A novel shaft-less double suction mini pump

A novel double suction shaft-less mini pump was developed for heat control of small energy systems in this study.The mini pump impeller with an exit diameter of 40 mm was combined with the motor rotor supported by the hybrid dynamic bearing.The specific speed of the pump was 125 min-1 m3 min-1 m.The hydraulic performance of the pump was investigated experimen-tally under four rotational speeds.From the test results,it was recognized that the pump could provide a flow discharge of 5 L/min and head of 1.5 m,w...     

简易放顶煤工作面瓦斯综合治理技术

不稳定煤层采用单体液压支柱放顶煤开采技术,无疑是一种高效采煤方法。由于工作面采高大、单产高,且底层落煤与顶层放煤同时进行或工序间隔时间短,相应的采煤工作面瓦斯涌出量明显增大,采空区上部和工作面上方顶煤裂隙中易形成瓦斯积聚,从而严重威胁工作面的安全生产。本文通过分析简易放顶煤采煤工作面各生产工艺中瓦斯涌出规律,提出并实施有效的针对性综合瓦斯治理技术措施,实现了工作面的安全生产。     

注氮惰化窒息燃烧煤炭氧浓度的实验研究

利用煤炭自燃实验系统,对龙固煤矿7煤煤样的自燃过程进行了模拟实验.实验研究了注氮情况下的煤氧化煤温、自燃状态与氧含量的变化关系,确定了龙固煤矿7煤煤样窒息的最低氧浓度,研究结果对使用注氮防治煤炭自燃技术的应用具有重要的现实指导意义.     

熔体接枝与共混改性调控等规聚丙烯聚集态结构与性能

聚丙烯在应力与温度等因素作用下晶型转变而引起的物理力学性能的变化尚未得到学术界与工程界的应有重视。通过熔体自由基接枝多功能团单体、添加高熔点的聚合物和α成核剂调控其聚集态结构,有效抑制了聚丙烯在应力作用下的晶型转变,改善了聚丙烯的疲劳稳定性,有助于增加其在工程应用中的使用寿命。     

Study on early warning index of spatial deformation for high concrete dam

Owing to the deficiency in early warning for high concrete dam,a formula was established to characterize the deformation behavior of high concrete dam as a whole.The early warning index of spatial deformation was calculated by low probability principle on the basis of the deformation entropy formula proposed.The steps were as follows.Firstly,the probability method was utilized to define the degree of order and degree of chaos for each survey point.Secondly,the weight distribution among the survey points was...     

阻火器的选用

阻火器的选用是石油化工厂、石油和天然气工厂、有可燃性气体的工厂生产安全保护和工程设计中常遇到并需解决的问题，本文对阻火器产品的选用步骤提出了个人的一些理解意见。     

从管道检测的角度,分析涂层失效的原因

本文首先阐明涂层对管道保护的重要作用，综述了目前长输管道涂层现状及常用涂层材料的特点，通过近几年来对数千公里管道的不同类型涂层检测、评价，总结出涂层失效的主要形式，从管道周围介质的腐蚀性、环境及涂层施工等方面，分析了外界条件与涂层失效的关系，以及导致涂层失效的主要原因。目前长输管道涂层失效的形式主要有：涂层的剥离、龟裂、破损及变形等。     

Viscosity index. I. Evaluation of selected copolymers incorporating n-octadecyl acrylate as viscosity index improvers

Compositionally and structurally varied copolymers all containing n-octadecyl acrylate were prepared and evaluated as viscosity index improvers in a common base oil under conditions of low shear. Systems evaluated over a range of copolymer and blend composition were: copolymers of n-octadecyl acrylate with, respectively, methyl methacrylate, 2-ethylhexyl acrylate, and n-dodecyl acrylate; and homopolymers of poly(n-octadecyl acrylate), prepared with a wide range of molecular weights. Properties were compared with those of blends of commercial methacrylate copolymers (acryloids) which had been freed of their entraining liquid. Mixtures of base oil with copolymers of n-octadecyl acrylate and methyl methacrylate, compared at fixed SAE viscosities, were the most efficient of all blends studied. They had the smallest rate of change of viscosity with temperature (as measured by their ASTM slopes), particularly in the composition region of incipient polymer precipitation at room temperature. Efficiency of certain of these composition was somewhat greater than that of the acryloids. A parameter that related concentration and weight-average molecular weight was used to correlate all of the data for ASTM slope and viscosity. Empirical relations developed by using this parameter enabled rheological data to be estimated that agree within 6% of experimental values for the case of thermodynamically good base oil solvents. These data demonstrated the relatively small contributions of copolymer structure to viscosity index improvement.     

仿瓷胶粘剂的研究

本文介绍一种仿瓷环氧胶粘剂,该胶耐酸耐碱,可室温固化,在室温下粘接不锈钢试样,其剪切强度可达30.7MPa;而在130℃时其剪切强度为1.7MPa。可用于修复搪瓷,粘接金属和陶瓷等。     

TIG焊和PAW焊中活性剂对焊缝熔深的影响

针对常规TIG焊生产效率低、熔深小等问题，研究了TIG焊和PAW焊中应用活性剂对焊缝熔深的影响。结果表明，应用活性剂后，在同样的参数下，同传统TIG相比，活性剂能够大幅度提高不锈钢、铝合金和钛合金的焊缝熔深。对于PAW焊，熔深也有增加，但是增加的幅度不如TIG效果明显，但对焊缝成形有很好的改善。同时，活性剂对铝合金焊接背面能够起到保护作用。对于钛合金，活性剂除了增加焊缝的熔深外，还能够大幅度地消减焊缝产生的气孔。