石家庄市室内氡及其子体浓度

本文报道了用双滤膜法对石家庄市室内空气中氡及其子体浓度的调查结果。47个房间室内氡年平均浓度为17.0Bq·m~(-3),氡子体平均浓度是7.14Bq·m~(-3)。氡及其子体浓度的日变化是清晨4—8时出现峰值。季节变化是夏秋季低,冬季高,全年的最低值出现在8月,最高值出现在11月。     

三维Fuzzy数字拓扑及应用(Ⅰ)

本文引入L-,l-连通度的概念,把Rosenfeld等人建立的三维数字拓扑模糊化;并在三维地震处理中找到了它的应用模型.     

油田放射性作业人员外周血淋巴细胞染色体畸变的观察

本文调查了油田212例受γ射线和中子混合辐射照射的作业人员和30例正常人的外周血淋巴细胞染色体畸变。作业人员受γ射线照射的人均年受照剂量为1.28mGy。调查结果表明,放射性测井人员与正常人相比染色体畸变率有显著差异。     

石油系油浆与煤系闪蒸油的焦化性能——I．热解条件的影响

通过偏光显微镜观察了石油系油浆（LH）与煤系闪蒸油（SN）焦化后所得焦块的光学结构。结果表明，在较宽条件下两种原料单独焦化均得不到取向度高的流线型结构。将两种原料以一定比例混合后先热解丙焦化所得焦块的光学结构明显好于二者混合后直接焦化所得焦块的光学结构，其中LH和SN以3：2的重量比混合后在440℃、1MPa下热解3．5h然后再在530℃、1MPa下焦化8h所得焦块为具有较高取向度的流线型结构，适合于作为针状焦的起始原料。     

北京谱仪端盖簇射计数器工作气体的研究

为使北京谱仪端盖族射计数器更好地工作在自猝灭流光ＳＱＳ模式下，提高其能量分辨以及线性等指标，用Ａｒ，ＣＯ２，Ｌｓｏｂｕｔａｎｅ三元工作气体对探测器的工作性能进行了仔细研究，找出了一适合于主雇地数器的工作气体，此外，还研究了异丁的纯度对探测器性能的影响。     

云南锰矿选矿现状与前景分析

云南锰矿资源丰富,具有品位高、低磷低铁、易选等特点。文章概述了斗南、鹤庆、建水等锰矿的选矿科研进展情况,三个锰矿均可采用强磁选或磁-重选流程选别,可提高品位8—12％;精矿含锰可达33—35％,锰回收率在80％以上的好结果。     

Adaptive predictive control algorithm based on Laguerre Functional Model

Laguerre Functional Model has many advantages such as good approximation capability for the variances of system time‐delay, order and other structural parameters, low computational complexity, and the facility of online parameter identification, etc., so this model is suitable for complex industrial process control. A series of successful applications have been gained in linear and non‐linear predictive control fields by the control algorithm based on Laguerre Functional Model, however, former researchers have not systemically brought forward the theoretical analyses of the stability, robustness, and steady‐state performance of this algorithm, which are the keys to guarantee the feasibility of the control algorithm fundamentally. Aimed at this problem, we introduce the principles of the Incremental Mode Linear Laguerre Predictive Control (IMLLPC) algorithm, and then systemically propose the theoretical analyses and proofs of the stability and robustness of the algorithm, in addition, we also put forward the steady‐state performance analysis. At last, the control performances of this algorithm on two different physical industrial plants are presented in detail, and a number of experimental results validate the feasibility and superiority of IMLLPC algorithm. Copyright © 2005 John Wiley & Sons, Ltd.     

Assessment of underground cable ratings based on distributed temperature sensing

Numerous power utilities have installed advanced distributed temperature sensing (DTS) systems to measure the temperature of underground cables. This paper presents a general procedure for real-time assessment of underground cable ratings based on DTS. After the identification and location of hot spots on a cable, the cable installation data, load, and DTS-recorded temperature over a period of time are used to estimate soil thermal parameters and assess cable ratings under normal and overloading conditions. In order to accurately estimate soil thermal parameters, a combined technique of the finite-element method and gradient-based optimization is used. The technique was validated in the laboratory and applied to a rating assessment of a 230-kV/500-MVA cable circuit. The assessed continuous and emergency ratings are helpful in improving the operation of this circuit.     

Reliability Modeling and Analysis of Communication Networks with Dependent Failures

This paper presents a new model to study the reliability of communication networks in which link failures are statistically dependent. The approach tries to identify and model explicitly the events that cause communication link failures. No conditional probabilities are needed, and so two major difficulties inherent to them, namely, an exponential number of conditional probabilities to deal with and a consistency requirement to satisfy, are avoided. For reliability computations, some existing algorithms for finding network reliability can be used with minor modifications and no significant increase in computational complexity.