Preparation and characterization of Mg–Al layered double hydroxides intercalated with benzenesulfonate and benzenedisulfonate

Mg–Al layered double hydroxides (Mg–Al LDHs) intercalated with benzenesulfonate (BS^–) and benzenedisulfonate (BDS^2–) ions were prepared by coprecipitation and characterized by X-ray diffraction, FT-IR spectroscopy, and chemical analyses. The intercalated BS^– and BDS^2– maintained their intrinsic molecular structures within the Mg–Al LDH interlayers. At low intercalation levels, the benzene ring of BS^– in BS · Mg–Al LDH was inclined at 30° relative to the plane of the brucite-like layers of Mg–Al LDH. With increasing BS^– content, the benzene ring adopted an additional configuration perpendicular to the Mg–Al LDH layers. In BDS-intercalated Mg–Al LDH, the benzene ring of BDS^2– was tilted at 26° relative to the plane of the Mg–Al LDH layers. Intercalation levels of BDS^2– were smaller than those of BS^– despite the greater charge density of BDS^2–, which was likely attributable to a greater degree of electrostatic repulsion between intercalated anions.     

Radiation grafting of α,β,β-trifluorostyrene onto poly(ethylene-tetrafluoroethylene) film by preirradiation method. II. Properties of cation-exchange membrane obtained by sulfonation and hydrolysis of the grafted film

A Study was made on certain properties of the cation-exchange membranes obtained by the preirradiation grafting of α,β,β-trifluorostyrene (TFS) noto poly(ethylene-tetrafluoroethylene) (ETFE), followed by sulfonation and hydrolysis of the grafted film. Swelling, water uptake, electric conductivity, and transport number of the membranes were measured as a function of ino-exchange capacity. Thermal and chemical stability were also investigated. These properties were found to be mainly dependent on ion-exchange capacity. The stable membrane properties were established due to a homogeneous ion-exchange group distribution in the membrane, as confirmed by x-ray imcroscopy analysis of the membrane cross sections. In addition, the membranes showed good electrochemical, thermal, and chemical properties, and were found to be scceptable for practical use as cation-exchange membranes.     

Bioaccumulation, temporal trend, and geographical distribution of synthetic musks in the marine environment

Bioaccumulation of synthetic musks in a marine food chain was investigated by analyzing marine organisms at various trophic levels, including lugworm, clam, crustacean, fish, marine mammal, and bird samples collected from tidal flat and shallow water areas of the Ariake Sea, Japan. Two of the polycyclic musks, HHCB and AHTN, were the dominant compounds found in most of the samples analyzed, whereas nitro musks were not detected in any of the organisms, suggesting greater usage of polycyclic musks relative to the nitro musks in Japan. The highest concentrations of HHCB were detected in clams (258-2730 ng/g lipid wt.), whereas HHCB concentrations in mallard and black-headed gull were low, and comparable with concentrations in fish and crab. These results are in contrast to the bioaccumulation pattern of polychlorinated biphenyls; for which a positive correlation between the concentration and the trophic status of organisms was found. Such a difference in the bioaccumulation is probably due to the metabolism and elimination of HHCB in higher trophic organisms. Temporal trends in concentrations of synthetic musks were examined by analyzing tissues of marine mammals from Japanese coastal waters collected during 1977-2005. HHCB concentrations in marine mammals have shown significant increase since the early 1990s, suggesting a continuous input of this compound into the marine environment. Comparison of the time trend for HHCB with those for PCBs and PBDEs suggested that the rates of increase in HHCB concentrations were higher than the other classes of pollutants. To examine the geographical distribution of HHCB, we have analyzed tissues of fish, marine mammals, and birds collected from several locations. Synthetic musks were not detected in a sperm whale (pelagic species) from Japanese coastal water and in eggs of south polar skua from Antarctica. While the number of samples analyzed is limited, these results imply a lack of long-range transportation potential of synthetic musks in the environment.     

Competitive adsorption of fibronectin and albumin on hydroxyapatite nanocrystals

Competitive adsorption of two-component solutions containing fibronectin (Fn) and albumin (Ab) on hydroxyapatite (HAp) nanocrystals was analyzed in situ using the quartz crystal microbalance with dissipation (QCM-D) technique. Adsorption of the one-component protein (Fn or Ab) and the two-component proteins adjusted to different molar ratios of Fn to Ab at a fixed Fn concentration was investigated. The frequency shift (Δf; Hz) and the dissipation energy shift (ΔD) were measured with the QCM-D technique, and the viscoelastic changes of adlayers were evaluated by the saturated ΔD/Δf value and the Voigt-based viscoelastic model. For the adsorption of the one-component protein, the Fn adlayer showed a larger mass and higher viscoelasticity than the Ab adlayer, indicating the higher affinity of Fn on HAp. For the adsorption of the two-component proteins, the viscoelastic properties of the adlayers became elastic with increase in Ab concentration, whereas the adsorption mass was similar to that of Fn in the one-component solution regardless of the Ab concentration. The specific binding mass of the Ab antibody to the adlayers increased with increase in Ab concentration, whereas that of the Fn antibody decreased. Therefore, Fn preferentially adsorbs on HAp and Ab subsequently interacts with the adlayers, indicating that the interfacial viscoelasticity of the adlayers was dominated by the interaction between Fn and Ab.     

Properties of calcium spikes revealed during GABAA receptor antagonism in hippocampal CA1 neurons from guinea pigs

A potential energy function for unsaturated hydrocarbons is proposed and is shown to agree well with experiment, using molecular dynamics simulations of a water/octene interface and a dioleoyl phosphatidylcholine (DOPC) bilayer. The simulation results verify most of the assumptions used in interpreting the DOPC experiments, but suggest a few that should be reconsidered. Comparisons with recent results of a simulation of a dipalmitoyl phosphatidylcholine (DPPC) lipid bilayer show that disorder is comparable, even though the temperature, hydration level, and surface area/lipid for DOPC are lower. These observations highlight the dramatic effects of unsaturation on bilayer structure.     

Simulation and fabrication of flat-plate concentrator modules

A flat-plate concentrator (FPC) module has been proposed and developed for cost reduction of PV modules. The FPC has V-grooved rear reflectors on spaces between adjacent cells. To find appropriate design parameters, yearly optical performance is simulated by using meteorological data and introducing a performance index. As a result of the simulation, it is shown that the FPC module can reduce occupation area of solar cells to 75% compared with that of a conventional module, although its module area increases to 1.16 times. Several prototypes are fabricated and measured under a solar simulator. The measured results are somewhat lower than the simulated ones, but generally show the validity of the simulation.     

Study on grounding in the vicinity of the work site on 1000-kV power transmission line. Part 2. Electromagnetic induction and its protection

In order to clarify the grounding conditions for protecting workers on a de-energized circuit from induction from a live circuit and to determine the required current capacity of the grounding conductor for a 1,000 kV double-circuit power transmission line, the phenomena caused by electromagnetic induction resulting from a live circuit are discussed. The electromagnetic induction current I_g flowing through the body of a worker and the electromagnetic induction current I_gO flowing through the grounding conductor can be analyzed by dividing the various power line conditions into three main factors, and using electromagnetic induction current calculations for a power line of infinite length. The zone where I_g does not exceed 1 mA is within 1 km of the grounding point on the de-energized circuit owing to the grounding resistance (0.1 Ω) of the substations at the ends of the line and the difference in the phase configurations on the line when the current I₁ of the live circuit is a constant 1 kA through the line. Similarly the value of I_gO is determined by the grounding resistance of the substations at the ends of the line and the difference in the phase configurations on the line. I_gO is approximately 10 A per 1 kA of I₁. The currents I_g and I_gO produced by electromagnetic induction are additive, allowing I_g and I_gO in the actual power line to be evaluated by summation.     

Structure of the human type XIX collagen (COL19A1) gene, which suggests it has arisen from an ancestor gene of the FACIT family

Type XIX collagen is a newly discovered member of the FACIT (fibril-associated collagens with interrupted triple helices) group of extracellular matrix proteins. Based on the primary structure, type XIX collagen is thought to act as a cross-bridge between fibrils and other extracellular matrix molecules. Here we describe the complete exon/intron organization of COL19A1 and show that it contains 51 exons, spanning more than 250 kb of genomic DNA. The comparison of exon structures of COL19A1 and other FACIT family genes revealed several similarities among these genes. The structure of exons encoding the noncollagenous (NC) 1-collagenous (COL) 1-NC 2-COL 2-NC 3-COL 3-NC 4 domain of the alpha1(XIX) chain is similar to that of the NC 1-COL 1-NC 2-COL 3-NC 3 domain of the alpha2(IX) chain except for the NC 3 domain of alpha1(XIX). The exons encoding the COL 5-NC 6 domain of alpha1(XIX) are also similar to those of the COL 3-NC 4 domain of alpha1(IX) chain. Previously, COL19A1 was mapped to human chromosome 6q12-q14, where COL9A1 is also located. Likewise, the present work shows that the mouse Col19a1 gene is located on mouse chromosome 1, region A3, where Col9a1 has also been mapped. Taken together, the data suggest that COL19A1 and COL9A1 (Col19a1 and Col9a1) were duplicated from the same ancestor gene of the FACIT family. Three CA repeat markers with high heterozygosity were found in COL19A1. These markers may be useful for linkage analysis of age-related inheritable diseases involved in eyes and/or brain.