Enhanced adsorption of Cd (II) on a hydrous Al (III) floc in the presence of a modified form of polyethylenimine

A polymer modified with succinic anhydride has been investigated for the adsorption of cadmium (II) on a freshly precipitated aluminium (III) hydroxide floc. The proportion of chelate attached to the polymer is varied to determine the relationship between carboxyl and amino groups on the polyelectrolyte, in terms of enhanced adsorption of cadmium (II) on a hydrous aluminium floc. The presence of polyelectrolyte enhanced the adsorption of 3.3 ppm Cd (II) on a 333 ppm Al (III) floc at every concentration of polyelectrolyte investigated. The proportion of succinic anhydride attached to the polymer had an impact on the increased adsorption of Cd (II) on an Al (III) floc observed. A decreasing proportion of succinic anhydride to polymer resulted in a decrease in the amount of cadmium adsorbed on the floc. Above pH 8, a decrease in the % Cd (II) adsorbed on the floc and % Al (III) retained within the floc decreases with the presence of polyelectrolyte as a result of the formation of soluble Cd-Polyethylenimine-succinic acid (PEISA) complexes. When the Al-PEISA combination was applied to a complex matrix where Cd (II), Cu (II) and Ni (II) ions competed for adsorption, enhanced adsorption was observed for Cd (II) and Ni (II). At pH 7, dissolution of the floc observed with the addition of discrete chelates was not observed with the addition of polyelectrolytes.     

Semi-volatile organic compounds in the Campaspe River system (Victoria, Australia)

The levels of semi-volatile organic compounds (SVOCs) in the Campaspe River system, North Central Victoria, Australia, were monitored from January to September 1995, and the environmental trends and sources of these compounds were determined. The land use within particular catchments dictated the complexity of the SVOCs in run-off water. Run-off from native forest contained the greatest number of SVOCs. Soil and ground litter were shown to contain the greatest complexity of SVOCs, mostly terpenes. However, only a small proportion were leached by run-off with the remainder being tightly bound to the soil or volatilizing to the atmosphere. Under the prevailing drought of early 1995, the rivers contained no detectable SVOCs until the first catchment run-off after significant rainfall in May. The maximum complexity and concentration of the SVOCs coincided with extensive run-off after heavy rainfall in June, effecting a surge of SVOCs with the flood peak. Fatty acids, their amides and hydrocarbons made up the majority of the compounds identified and were in the 1-39 micrograms/l concentration range. The levels then diminished as the catchment was flushed by continual run-off. These results support Lake's 1967 hypothesis that natural floodwaters contain a signature of SVOCs entering from the catchment. The downstream passage of these compounds was obstructed by a man-made storage, Lake Eppalock, with only low concentrations of SVOCs (1-3 micrograms/l) in the outflow, displaying no correlation to run-off.     

Mercury contamination in fish from gold mining areas in Indonesia and human health risk assessment

This study investigates the effects on fish and assesses human health hazards from mercury released in two gold mining areas in Indonesia: Tatelu (North Sulawesi Province) and Galangan (Katingan District, Central Kalimatan Province). In Tatelu, 154 fish specimens of 10 freshwater species were collected, as well as five marine species from the fish market. The mean concentration of total mercury in muscles of freshwater fish from this area was 0.58+/-0.44 microg/g, with more than 45% of fish having Hg levels above the WHO guideline for human consumption of 0.5 microg/g. In Galangan, where 263 fish specimens of 25 species were collected, the total mercury in muscles averaged 0.25+/-0.69 microg/g. Excluding data from flooded open pits in sub-area P4, mean Hg levels in fish from Galangan were 2 to 4 times lower than 0.5 microg/g, while fewer than 10% of fish from Galangan exceeded WHO guidelines. The Hazard Quotient (HQ) was applied to both areas to determine the threat of MeHg exposure for communities in both areas. The HQ is a risk assessment indicator which defines the ratio of exposure level to a single substance in relation to a reference dose. Samples from Tatelu (excluding marine species) had an HQ above one, while those from Galangan resulted in values of 2.4 for the whole area and 9.9 for sub-area P4, pointing to potentially harmful fish consumption for the local population. By using the single-compartment model to estimate mercury levels in blood and hair from daily intake dose, sub-area P4 showed the highest levels, higher than the upper limit guideline for pregnant women, but still lower than threshold levels associated with observed clinical effects.     

Some properties of A sedimentary laterite soil as engineering construction material

A sedimentary laterite soil is examined for its suitability as a construction material by the consideration of its mineralogy and basic geotechnical properties as well as its consolidation and permeability in the compacted state. Three compaction energy levels are utilised. Mineralogically, the soil contains virtually nothing undesirable while its basic geotechnical properties are those generally ascribed to non-problematic soils. The compressibility of the soil varies from moderate to low depending on the energy of compaction. It is however impervious for all the compaction energy levels. The sedimentary laterite soil constitute a good engineering construction material as it has already been successfully used as base and sub-base material in road construction. Results obtained in this study show that this laterite soil is also suitable for use as fill materials in embankment and dam construction.     

Fluid filling of a membrane tube with self-weight

The filling of a membrane tube with self-weight by a fluid is studied theoretically for the first time. The fundamental problem depends on two non-dimensional parameters, $\beta$ and $\gamma$ which represent the importance of internal pressure and membrane self-weight respectively. The nonlinear equations are solved by an efficient numerical integration method. It is found that membrane self-weight has considerable effect on the tube geometry and the tension of the membrane at low filling pressures.     

Representing the socioeconomic world

This paper considers the potential of geographic information systems as a tool for the analysis of the socioeconomic environment. To obtain the maximum benefit from spatial data, it is necessary to find a structure which allows analysis at a wide range of scales, and this is a severe limitation to conventional vector-based systems. Raster models may be constructed that overcome many of these difficulties. This approach serves to illustrate a number of ways in which GIS can be used as a basis for spatial statistics and modeling of socioeconomic phenomena.     

Mesure en place de la permeabilite des sols fins

Bulletin of Engineering Geology and the Environment - La mesure en place de la perméabilité k des sols fins est un moyen d'améliorer la prévision des vitesses de tassement...     

Geomechanical model simulation for the varied rock formations of the Kadana dam foundation,Gujarat, India

Bulletin of Engineering Geology and the Environment - Precambrian layered rocks consisting of quartzites, phyllites and metagreywackes of the Aravallis having a large variation in thickness,...     

Oxygen transfer in a rotating disc treatment plant

In this paper experiments are described in a bio-disc pilot plant. A new method has been developed for a reproducible measurement of the thickness of the waterfilm on the rotating discs. The results were used to calculate the oxygen transfer coefficient into water (K_L). The values of K_L, calculated in this way, appeared to be considerably higher than experimental K_L-values, which is mainly due to the fact that the water layer on the rotating disc is outdistanced by the disc. This effect has not been taken into account in the literature so far.     

Dynamic analysis and optimal feedback control synthesis applied to biological waste treatment

The dynamics and optimal feedback control of biological waste treatment processes are examined. Modern feedback control theory is applied and results are obtained for both proportional and proportional plus integral control. A dynamic mathematical model of the system is developed by employing a Monod kinetic model, which is modified to account for endogenous metabolism, and a complete mixing flow model in the growth chamber. The feedback control is implemented via the flow rate so as to maintain desired effluent concentrations. External disturbances which cause changes in substrate concentration and/or cell concentration are considered and optimal control effort is applied. Results are also presented for impulse and step changes in the influent substrate concentration. It is found that by changing the values of the weighting factors in the objective function, it is possible to obtain good control of either the effluent substrate concentration or cell concentration.