空间相机中的偏流角分析

高分辨率星载TDI-CCD相机在成像过程中,偏流角会对相机的成像质量产生影响.因此根据卫星轨道方程给出了偏流角和偏流角角速度随纬度变化的具体形式,基于此分别研究了偏流角在卫星穿航方向和沿航方向引起的像移量和它对相机成像质量的影响.结果表明,偏流角是纬度的函数,由它引起的像移在穿航方向对相机像质的影响较为严重,必须加以校正.并针对极地圆轨道详细计算了像移对像质的影响程度和在MTF偏流角＞0.95的情况下偏流角需要调整的最小时间间隔.     

Optimal Block Design for Asynchronous Wake-Up Schedules and Its Applications in Multihop Wireless Networks

In this paper, we consider the problem of designing optimal asynchronous wake-up schedules to facilitate distributed power management and neighbor discovery in multihop wireless networks. We first formulate it as a block design problem and derive the fundamental trade-offs between wake-up latency and the average duty cycle of a node. After the theoretical foundation is laid, we then devise a neighbor discovery and schedule bookkeeping protocol that can operate on the optimal wake-up schedule derived. To demonstrate the usefulness of asynchronous wake-up, we investigate the efficiency of neighbor discovery and the application of on-demand power management, which overlays a desirable communication schedule over the wake-up schedule mandated by the asynchronous wake-up mechanism. Simulation studies demonstrate that the proposed asynchronous wake-up protocol has short discovery time which scales with the density of the network; it can accommodate various traffic characteristics and loads to achieve an energy savings that can be as high as 70 percent, while the packet delivery ratio is comparable to that without power management.     

SO4^2-／ZrO2固体超强酸的制备及其催化合成ETBE的研究

采用沉淀一浸渍法制备了负载型SO4^2-／ZrO2固体超强酸催化剂，运用IR、XRD等方法表征所制备催化剂的物化性质。结果表明，所制备的催化剂具有固体超强酸催化剂的特征，酸性与焙烧温度有关，适当提高焙烧温度有利于样品酸强度的提高，但焙烧温度过高会导致脱硫；浸渍液H2SO4浓度高有利于提高催化剂的硫含量，但是浓度过高，会在催化剂上形成硫酸盐，从而降低催化剂的比表面积和酸性。采用制备的催化剂气相催化乙醇与叔丁醇合成乙基叔丁基醚反应，乙基叔丁基醚的选择性为54．71％。     

Oxidation of Hastelloy-XR Alloy for Corrosion-Resistant Glass-Coating

The oxidation behavior of Hastelloy-XR alloy was investigated to obtain the optimum surface condition for corrosion-resistant glass-coatings. The surface morphology of oxide scales changed significantly with variation of temperatureand oxygen partial pressure (po2 ). The oxidation kinetics was mainly parabolic independent of oxidation conditions.The oxide scales were consisted of inner Cr2O3 and outer spinel layers. The phase component of spinel layers wereMn1.5Cr1.5O4 and (Mn,Ni)(Cr,Fe)2O4 for the oxygen partial pressures po2<10 kPa and po2>10 kPa, respectively.The optimum oxidation condition to obtain an oxide scale for well-adhered glass-coating to the substrate was 1248 Kand po2 =0.01 kPa for the oxidation time of 43 ks.     

储层泥浆侵入深度预测方法研究

泥浆侵入半径的确定尚缺乏严格的验证标准.以油水两相渗流理论和离子扩散方程为基础,结合储集层特点,研究了不同储层参数下泥浆滤液对地层的侵入特性.数值模拟侵入时间选取10 d和20 d.数值模拟结果表明,侵入半径在渗透率不变的情况下随孔隙度的增大而减小,在孔隙度不变的情况下随渗透率的增大而增大;当渗透率和孔隙度都发生变化时,泥浆侵入半径一般随孔隙度的增加呈幂函数增加.依据这种关系对测井资料约束处理,得到的泥浆侵入半径较客观地反映了地层的真实情况.     

高分辨率阵列感应测井仪在河南油田的应用

文章介绍了美国Baker-Atlas公司研制生产的高分辨率阵列感应成像测井仪（HDIL）,简述了该仪器的工作原理和技术性能指标及主要应用范围,并介绍了高分辨率阵列感应测井（HDIL）资料在河南南阳油田的具体应用实例.     

川东气藏直井完井方法的产能预测研究

在分析研究目前国内外油气井完井产能计算经验公式的基础上，针对四川气田东部浅层气藏常用的几种完井方式，建立了该地区完井产能预测的数学模型。通过实例计算，表明了其数学模型的准确可行性，并为出砂井和非出砂井的完井方式提供了选择依据：对于出砂井，砾石裸眼充填完井方式是最理想的完井方式；对于非出砂井，实际裸眼完井的产能最大。得出的结论对该地区直井完井方式的选择，完井参数优化设计以及产能预测具有一定的指导作用。     

板式换热器常见故障及处理

介绍了板式换热器使用中经常出现的外漏、串液等故障,并对此进行了分析,提出了合理的解决方法。     

通信性能评估的仿真实验研究

研究了流量控制和差错控制对通信性能的综合影响，着重分析了停止-等待协议和连续ARQ协议的优缺点，讨论了信道利用率和帧长的关系。介绍了几种多点接人技术的基本原理，如CSMA和CSMA／CD，并给出了各自相应的性能仿真曲线。所设计的通信性能评估实验，仿真界面形象丰富，与实验知识点紧密结合，可以大大提高实验教学的效率和质量。     

一种基于空间到达角的卫星电子侦察信号分选方法

在建立简化的卫星电子侦察空间模型的基础上，提出了一种利用空间到达角分选卫星电子侦察信号的新方法。通过仿真实验验证了这种方法的可行性。该方法可用于密集信号的预处理。