金属污染的防护以满足ＵＬＳＩ加工对离子注入的要求。     

Recurrent Epstein-Barr virus-associated lesions in organ transplant recipients

This paper discusses the problem of violence and its expression upon mortality due to external causes. A few indicators are offered, which have been worked upon it to emphasise the importance of the theme. In a general way, the study demonstrates violent death has had its magnitude increased along the years, not only throughout Latin America but also in Brazil and in Santa Catarina.     

Aperture sampling requirements in planar near-field and patterncalculations

The paper covers a simple idea. If we sample an aperture, we can obtain valid patterns over a limited angular region about the normal to the aperture. The same expression can be used with near-field measurements. I reduced the expression to a nomograph. A nomograph allows one to rapidly test various choices. In the second half of the paper, I answer questions caused by the February column which discussed polarization (Milligan, IEEE Antennas. Propag. Mag., vol.38, no.1, p.56-8, 1996)     

Mullite Formation by Endothermic Reaction of α-Alumina/Silica Microcomposite Particles

The formation of mullite was investigated using microcomposite powders which consist of α-alumina cores and amorphous silica coatings. Differential thermal analysis and X-ray diffraction showed that the mullitization reaction was endothermic. In contrast, mullite forms exothermically in samples prepared by sol-gel processing. The results are shown to be consistent with available thermodynamic data for mullite formation from different alumina and silica phases.     

Value analysis of intermittent generation sources from the systemoperations perspective

The objective of this study is to determine the economic and operational impact on energy cost of incorporating large photovoltaic (PV) and wind energy conversion systems (WECS) into the electric utility generation mix. In most cases, PV and WECS power outputs are subtracted from the utility load with the expectation that conventional generation would meet the residual load. This approach is valid for small penetration levels and/or for PV and WECS facilities connected near load centers, However, several constraints such as thermal generation characteristics, fuel supply and delivery, spinning reserve requirements, and hydro availability are not adequately represented in this process. To determine the optimal value of large-scale PV and WECS applications, a new methodology that would take into account the aforementioned constraints as well as a more global penetration is developed. Results indicate that while high hydro availability increases PV penetration levels, high ramping rates can also significantly increase penetration levels     

Three-dimensional CMOS NAND with three stacked channels

A process-inherent NAND2 device is presented for a three-dimensional CMOS integration with epitaxial lateral overgrowth and chemo-mechanical polishing. The required 'OR' function of the two PMOS transistors is achieved by one silicon volume, which is controlled by a back gate and a conventional front gate. Almost symmetrical characteristics are measured for the front and the back gates.<>     

1.3 μm InAsyP1-y-InPstrained-layer quantum-well laser diodes grown by metalorganic chemicalvapor deposition

The authors have fabricated 1.3-μm InAsP-InP separate-confinement-heterostructure (SCH) strained-layer double-quantum-well (SL-DQW) laser diodes (LDs) by metalorganic chemical vapor deposition (MOCVD). A low threshold current density of 410 A/cm ² was obtained. The CW threshold current was as low as 1.8 mA at 20°C, and maximum CW operating temperature of 120°C was obtained. These characteristics are almost the same as those of well-designed GaInAsP-InP SL-QW LDs. Further improvement of the characteristics of InAsP-InP LDs is expected by optimizing the device structure