Analytical comparison of reversed nested Miller frequency compensation techniques

In this paper, novel and previously proposed reversed nested Miller compensation (RNMC) networks are analyzed and compared, and their design equations are also presented. Hence, this paper is the natural extension of a previous paper by the authors (Int. J. Circ. Theor. Appl. 2008; 36 (1):53–80), where only the nested Miller compensation topologies were treated. In particular, a coherent and comprehensive analytical comparison of the RNMC topologies, including two new networks presented for the first time, is performed by means of the figure of merit that expresses a trade‐off among gain‐bandwidth product, load capacitance and total transconductance, for equal values of phase margin (Int. J. Circ. Theor. Appl. 2008; 36 (1):53–80). The analysis shows that there is no unique optimal solution among the RNMC topologies, as this depends on the load condition as well as on the relative transconductance magnitude of each amplifier stage. From this point of view, the proposed comparison also outlines useful design guidelines for the optimization of large‐signal and small‐signal performance. Simulations confirming the effectiveness of the proposed design methodology and analytical comparison are also included. Copyright © 2009 John Wiley & Sons, Ltd.     

Charge Injection in Solution‐Processed Organic Field‐Effect Transistors: Physics,Models and Characterization Methods

A high‐mobility organic semiconductor employed as the active material in a field‐effect transistor does not guarantee per se that expectations of high performance are fulfilled. This is even truer if a downscaled, short channel is adopted. Only if contacts are able to provide the device with as much charge as it needs, with a negligible voltage drop across them, then high expectations can turn into high performances. It is a fact that this is not always the case in the field of organic electronics. In this review, we aim to offer a comprehensive overview on the subject of current injection in organic thin film transistors: physical principles concerning energy level (mis)alignment at interfaces, models describing charge injection, technologies for interface tuning, and techniques for characterizing devices. Finally, a survey of the most recent accomplishments in the field is given. Principles are described in general, but the technologies and survey emphasis is on solution processed transistors, because it is our opinion that scalable, roll‐to‐roll printing processing is one, if not the brightest, possible scenario for the future of organic electronics. With the exception of electrolyte‐gated organic transistors, where impressively low width normalized resistances were reported (in the range of 10 Ω·cm), to date the lowest values reported for devices where the semiconductor is solution‐processed and where the most common architectures are adopted, are ～10 kΩ·cm for transistors with a field effect mobility in the 0.1–1 cm²/Vs range. Although these values represent the best case, they still pose a severe limitation for downscaling the channel lengths below a few micrometers, necessary for increasing the device switching speed. Moreover, techniques to lower contact resistances have been often developed on a case‐by‐case basis, depending on the materials, architecture and processing techniques. The lack of a standard strategy has hampered the progress of the field for a long time. Only recently, as the understanding of the rather complex physical processes at the metal/semiconductor interfaces has improved, more general approaches, with a validity that extends to several materials, are being proposed and successfully tested in the literature. Only a combined scientific and technological effort, on the one side to fully understand contact phenomena and on the other to completely master the tailoring of interfaces, will enable the development of advanced organic electronics applications and their widespread adoption in low‐cost, large‐area printed circuits.     

Energetic and exergetic analysis of steam production for the extraction of coniferous essential oils

Bioenergy production is optimal when the energy production process is both efficient and benefits from local resources. Energetic and exergetic analyses are applied to highlight efficiency differences between small-size systems that are based on the co-generation of heating and power (CHP) versus the co-generation of heating and power with steam production (CHP-S). Both systems use the Organic fluid Rankine Cycle (ORC).The recovery of heat from flue gases is considered to be a way of increasing energy efficiency. In the CHP-S case, steam (at low pressure) is used to extract essential oils from fresh twigs and needles of coniferous trees throughout a steam distillation process. When the systems work at a thermal combustion power of 1350 kW, energetic analysis shows that the energy efficiency of the CHP-S plant (89.4%) is higher than that of the CHP plant (77.9%). Exergetic analysis shows that the efficiency of the CHP-S plant is 2.2% higher than that of the CHP plant.     

Characterization of metal-supported Al2O3 thin films by scanning electrochemical microscopy

In this paper, physiochemical properties of amorphous alumina thin films, grown by the metal organic chemical vapour deposition process on the surface of platinum (Pt/Al₂O₃) and stainless steel (SS/Al₂O₃), were investigated in aqueous media. The study was performed by the use of scanning electrochemical microscopy (SECM), which allowed obtaining information on uniformity, topography and chemical stability/reactivity of the alumina coatings with high spatial resolution. In particular, the effects due to local acid, base and fluoride ions attack on alumina layers of thickness of about 250 nm (in the Pt/Al₂O₃ sample) and 1000 nm (in the SS/Al₂O₃ sample) were investigated. In the acid and base attack, high concentrations of H₂SO₄ and KOH were electrogenerated locally by the use of a 25 μm diameter platinum microelectrode. The latter was also used as SECM tip to monitor the chemical effect on the alumina layers. It was found that, regardless of the thickness of the film, alumina provided good resistance against local attack of concentrated H₂SO₄; instead, the film dissolved when subjected to KOH attack. The dissolution rate depended on several experimental parameters, such as SECM-tip to substrate distance, electrolysis time and alumina film thickness. The alumina layer proved also relatively poor resistance to etching in 0.1 M NaF solutions.     

Effects of age on cerebrospinal fluid oxytocin levels in free-ranging adult female and infant rhesus macaques.

There is growing interest in examining oxytocin and social functioning in human and non-human primates. Studies of human oxytocin biology are typically restricted to peripheral assessments because opportunities to collect cerebrospinal fluid (CSF) are rare. Several studies have examined CSF oxytocin levels in captive adult primates, but none to our knowledge have been conducted under free-ranging conditions and inclusive of infants. The main goal of this study was to establish feasibility of quantifying CSF oxytocin levels in free-ranging adult female and infant rhesus monkeys living on Cayo Santiago, PR. CSF oxytocin levels were examined in relation to individuals' demographic and reproductive characteristics as well as plasma cortisol levels. CSF oxytocin concentrations ranged from 36.02 to 134.41 pg/ml in adult females (ages 7–26 years; N = 31) and 35.94 to 77.3 pg/ml in infants (ages 38–134 days; N = 17). CSF oxytocin levels were positively correlated with adult female age and negatively correlated with infant age. The former correlation was driven by reproductive status. CSF oxytocin levels were unrelated to dominance rank or plasma cortisol levels. In contrast to a previous study of plasma oxytocin concentrations in this population, CSF oxytocin levels did not differ significantly between lactating and non-lactating females. These findings: 1) provide feasibility data for examining CSF oxytocin levels in free-ranging non-human primates and 2) indicate that CSF oxytocin levels may be a biomarker of age-related central nervous system changes across lifespan development. Research is now required to examine CSF oxytocin levels in the context of social functioning in free-ranging rhesus monkeys. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Representation of journals from five neighboring European countries in the Journal Citation Reports

This study explores the representation of scientific journals from Italy, Hungary, Slovenia, Croatia, and Serbia and Montenegro in the Thomson Scientific’s 2005 Journal Citation Reports (JCR). The number of journals covered by JCR was analyzed in relation to scientific productivity of selected countries and the size of their economies, and no apparent relationship between these factors was found. Our findings suggest that other factors, including the quality of individual journals, may influence how many journals a country will have in the JCR.     

Confocal ultrafast pump-probe spectroscopy: a new technique to explore nanoscale composites

This article is devoted to the exploration of the benefits of a new ultrafast confocal pump-probe technique, able to study the photophysics of different structured materials with nanoscale resolution. This tool offers many advantages over standard stationary microscopy techniques because it directly interrogates excited state dynamics in molecules, providing access to both radiative and non-radiative deactivation processes at a local scale. In this paper we present a few different examples of its application to organic semiconductor systems. The first two are focussed on the study of the photophysics of phase-separated polymer blends: (i) a blue-emitting polyfluorene (PFO) in an inert matrix of PMMA and (ii) an electron donor polythiophene (P3HT) mixed with an electron acceptor fullerene derivative (PCBM). The experimental results on these samples demonstrate the capability of the technique to unveil peculiar interfacial dynamics at the border region between phase-segregated domains, which would be otherwise averaged out using conventional pump-probe spectroscopy. The third example is the study of the photophysics of isolated mesoscopic crystals of the PCBM molecule. Our ultrafast microscope could evidence the presence of two distinctive regions within the crystals. In particular, we could pinpoint for the first time areas within the crystals showing photobleaching/stimulated emission signals from a charge-transfer state.     

Random and block copolymers based on 4-methyl-1-pentene and 1-pentene

The zirconium acetamidinate catalyst {Cp*Zr(Me)₂[N(Et)C(Me)N(tBu)]} (Cp* = ?⁵-C₅Me₅) was used to synthesize both random and block copolymers based on 4-methyl-1-pentene (4M1P) and 1-pentene. The polymers have been characterized by NMR spectroscopy, SEC, DSC, high temperature HPLC and CRYSTAF. Unexpectedly, the yields and molecular weights decreased with increasing amounts of 1-pentene. The reason for this behavior is that 1-pentene occasionally undergoes 2,1-misinsertions trapping the catalyst in a dormant state. These 2,1-misinsertions do not seem to occur with the bulky 4M1P (branched α-olefin). Adding a small amount of ethylene reactivates the catalyst. Unlike most semi-crystalline polymers, the density of the crystalline phase of isotactic P4M1P can be lower than of the amorphous phase, when crystallized under very high pressures. To characterize this peculiar behavior of 4M1P-based polymers, various samples have been subjected to Pressure-Volume-Temperature (PVT) measurements. While the P4M1P homopolymers and block copolymers show the expected decrease in specific volume upon crystallization, the 4M1P-rich random copolymers proved not to vary in specific volume under the same conditions.