Doubly Bonded C60 Dimers and Congeners: Computational Studies of Structures, Bond Energies and Transformations

Initial steps of thermal transformation from doubly bonded [2+2] (1) and [4+4] (2) dimers of C₆₀ have been analyzed on the basis of computed structural features and Pople's energy partition scheme. Completely conjugated C₁₂₀ structures 3 and 4 are found to be considerably stable and proposed to be important intermediates. The linkage patterns in 3 and 4 are also likely to appear in the repeating units of the metastable dimer and polymer phases of A₁ crystals.     

Series resonant ZCS‐PFM DC‐DC power converter with high‐frequency high‐voltage transformer link for high‐power magnetron drive

This paper presents a single lossless inductive snubber‐assisted ZCS‐PFM series resonant DC‐DC power converter with a high‐frequency high‐voltage transformer link for industrial‐use high‐power magnetron drive. The current flowing through the active power switches rises gradually at a turned‐on transient state with the aid of a single lossless snubber inductor, and ZCS turn‐on commutation based on overlapping current can be achieved via the wide range pulse frequency modulation control scheme. The high‐frequency high‐voltage transformer primary side resonant current always becomes continuous operation mode, by electromagnetic loose coupling design of the high‐frequency high‐voltage transformer and the magnetizing inductance of the high‐frequency high‐voltage transformer. As a result, this high‐voltage power converter circuit for the magnetron can achieve a complete zero current soft switching under the condition of broad width gate voltage signals. Furthermore, this high‐voltage DC‐DC power converter circuit can regulate the output power from zero to full over audible frequency range via the two resonant frequency circuit design. Its operating performances are evaluated and discussed on the basis of the power loss analysis simulation and the experimental results from a practical point of view. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 153(3): 79–87, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20126     

Crystallization process and magnetic properties of Fe100−x,B x (10 ≦ × ≦ 35) amorphous alloys and supersaturated state of boron inα-Fe

Amorphous specimens of Fe_100–x B _x were prepared in the range 10 × 35 at % B by a single-roller method. The crystallization process and the boron concentration dependence of the Curie temperature were examined by differential scanning calorimetry, X-ray diffraction, Mössbauer spectroscopy and magnetic measurements. Two-step crystallization was observed in specimens with× < 17: amorphous amorphous + boron-supersaturated b c c phase (-Fe(B)) t-Fe₃B +-Fe. A single-Fe(B) phase was not observed. The transition temperature from t-Fe₃B to stable (-Fe + t-Fe₂B) sensitively depends on the boron content in the alloys. The crystallization temperature (T _x) of the amorphous alloys was almost unchanged for 17 × 31, but increased remarkably at high boron concentrations of× 33, where the decomposition products consisted of t-Fe₂B and o-FeB. The Curie temperature (T _c) of the amorphous phase was as low as 480 K at× = 10, increased with increasing boron content up to 820 K and then decreased in the high boron concentration alloys of× > 28. A single-Fe(B) phase was not detected in the as-quenched specimens of× = 8 and 10. The phase coexisted with the o-Fe₃B and amorphous phases. The lattice parameter of the phase was 0.2861₀ nm which was smaller than that of pure iron by 2/1000, indicating the substitutional occupation of boron atoms in the b c c lattice.     

铝合金局部加压凝固及流动数值模拟的研究

局部加压方法是压铸中用于消除铸件厚壁处缩孔缺陷的一种新工艺.本研究通过实验模型测量了不同加压条件下铸件的冷却曲线,分析了局部加压引起的凝固变化.考虑局部加压引起的补缩流动,通过适时修改网格文件、初始和边界条件的方法,模拟了局部加压过程中铝合金的凝固及流动变化,并与实验结果进行了对比,二者基本吻合.     

Interactions oftrans-cinnamic acid,its related phenolic allelochemicals,and abscisic acid in seedling growth and seed germination of lettuce

Phenolic compounds have been identified as the most common allelochemicals produced by higher plants. Inhibitions of cinnamic acid, its related phenolic derivatives, and abscisic acid (ABA) on seedling growth and seed germination of lettuce were studied.trans-Cinnamic acid, ando-,m-, andp-coumaric acids inhibited the growth of etiolated seedlings of lettuce at concentrations higher than 10^–4 M and seed germination above 10^–3 M. Coumarin inhibited seedling growth and seed germination at 10^–5 M or above. Chlorogenic acid inhibited seedling growth above 10^–4 M, but did not inhibit seed germination at 10^–5–5×10^–3 M. Low concentrations (below 10^–3 M) of caffeic and ferulic acids promoted the elongation of hypocotyls, but higher concentrations (over 10^–3 M) inhibited seedling growth and seed germination. These phenolic compounds and abscisic acid had additive inhibitory effects both on seedling growth and seed germination. The inhibition on lettuce was reversed by caffeic and ferulic acids at concentrations lower than 10^–3 M except for the inhibition of germination by coumarin. These results suggest that in naturetrans-cinnamic acid,o-, m-, p-coumaric acids, coumarin, and chlorogenic acid inhibit plant growth regardless of their concentration. However, caffeic and ferulic acids can either promote or inhibit plant growth according to their concentration.     

Thermodynamics of calcium and oxygen in molten titanium and titanium-aluminum alloy

The deoxidation equilibrium of molten titanium and titanium-aluminum alloys saturated with solid CaO has been measured in the temperature range from 1823 to 2023 K. The equilibrium constant of reaction CaO (s)=Ca (mass pct in Ti,Ti-Al)+O (mass pct in Ti,Ti-Al) and the interaction parameter between calcium and oxygen were determined for Ti, TiAl, and TiAl₃. The standard Gibbs energy of reaction for TiAl was obtained as follows: $$\Delta G^\circ = 279,000 - 103TJ/mol$$ The possibilities for the deoxidation of titanium and titanium-aluminum alloys by using calcium-based fluxes are discussed.     

A control method with pheromone information for a transport system

Since the control methods of a transport system between processing machines are specialized for each layout of the system, it is difficult to design prompt schedules and control logic for new complicated systems, especially in cases of machine faults or restructuring the system to modify the layout. In this article, we describe a multiagent transport control system which utilizes pheromone information. Each element of the system acts as an agent and estimates the appropriate path and time to drive out the products using information obtained by communication with other elements as well as pheromone information deposited on the tracks of the products.     

Navigation system for an autonomous robot using an ocellus camera in an indoor environment

Autonomous and mobile robots are being expected to provide various services in human living environments. However, many problems remain to be solved in the development of autonomous robots that can work like humans. When a robot moves, it is important that it be able to have self-localization abilities and recognize obstacles. For a human, the present location can be correctly checked through a comparison between memorized information assuming, it is correct, and the present situation. In addition, the distance to an object and the perception of its size can be estimated by a sense of distance based on memory or experience. Therefore, the environment for robotic activity assumed in this study was a finite-space such as a family room, an office, or a hospital room. Because an accurate estimation of position is important to the success of a robot, we have developed a navigation system with self-localization ability which uses only a CCD camera that can detect whether the robot is moving accurately in a room or corridor. This article describes how this system has been implemented and tested with our developed robot.     

Detection of environmental changes from network structure

We studied the networks of the temperature record in the atmosphere. They are made by the strength of the synchronization, including the delay between temperatures at locations on Earth. We consider these locations as nodes, and we consider a pair of locations as a link if the synchronization between them is stronger than a threshold. The network is scale-free, which is thought to contribute to the stability of the climate. This work was presented in part at the 12th International Symposium on Artificial Life and Robotics, Oita, Japan, January 25–27, 2007