Behavior of Split Timber Stringers Reinforced with External GFRP Sheets

A large number of timber bridges are at the end of their service life in North America and the prohibitive costs of replacement make owners face the challenge of developing efficient rehabilitation techniques. This paper presents the results from an experimental program of testing old full scale timber stringers with longitudinal splits. Stringers were reinforced for shear and bending using glass fiber-reinforced polymer (GFRP) sheets. A total of nine full-scale Douglas-fir beams were tested in three-point bending after strengthening for flexure and shear with GFRP sheets. Horizontal shear forces in shear reinforcement were calculated using a simplified model. Beams that failed by debonding of shear reinforcement, failed at horizontal shear forces within the range of 150–266?kN. Design charts were constructed on the basis of these calculated forces to simplify the design of shear reinforcement for different sizes and locations of splits.     

CFRP Prestressed High-Strength Concrete Prisms Subjected to Direct Tension

This paper describes the behavior of carbon fiber-reinforced polymer (CFRP) prestressed high-strength concrete prisms under direct tension. Seven prestressed concrete prisms with different levels of prestressing were cast and tested. Prisms were 50×50?mm in cross section and their lengths varied between 1,400 and 2,000?mm. Concrete compressive strength was as high as 147?MPa. Tension stiffening, crack width, and crack spacing in prisms were investigated. Concrete properties, such as the stress–strain relationship under direct tension and bond strength, were also determined. Test results revealed that tension stiffening in CFRP prestressed high-strength concrete is significant when higher concrete strength and higher prestressing level are applied. Tension stiffening factors are proposed based on the postcracking behavior of concrete. Experimental results also showed that increasing the prestressing level increases the amount of tension stiffening and reduces the number of cracks, which delays their appearance. However, cracks widened at a faster rate in the prisms with higher prestressing levels. Experimental results were compared with Comite Euro-International du Beton and American Concrete Institute proposed equations. Modifications were suggested for the above-mentioned equations to account for use of CFRP bars in prestressed sections.     

Kinetische Untersuchung zur platinkatalysierten Hydrosilylierung von Vinylsiloxanen mit Hydrogensiloxanen

Kinetic Investigation of the Platinum-catalysed Hydrosilylation of Vinylsiloxanes with Hydrogensiloxanes A kinetic investigation of the platinum-catalysed hydrosilylation of monofunctional oligomeric vinylsiloxanes by monofunctional oligomeric hydrogensiloxanes was performed under stoichiometric conditions with use of quantitative ¹H-NMR spectrometry. The reaction rate up to 50% conversion can be expressed by v=k [Pt]. During further hydrosilylation the kinetic changed to second order. No induction period was observed. A hydrogensiloxane with a dimethylsilyl end group gives much higher rates than a siloxane with a methylsiloxy group. The main reactions of all hydrosilylations, determined by GC-MS and ²⁹Si-NMR, are β-additions. Less then 5% α-products are obtained.     

Microstructure of Nanocrystalline Yttria-Doped Zirconia Thin Films Obtained by Sol–Gel Processing

Nano- and microcrystalline yttria-stabilized zirconia (YSZ) thin films with a dopant concentration of 8.3±0.3 mol% Y₂O₃ were prepared with a variation in grain size by two orders of magnitude. A sol–gel-based method with consecutive rapid thermal annealing was applied to fabricate YSZ films, resulting in about 400 nm YSZ on sapphire substrates. The average grain sizes were varied between 5 nm and 0.5 μm by heat treatment in the temperature range of 650°–1350°C for 24 h. High-resolution (HRTEM) and conventional transmission electron microscopy analyses confirmed specimens—irrespective of the thermal treatment—consisting of cubic ( c -)ZrO₂ grains with nanoscaled tetragonal precipitates coherently embedded in the cubic matrix. Energy-dispersive X-ray spectroscopy and HRTEM on a large number of specimens yielded a homogeneous yttria concentration within the grains and at the grain boundaries with the absence of impurities, i.e. silica at the grain boundaries.     

The 3.0 A crystal structure of xylose isomerase from Streptomyces olivochromogenes

The crystal structure of xylose isomerase [E.C. 5.3.1.5 [EC] ] fromStreptomyces olivochromogenes has been determined to 3.0 Åresolution. The crystals belong to space group P22₁2₁ with unitcell parameters a = 98.7, b = 93.9, c = 87.7. The asymmetricunit contains half of a tetrameric molecule of 222 symmetry.The two-fold axis relating the two molecules in the asymmetricunit is close to where a crystallographic two-fold would beif the space group were 1222. This causes the diffraction patternto have strong 1222 pseudo-symmetry, so all data were collectedin this pseudo-space group. Since the sequence of this enzymehas not been reported, a polyalanine backbone has been fittedto the electron density. Xylose isomerase has two domains: theN-terminal domain is an eight-stranded /ß barrel of299 residues. The C-terminal domain is a large loop of 50 residueswhich is involved in inter-molecular contacts. Comparison ofxylose isomerase with the archetypical /ß barrel protein,triose phosphate isomerase, reveals that the proteins overlapbest when the third (ß) strand of xylose isomeraseis superimposed on the first (ß) strand of triosephosphate isomerase. This same overlap has also been found betweenthe muconate lactonising enzyme and triose phosphate isomerase[Goldman et al. (1987) J. Mol. Biol., in press].     

Determination of bisphenol A in canned fish by sol–gel immunoaffinity chromatography,HPLC and fluorescence detection

The paper presents a highly selective analysis method for the determination of bisphenol A (BPA) in canned fish. The procedure consists of sample clean-up by sol–gel immunoaffinity chromatography followed by high performance liquid chromatography and fluorescence detection. BPA concentrations were determined in nineteen tuna, sardine and mackerel cans by analysing the solid and the liquid parts of the contents separately. In different tested matrices limits of detection (S/N=3) ranged from 0.2 ng/g (sardines) to 1.8 ng/ml (oil) and limits of quantification (S/N=6) from 0.4 ng/g to 3.8 ng/ml, respectively. In the solid part (fish) very low BPA levels (2–4 ng/g) were found in mackerels, the highest level (59 ng/g) in tuna. In oil significantly higher BPA concentrations were found than in brine. In all samples BPA concentrations were significantly lower than the Specific Migration Level of 0.6 mg/kg for BPA migration into food established by the EU Commission in 2004.     

Estimation of potential impacts and natural resource damages of oil

Methods were developed to estimate the potential impacts and natural resource damages resulting from oil spills using probabilistic modeling techniques. The oil fates model uses wind data, current data, and transport and weathering algorithms to calculate mass balance of fuel components in various environmental compartments (water surface, shoreline, water column, atmosphere, sediments, etc.), oil pathway over time (trajectory), surface distribution, shoreline oiling, and concentrations of the fuel components in water and sediments. Exposure of aquatic habitats and organisms to whole oil and toxic components is estimated in the biological model, followed by estimation of resulting acute mortality and ecological losses. Natural resource damages are based on estimated costs to restore equivalent resources and/or ecological services, using Habitat Equivalency Analysis (HEA) and Resource Equivalency Analysis (REA) methods. Oil spill modeling was performed for two spill sites in central San Francisco Bay, three spill sizes (20th, 50th, and 95th percentile volumes from tankers and larger freight vessels, based on an analysis of likely spill volumes given a spill has occurred) and four oil types (gasoline, diesel, heavy fuel oil, and crude oil). The scenarios were run in stochastic mode to determine the frequency distribution, mean and standard deviation of fates, impacts, and damages. This work is significant as it demonstrates a statistically quantifiable method for estimating potential impacts and financial consequences that may be used in ecological risk assessment and cost-benefit analyses. The statistically-defined spill volumes and consequences provide an objective measure of the magnitude, range and variability of impacts to wildlife, aquatic organisms and shorelines for potential spills of four oil/fuel types, each having distinct environmental fates and effects.     

Heterogeneously doped nanocrystalline ceria films by grain boundary diffusion: Impact on transport properties

Heterogeneous doping of nanocrystalline ceria films, by controlled in-diffusion along grain boundaries, is explored as a means for modifying the space charge potential and the inhomogeneous distribution of defects in the space charge layer known to control the electrical properties of nanocrystalline electroceramics. Nanocrystalline cerium oxide thin films were grown by pulsed laser deposition and modified by a novel doping technique. Thin diffusion sources were deposited and cations such as Ni²⁺ and Gd³⁺ were in-diffused at temperatures of 700–800 °C along columnar grain boundaries normal to the surface; the resulting diffusion profiles were examined by Time-of-Flight SIMS. The properties of these modified films were compared with as-deposited samples, with in-diffusion resulting in decreased electrical conductivity. It is proposed that the variation in conductivity results from a redistribution of charge carriers in the space charge layers due to a change in the space charge potential.     

Dysregulation of Placental Lipid Hydrolysis by High-Fat/High-Cholesterol Feeding and Gestational Diabetes Mellitus in Mice

Advanced maternal age and obesity are the main risk factors to develop gestational diabetes mellitus (GDM). Obesity is a consequence of the increased storage of triacylglycerol (TG). Cytosolic and lysosomal lipid hydrolases break down TG and cholesteryl esters (CE) to release fatty acids (FA), free cholesterol, and glycerol. We have recently shown that intracellular lipases are present and active in the mouse placenta and that deficiency of lysosomal acid lipase alters placental and fetal lipid homeostasis. To date, intracellular lipid hydrolysis in GDM has been poorly studied despite the important role of FA in this condition. Therefore, we hypothesized that intracellular lipases are dysregulated in pregnancies complicated by maternal high-fat/high-cholesterol (HF/HCD) feeding with and without GDM. Placentae of HF/HCD-fed mice with and without GDM were more efficient, indicating increased nutrient transfer to the fetus. The increased activity of placental CE but not TG hydrolases in placentae of dams fed HF/HCD with or without GDM resulted in upregulated cholesterol export to the fetus and placental TG accumulation. Our results indicate that HF/HCD-induced dysregulation of placental lipid hydrolysis contributes to fetal hepatic lipid accumulation and possibly to fetal overgrowth, at least in mice.