基于精细积分法的干摩擦隔振系统稳定性的研究

本文利用摩擦隔振系统的计算模型，建立了系统的动力学方程，在此基础上，对干摩擦隔振系统的稳定性问题进行了分析，同时将精细积分法引入了求解过程，提高了计算的精度，并给出了相应的数值例题，本文的工作可为工程应用提供必要的计算依据。     

语音合成ASIC的原理与设计方法

本文阐述了语音合成专用集成电路(ASIC)的数字信号处理原理.采用波形自适应增量调制编码方法,研究并解决了语音信号的压缩与加密.用半定制标准单元CAD设计方法,CMOS工艺,完成了32K ROM 6秒语音ASIC芯片的设计.     

软土基坑工程中劈裂注浆防渗机理与应用

结合紧邻市政管线的软土基坑工程 ,分析劈裂注浆力学和防渗性能 ,确定技术方案 ,控制施工参数 ,在控制管线位移的前提下达到基坑防渗要求 ,为类似工程提供借鉴     

Analysis of the detectivity for triple-layer heterojunction GaSb/GaInAsSb infrared detectors

In this paper, the detectivity is calculated and analyzed with the front-or backside illuminated case for both N-GaSb/p₂-Ga_0.8In_0.2As_0.19Sb_0.81/p₁-Ga_0.9In_0.1As_0.09Sb_0.91 and N₁-GaSb/n₂-Ga_0.9In_0.1As_0.09Sb_0.91/p-Ga_0.8In_0.2As_0.19Sb_0.81 infrared photovoltaic detectors, respectively. The analysis results show that the main absorption appears in the p-type Ga_0.8In_0.2As_0.19Sb_0.81 material with either front- or backside illuminated case for above two structures. In each structure, the carrier concentration obviously affects the detectivity. The carrier concentration in the wide-bandgap material for the isotype heterojunction should be reduced as low as possible to reduce the tunneling rate at the isotype heterointerface. Moreover, the change of the detectivity with the p-side surface recombination velocity for the N₁-n₂-p structure is more sensitive than that with the p₁-side surface recombination velocity for the N-p₂-p₁ structure. In the N-p₂-p₁ structure with the incident light from the p₁-side surface, two-color detection is achieved.     

节流式差压流量计的发展和现状

文章介绍节流式差压流量计的特点及标准化进程，煤气流量测量中存在的难点以及正在试图解决的途径。     

谈中小水电项目建设程序管理——以贵州中小水能资源开发利用现状为例

分析近年来贵州省中小水电资源开发建设活动中存在的因项目建设程序管理不规范所造成的水能资源开发无序、资源浪费以及工程事故隐患等诸多问题,依据水利工程建设管理有关法律法规,从项目建设管理角度进一步探讨了中小型水电项目建设管理的基本程序。图2幅。     

基于雅可比矩阵的电压控制区域划分的改进

对应用比较广泛的电压控制区域（VCA）划分方法进行了改进，在传统的去除小元素法基础上，采用牛顿 — 拉夫逊法潮流雅可比矩阵中有功和无功对电压幅值偏导数的子矩阵之和进行VCA划分;然后，将各种拓扑变化对系统电压稳定性的影响进行排序，按从大到小的顺序用这些拓扑变化对得到的VCA分区进行修正，直到修正结果不再改变为止，从而得到了适用于各种拓扑结构下电压稳定性分析的分区。改进后分区的有效性在新英格兰10机39节点系统上得到了验证。     

Effect of stress triaxiality levels in crack tip regions on the characteristics of void growth and fracture criteria

The behaviour of void growth in the crack tip regions of four specimen geometries with different stress triaxiality levels have been investigated by the FEM method and experimental observations in plane strain and plane stress cases respectively. It was found that the shape change of growing voids, the configurations of a blunting crack tip and the sizes of decreasing ligament between the void and the crack tip are strongly dependent upon the stress triaxiality levels. Under the condition of plane stress, the stress triaxiality on the ligaments of cracks are nearly the same for different specimen geometries, also the void growth, crack tip blunting asnd decreasing of ligament size are identical for various specimens with increasing load levels, which lead to the conclusion that the J_i-value is independent of specimen geometries. However, in the plain strain case, different void growth, crack tip blunting and decreasing in ligament size for various stress triaxiality levels directly caused the J_i-value to be dependent on the specimen geometries. It was found that when the void is linked to the blunting crack tip by the extrapolation to the zero ligament from FEM calculations, the J_i values, measured experimentally, are underestimated slightly.     

石家庄市室内氡及其子体浓度

本文报道了用双滤膜法对石家庄市室内空气中氡及其子体浓度的调查结果。47个房间室内氡年平均浓度为17.0Bq·m~(-3),氡子体平均浓度是7.14Bq·m~(-3)。氡及其子体浓度的日变化是清晨4—8时出现峰值。季节变化是夏秋季低,冬季高,全年的最低值出现在8月,最高值出现在11月。