海上油田早期弱凝胶驱矿场见效规律及效果评价

针对L油田进行早期弱凝胶驱见效规律和效果评价。注采动态分析显示,弱凝胶驱时受效井含水越低,含水漏斗越不明显,且注入端吸水指数降幅、压力上升值和渗流阻力也越大。将整体技术和经济效果分析结果与其他化学驱油田进行类比,可知L油田早期弱凝胶驱开发效果较好。     

Overall efficiency optimization of controllable mechanical turbo-compounding system for heavy duty diesel engines

A controllable mechanical turbo-compounding (CMTC) system including continuously variable transmission (CVT) and power turbine bypass valve is proposed to recover waste heat from engine exhaust. The combined matching principle considering swallowing capacity of both charging turbine and power turbine, main gear ratio is investigated at first based on the analysis of individual influence. Then the effects and strategies of CVT and power turbine bypass valve are studied for better performance under off-design conditions. At last, the transient response of intake pressure of engine with CMTC system is researched and the fuel saving potential is tested under driving cycle conditions. The results indicate that the overall fuel efficiency elevates at the off-design conditions if CVT is adopted due to the improvement of power turbine operating efficiency by speed modulation. The diversion of exhaust through power turbine bypass valve under the low load condition is necessary. The back pressure of the charging turbine infuences the transient response of intake pressure for a fixed CMTC configuration. A method featured by the assistance of power turbine bypass valve is tested to improve the transient response of the intake pressure. The fuel consumption reduces by 2% and 3.4% under highway fuel economy test (HWFET) and Tianjin 503 (TJ503) driving cycles respectively.     

进程安全保护技术综述

进程安全保护是信息安全领域的一个研究热点,可以应用于计算机安全系统、网站保护、杀毒软件自保护、数字产权保护等方面.在信息安全研究的背景下,总结了进程所受到的威胁,包括软件和硬件方面的威胁;结合实际案例对进程安全保护技术从硬件和软件方面进行了详细分类,分析了每种技术的特点和不足;指出现在研究存在的问题,并展望了未来关于进程安全保护的研究方向和重点.     

峡谷和垭口地形风场特征的CFD数值模拟

为获得峡谷和垭口地形的风场特征和典型位置的风加速效应,采用计算流体动力学(CFD)方法进行模拟计算,将计算得到的单山结果与风洞试验及规范进行对比以验证CFD计算的有效性,对峡谷和垭口地形进行数值模拟计算,分析峡谷和垭口在不同山脚间距时的加速效应,针对内侧山脚和山顶处的加速比给出设计建议.研究表明:山顶处加速比最大;山体横风切面的加速效应比顺风切面显著;CFD模拟与风洞试验结果吻合较好;山顶处,垭口地形风加速效应比峡谷和单山都大;内侧山脚加速比随着两山靠近而增大;内侧山脚处,峡谷地形的加速比小于规范下限,垭口地形在山间距小于一半山体底部直径、离山表面高度低于0.4倍山体高度时的加速比大于规范上限;山顶处的加速比在各种工况下均比较接近;不建议将山顶和垭口位置作为构筑物的选址地点.     

Effects of annealing processes on Cu<Subscript><Emphasis Type="Italic">x</Emphasis></Subscript>Si<Subscript>1-<Emphasis Type="Italic">x</Emphasis></Subscript> thin films

The Cu _x Si_1-x thin films have been grown by pulsed laser deposition (PLD) with in situ annealing on Si (001) and Si (111), respectively. The transformation of phase was detected by X-ray diffraction (XRD). The results showed that the as-deposited films were composed of Cu on both Si (001) and Si (111). The annealed thin films consisted of Cu + η”-Cu₃Si on Si (001) while Cu + η’-Cu₃Si on Si (111), respectively, at annealed temperature (T _a) = 300-600 °C. With the further increasing of T _a, at T _a= 700 °C, there was only one main phase, η”-Cu₃Si on Si (001) while η’-Cu₃Si on Si (111), respectively. The annealed thin films transformed from continuous dense structure to scattered-grain morphology with increasing T _a detected by field emission scanning electron microscope (FESEM). It was also showed that the grain size would enlarge with increasing annealing time (t _a).     

Use of different barium salts to inhibit the thaumasite form of sulfate attack in cement-based materials

We investigated the effects of different barium compounds on the thaumasite form of sulphate attack(TSA)resistance of cement-based materials when they were used as admixtures in mortars.Moreover,we analyzed the inhibition mechanisms within different types of barium salts,namely BaCO_3 and Ba(OH)_2,on the thaumasite formation.The controlcement mortar and mortars with barium salts to cement and limestone weight ratios of 0.5%,1.0%,and 1.5% were immersed in 5%(by weight)MgSO_4 solution at 5 ℃ to mimic TSA.Appearance,mass,and compressive strength of the mortar samples were monitored and measured to assess the generaldegradation extent of these samples.The products of sulphate attack were further analyzed by XRD,FTIR,and SEM,respectively.Experimentalresults show that different degradation extent is evident in allmortars cured in MgSO_4 solution.However,barium salts can greatly inhibit such degradation.Barium in hydroxide form has better effectiveness in protection against TSA than carbonate form,which may be due to their solubility difference in alkaline cement pore solution,and the presence of these barium compounds can reduce the degree of TSA by comparison with the almost completely decomposed controlsamples.     

NH_4SCN解吸剂对负载Re的D296树脂的解吸影响

为了实现离子交换树脂中吸附离子的高效解离,研究了NH_4SCN解吸剂对负载Re的D296树脂的解吸影响,并探讨了其最优解吸工艺.通过静态实验探讨了解吸时间、解吸温度,以及解吸溶液的浓度和p H值对D296树脂的解吸影响,并测定了相应的解吸曲线.结果表明,NH_4SCN解吸剂对D296树脂的最佳解吸温度为323 K,最佳pH值为10,最佳解吸溶液浓度为100 g·L~(-1).在最佳解吸工艺条件下,反应20 min后,D296树脂中Re的解吸率可达98%以上,且解吸反应为吸热反应.当NH_4SCN解吸剂的流速为2 m L·min~(-1)时,淋洗效果较好.     

Influence of deposition pressure on properties of ZnO: Al films fabricated by RF magnetron sputtering

Transparent conductive aluminum doped zinc oxide(ZnO:Al,AZO) films were prepared on glass substrates by rf(radio frequency) magnetron sputtering from ZnO: 3wt% Al_2O_3 ceramic target. The effect of argon gas pressure(PAr) was investigated with small variations to understand the influence on the electrical, optical and structural properties of the films. Structural examinations using X-ray diffraction(XRD) and scanning electron microscopy(SEM) showed that the ZnO:Al thin films were(002) oriented. The resistivity values were measured by four-point probe with the lowest resistivity of 5.76×10~(-4) Ω?cm(sheet resistance=9.6 Ω/sq. for a thickness=600 nm) obtained at the PAr of 0.3 Pa. The transmittance was achieved from ultravioletvisible(UV-VIS) spectrophotometer, 84% higher than that in the visible region for all AZO thin films. The properties of deposited thin films showed a significant dependence on the PAr.     

我国铝业生产的环境负荷动态分析

本文对我国铝业生产的环境库兹涅茨曲线进行研究,分析其是否符合环境污染程度随着经济发展呈现先上升、后下降的倒U形状,并解释其原因.通过对我国铝业生产环境负荷的动态分析,探索我国铝业生产在发展与环保并重的要求下存在的不足及未来的努力方向.     

模糊系统结合蚁群算法的金具温升建模

为了得到准确可靠的阀厅连接金具温升模型,运用模糊系统结合蚁群算法的方法进行建模。在分析基本蚁群算法与梯度下降法优缺点的基础上,将两种方法结合形成改进蚁群算法,即在基本蚁群算法基础上应用梯度下降算法。通过试验得到的训练数据分别用基本蚁群算法、梯度下降算法、改进蚁群算法训练模糊系统,改进蚁群算法的收敛效果优于其他两种方法;通过试验得到的测试数据对4种方法所得的模型进行测试,由改进蚁群算法训练模糊系统所得模型的测试效果是最好的。结果表明,若能通过试验得到足量训练数据,用改进蚁群算法训练模糊系统的方法对阀厅连接金具的温升进行建模是可行的。