Maximum power density for an endoreversible carnot heat engine

An analysis using maximum power-density criteria has been carried out for an endoreversible Carnot heat engine. The results have been compared with known results on maximum power analysis. The design parameters at maximum power density lead to smaller and more efficient endoreversible Carnot heat engines than those working at maximum power output.     

Theoretical calculations of the surface tension of Ag(1−x)-Cu(x) liquid alloys

The surface tension of silver-copper binary liquid alloys is calculated, in the frame work of Eyring theory. The calculations were made for different compositions (mole fraction, x_Cu = 0, 0.2, 0.4, 0.6, 0.8 and 1), in the temperature range 1100-1800 K. The surface tension decreases with temperature increase, at a fixed copper fraction x_Cu, and increases with increasing copper content. The calculated results are appropriately compared with existing literature data.     

Functionalization of Graphene Oxide Films with Au and MoOx Nanoparticles as Efficient p‐Contact Electrodes for Inverted Planar Perovskite Solar Cells

A graphene oxide (GO) film is functionalized with metal (Au) and metal‐oxide (MoO_x) nanoparticles (NPs) as a hole‐extraction layer for high‐performance inverted planar‐heterojunction perovskite solar cells (PSCs). These NPs can increase the work function of GO, which is confirmed with X‐ray photoelectron spectra, Kelvin probe force microscopy, and ultraviolet photoelectron spectra measurements. The down‐shifts of work functions lead to a decreased level of potential energy and hence increased V_oc of the PSC devices. Although the GO‐AuNP film shows rapid hole extraction and increased V_oc, a J_sc improvement is not observed because of localization of the extracted holes inside the AuNP that leads to rapid charge recombination, which is confirmed with transient photoelectric measurements. The power conversion efficiency (PCE) of the GO‐AuNP device attains 14.6%, which is comparable with that of the GO‐based device (14.4%). In contrast, the rapid hole extraction from perovskite to the GO‐MoO_x layer does not cause trapping of holes and delocalization of holes in the GO film accelerates rapid charge transfer to the indium tin oxide substrate; charge recombination in the perovskite/GO‐MoO_x interface is hence significantly retarded. The GO‐MoO_x device consequently shows significantly enhanced V_oc and J_sc, for which its device performance attains PCE of 16.7% with great reproducibility and enduring stability.     

A Comparison Study Between Pre-Equalization Schemes for Single and Multi Carrier Modulation Systems

In this paper, frequency domain pre-equalization (Pre-FDE) is developed for broadband cyclic prefix-code division multiple access (CP-CDMA) as a single carrier transmission scheme, and for multi carrier-CDMA (MC-CDMA) and orthogonal frequency division multiplexing (OFDM) as multi carrier transmission schemes. A comparison study is held between these schemes and the traditional equalization schemes. Experimental results show that pre-equalization improves significantly the performance of the single and multi carrier communication systems with a very low complexity at the receiver. The comparative study between MIMO pre-equalization for single carrier systems and for multi carrier systems shows that MIMO pre-equalization for single carrier systems outperforms that for multi carrier systems in terms of bit error rate (BER) performance since single carrier transmission has more frequency diversity than multi carrier transmission in the uncoded case.     

Identification of the new 18-hexacosenoic acid in the spongeThalysias juniperina

The phospholipid fatty acids from the spongeSpheciospongia cuspidifera were studied revealing the presence of the rare 10-octadecenoic acid (10−18∶1) and a new 2-methoxyhexadecenoic acid. The phospholipid fatty acids fromThalysias juniperina were also studied revealing the presence of the hitherto unreported 18-hexacosenoic acid (18−26∶1). These results tend to indicate that the biosynthetic pathway from 10−18∶1 to 18−26∶1 may be operative in nature. The phospholipid mixture from the sponges was also analyzed by³¹P-NMR and shown to mainly consist of phosphatidylethanolamine, phosphatidylserine, phosphatidylinositol, and phosphatidylglycerol. Phosphatidylcholine was not found in the sponges analyzed in this work.     

A Novel Speech Enhancement Method Using Fourier Series Decomposition and Spectral Subtraction for Robust Speaker Identification

Wireless Personal Communications - This paper presents a novel speech enhancement approach by combining Fourier series expansion and spectral subtraction. This approach is implemented in speaker...     

Accurate analysis of carbon nanotube interconnects using transmission line model

A new technique for analysing the time-domain response of carbon nanotube (CNT) interconnects, based on transmission line modelling, that takes the effects of both contact and fundamental (quantum) resistances into account is introduced. A new sixth-order linear parametric expression for the transfer function of these lines has been presented for the first time. For verification purposes, the step response of a driver-CNT bundle-load configuration for a 32 nm technology node, using the new technique and HSPICE simulation have been compared, with which the obtained results show an excellent match. Also the effect of contact resistance on the step response, especially the propagation delay, has been studied. The obtained results show that for the length of a CNT bundle equal to 50 mum with the diameter of each individual CNT 1 nm, the propagation delay changes from 0.138 to 5.58 ns for the contact resistance values from 1 to 50 k Omega, i.e. a variation range of 39.43 times the minimum value. The related delay variations for the length values 200 mum, 500 mum and 1000 mum, are 31.37, 22.61 and 15.42 times the minimum value, respectively.     

An Anti-Gray Hole Attack Scheme in Mobile Ad Hoc Network

International Journal of Wireless Information Networks - Dynamic variation of network topology in mobile ad hoc networks (MANET) forces network nodes to work together and rely on each other for...