Effect of temperature on the strength and conductivity of a deformation processed Cu-20%Fe composite

The high temperature (22–600 °C) properties were evaluated for a Cu-20%Fe composite deformation processed from a powder metallurgy compact. The ultimate tensile strengths decreased with increasing temperature but were appreciably better than those of similarly processed Cu at temperatures up to 450 °C. At 600 °C, the strength of Cu-20%Fe was only slightly better than that of Cu as a result of the pronounced coarsening of the Fe filaments. However, at temperatures of 300 and 450 °C, the strength of Cu-20%Fe is about seven and six times greater, respectively, than that of Cu, as compared to about a two fold advantage at room temperature. Therefore, Cu-20%Fe composites made by deformation processing of powder metallurgy compacts have mechanical properties much superior to those of similarly processed Cu at room temperature and at temperatures up to 450 °C. The pronounced decrease in electrical conductivity of deformation processed Cu-20%Fe as compared to Cu is attributed to the appreciable dissolution of Fe into the Cu matrix which occurred during the fabrication of the starting compacts where temperatures up to 675 °C were used. While the powder metallurgy compacts used for the starting material for deformation processing in this study did not lead to a high conductivity composite, the powder metallurgy approach should still be a viable one if processing temperatures can be reduced further to prevent the dissolution of Fe into the Cu matrix.     

Moral reasoning and moral concerns: An alternative to Gilligan's gender based hypothesis.

Studied the differences in moral orientation in terms of gender specific modes of reasoning, in 2 experiments. In Exp 1, 32 Ss (aged 24–55 yrs) were read the "Heinz dilemma," and asked 3 questions regarding it. Deliberative and justificatory strategies were identified on the basis of the presence or absence of the higher level knowledge structures. In Exp 2, 40 undergraduates were presented with "Michael and Kohlberg Heinz dilemma," followed by a set of relevant questions. Male Ss preferred to apply a norm or rule in their solutions, while females rejected the application of a norm and sought alternative solutions. This was replicated in Exp 2, but the pattern was reversed with female Ss preferring to apply a norm. Males were divided in their use of either strategy indicating that although, genders differed in their judgments as to which norms or rules to apply; once adopted, norms and rules were used in similar ways. (French abstract) (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Effect of precyclic loading on stress-corrosion-cracking initiation in an X-65 pipeline steel exposed to near-neutral pH soil environment

A study was carried out to understand the effect of precyclic loading on stress-corrosion-crack initiation in an X-65 pipeline steel exposed to a near-neutral-pH soil environment. The test specimens were precyclically loaded before corrosion exposure to represent a service history of up to about 20 years, depending on the severity of pressure fluctuation. Microcracks had initiated on the polished surface of the X-65 pipeline steel after long-time exposure at open-circuit potential (OCP) in a near-neutral-pH synthetic soil solution. These microcracks were mostly initiated from pits at metallurgical discontinuities such as grain boundaries, pearlitic colonies, and banded phases in the steel. Strong preferential dissolution was observed along planes of the banded structures in the steel. The selective corrosion attack at these metallurgical discontinuities is attributed to the galvanic nature of those areas to their neighbors. Cyclic loading prior to corrosion exposure had significant effects on microcrack initiation and propagation during subsequent corrosion exposure. Cyclic loading prior to corrosion exposure either reduced or increased the probability of crack initiation and the rate of crack propagation, depending upon the magnitude of the stress cycles. The largest reduction was seen at a peak cyclic stress of about 0.8 of the yield strength. This cyclic-loading-dependent cracking behavior might be related to the alteration of the substructures and the residual stress in the steel as a result of precyclic loading.     

Traveling-wave amplifiers with prescribed frequency response

Microwave transistor amplifier combinations that have controlled frequency response over a specified bandwidth were designed. Theoretical analysis of such an amplifier with an arbitrary number of sections is presented. The response of the amplifier is controlled by tapering the frequency selectivity or Q of each section of the amplifier. To verify the theory, a three-section amplifier with maximally flat time delay response was designed, constructed, and evaluated. Existing traveling-wave amplifiers were modeled as lossy transmission lines. Although the amplifiers were relatively broadband, a prescribed frequency response was not achieved, and each transistor did not receive an equal portion of the signal power. Resistive elements were required for impedance matching at the input and output. The design seeks to improve on previous techniques by trading bandwidth for controlled gain. By making the transmission line that connects the amplifier sections nonuniform, the frequency response was controlled over the design bandwidth. The designs can easily be implemented using familiar components     

What can we learn from the Monte Carlo simulation of the glass transition of polymer melts?

The use of coarse-grained lattice models for the modelling of the glassy freezing in of polymer melts is discussed. The bond-fluctuation model is shown to be a reasonable compromise between simulation efficiency and realistic chemical detail. The potential energy, favoring large values of the length of effective bonds, is at low temperatures in conflict with the tendency for dense packing of the effective monomers and this “geometrical frustration” is responsible for the glass transition of this model. It is shown that many physical properties of the model are in surprisingly close agreement with experiments. Open problems and directions for future research are briefly discussed.     

Possibilities and extension of XRD material response analysis in failure research for the advanced evaluation of the damage level of Hertzian loaded components

Due to clearly distinguishable damage symptoms, it is differentiated between the surface and sub‐surface failure mode of rolling bearings. Material states red out by X‐ray diffraction (XRD) residual stress measurements point to a variety of loading conditions especially at raceway surfaces that are associated with several competing failure mechanisms. The corresponding lifetime reduction can range from the lower fatigue strength region to material ratcheting in extreme cases. Relevant position of the microstructural changes and nature of the failure mechanisms are characterized. The time alteration of the XRD material parameters measured at or near the surface and at the depth of the maximum equivalent stress correlates, in a different manner, with the statistical parameter of the 10 % bearing life. Both failure modes are illustrated by concrete examples. Contaminated lubricant and boundary lubrication, which represent practically important surface‐induced failures, are discussed in more detail. Gray staining, i.e. shallow pitting, often occurs without distinct indication of global material aging by means of XRD characteristics. Here, scanning electron microscopy observations and electron microprobe analyses point to corrosion fatigue as acting surface failure mechanism. The interaction between material and lubricant under complex loading regimes particularly of mixed friction and corrosion opens further failure research areas in the field of tribology.     

Working Memory Capacity and the Antisaccade Task: Individual Differences in Voluntary Saccade Control.

Performance on antisaccade trials requires the inhibition of a prepotent response (i.e., don't look at the flashing cue) and the generation and execution of a correct saccade in the opposite direction. The authors attempted to further specify the role of working memory (WM) span differences in the antisaccade task. They tested high- and low-span individuals on variants of prosaccade and antisaccade trials in which an eye movement is the sole requirement. In 3 experiments, they demonstrated the importance of WM span differences in both suppression of a reflexive saccade and generation of a volitional eye movement. The results support the contention that individual differences in WM span are not exclusively due to differences in inhibition but also reflect differences in directing the focus of attention. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Bedload Transport in Alluvial Channels

Hydraulic, sediment, land-use, and rock-erosivity data of 22 alluvial streams were used to evaluate conditions of bedload transport and the performance of selected bedload-transport equations. Transport categories of transport-limited (TL), partially transport-limited (PTL), and supply-limited (SL) were identified by a semiquantitative approach that considers hydraulic constraints on sediment movement and the processes that control sediment availability at the basin scale. Equations by Parker et al. in 1982, Schoklitsch in 1962, and Meyer-Peter and Muller in 1948 adequately predicted sediment transport in channels with TL condition, whereas the equations of Bagnold in 1980, and Schoklitsch, in 1962, performed well for PTL and SL conditions. Overall, the equation of Schoklitsch predicted well the measured bedload data for eight of 22 streams, and the Bagnold equation predicted the measured data in seven streams.     

Toward the reduction of population obesity: Macrolevel environmental approaches to the problems of food, eating, and obesity.

The authors reviewed the evidential basis of three environmental approaches to reducing population obesity: What are the effects of (a) taxing or subsidizing foods, (b) manipulating the ease of food access, and (c) restricting access to certain foods? A narrative review evaluated evidence using National Heart, Lung, and Blood Institute criteria. There was strong evidence that subsidization influences food purchases, but not necessarily food consumption or body weight. Ease of food access may influence food purchases, and possibly food intake and body weight. Data on restriction were lacking. More studies are needed to justify that altering these macro-environmental variables will necessarily reduce population obesity. A proposed conceptual model posits that the steps through environmental interventions may exert intended and unintended influences on body weight and obesity prevalence. Contemplated policy changes should weigh scientific evidence with social judgments and values concerning changes to the environment. (PsycINFO Database Record (c) 2010 APA, all rights reserved)