新设备技术在催化裂化装置上的应用

文章介绍了近年来在催化裂化装置上应用的新设备、新技术,如BY型旋风分离器、BSX型旋分式三级旋风分离器、上下拱型三级旋风分离器、下拱型三级旋风分离器、SHS“自蔓延”技术、SWY外取热器、BWJ型喷嘴、自流浇注料、Actehem高耐磨衬里、弓形钢丝纤维、侧拉环锚固钉、分体可拆人孔等的结构特点及实际应用情况。     

新会计准则对会计准则质量的影响

年初,国家财政部发布了新的会计准则,这是中国会计准则建设史上的重大事件。新会计准则体现出会计准则质量的几个重要标准,提高了中国会计准则的质量。同时,分析新会计准则质量方面仍存在的一些不足。     

应用API 581对输气站场进行定量风险评价

目前专门针对输气站场的风险评价方法还不多，现有的手段也只是根据国家法律法规得出定性的评价结果，然后按照评价结果对照得出整改方案。为此，对输气站场的定量风险评价工作提出了一套新方法，得到了定量的和更加客观的风险排序，为管道站场的完整性管理工作提供了有力的支持；并以陕京输气管道榆林压气站为例，应用美国石油学会标准API 581（基于风险检测的基本源文件）对站内设施进行了风险评价，计算了站内设备和管线的失效后果、失效概率，得到了定量风险值，进而分析了风险值产生差异的原因。最后，针对我国输气管道风险评估工作提出了看法和建议。     

TUD-DNS3脱硝助剂在催化裂化装置的工业应用

TUD-DNS3脱硝助剂在中韩（武汉）石油化工有限公司1号催化裂化装置上进行了工业应用。结果表明：针对两段再生工艺，当系统中助剂占总催化剂藏量的质量分数为2.6%时，烟气脱硫装置外排污水中的氨氮质量浓度由加剂前的100 mg/L下降至40 mg/L以内；助剂的加入降低了CO焚烧炉的炉膛温度，有利于烟气的合格排放，并对装置操作、产品分布及汽油、柴油产品质量无不良影响。     

On the Feasibility of Growing Pb[(Zn1/3Nb2/3)0.91Ti0.09]O3 Single Crystals

Pb[(Zn_1/3Nb_2/3)_0.91Ti_0.09]O₃ (PZNT91/9) single crystals were grown by two methods: from solution using PbO as a self‐fluxing agent (SC method) and directly from the melt without fluxing (MC method). In both growth methods, an allomeric Pb[(Mg_1/3‐Nb_2/3)_0.69Ti_0.31]O₃ (PMNT69/31) single crystal was used as a seed. X‐ray diffraction patterns of ground crystals showed that phase‐pure perovskite PZNT91/9 single crystals were successfully fabricated by the above two methods. The composition of the crystals obtained by both the SC and MC methods was analyzed using X‐ray fluorescence, which confirmed that the crystal composition is close to the nominal value, although volatilization of PbO and segregation during crystal growth are inevitable. The MC PZNT91/9 crystals exhibit excellent piezoelectric properties, with the piezoelectric constant, d₃₃, in the range of 1800–2200 pC N^–1. This value is comparable to that of the SC crystals. However, the MC crystals show an abnormal dielectric behavior. In contrast with the SC crystals, in the MC crystals a much broader dielectric peak appears in the dielectric response curves, accompanied by a much lower peak temperature of around 105 °C. Furthermore, frequency dispersion is apparent over a much wider temperature range (even more apparent than in pure relaxors), where a large, i.e., about 70 °C, full width at half maximum (FWHM) for the dielectric peaks is observed in the dielectric response. It is speculated that such an unusual phenomenon correlates with defects, microinhomogeneities, and polar regions in the as‐grown MC crystals. The origins of this abnormality have not been interpreted in detail until now. However, optical observation of the domain structure confirms that both the SC and MC crystals possess complex structural states.     

Thermo-Sensitive Ba0.64Sr0.36TiO3 Thin Film Capacitors for Dielectric Type Uncooled Infrared Sensors

Ba_0.64Sr_0.36TiO₃ (BST) thin films are prepared on Pt/Ti/SiO₂/Si₃N₄/SiO₂/Si substrates by a sol-gel method. Thermo-sensitive BST thin film capacitors with a Metal-Ferroelectrics-Metal (M-F(BST)-M) structure are fabricated as the active elements of dielectric type uncooled infrared sensors. XRD are employed to analyze the crystallographic structures of the films. AFM observations reveal a smooth and dense surface of the films with an average grain size of about 35 nm. Rapid temperature annealing (RTA) process is a very efficient way to improve crystallization quality. The preferable annealing temperature is 800°C for 1 min. The butterfly shaped C-V curves of the capacitors indicate the films have a ferroelectric nature. The dielectric constant and dielectric loss of the films at 100 kHz are 450 and 0.038, respectively. At 25°C, where the thermo-sensitive capacitors work, the temperature coefficient of dielectric constant (TCD) is about 5.9 %/°C. These results indicate that the capacitors with sol-gel derived BST thin films are promising to develop dielectric type uncooled infrared sensors.     

诱导水解法制备微细高分散金红石型二氧化钛

采用加热TiCl4稀溶液的方式,制备晶种,将其导入一定浓度的TiCl4溶液中进行诱导水解。所得的偏钛酸经干燥、煅烧后得到分散性好,D50为1 mm以下,金红石含量为≥95%的高纯TiO2,可用于生产PTC热敏电阻等铁电陶瓷。     

Simplification of the Plasma Load of Negative-Pulse-Bias Source Used in Arc Ion Plating

Based on the voltage and current fluctuating phenomenon in the arc plasma load under the negative-pulse-bias, usingthe plasma physics theory and analysis of computer simulation expatiates that the nature of plasma load in vacuumarc plasma is a capacitance     

马来酸酐对聚酰胺6短纤维/天然橡胶复合材料的增容作用

将马来酸酐直接与天然橡胶混炼，得到的马来酸酐-天然橡胶接枝物既能与聚酰胺6短纤维也能与天然橡胶形成良好的结合，有助于提高短纤维增强橡胶复合材料的物理机械性能。     

A decision support system for interactive decision making - Part II: analysis and output interpretation

For pt.I see ibid., p.42-55 (2003). The development of a comprehensive decision support system, GMCR II, for the systematic study of real-world interactive decision problems is presented. The companion paper (Part I), discusses how GMCR II elicits, stores, and manages conflict models; here (Part II), the focus is on GMCR IIs analysis and output interpretation subsystems. Specifically, this paper describes the powerful and efficient analysis engine contained in GMCR II, its informative output presentation and interpretation facilities, and a number of follow-up analyses. Furthermore, an illustrative case study is used to demonstrate how GMCR II can be conveniently applied in practice.