Forward-bias impedance of GaAs1-xPx LED's

The forward bias impedance characteristics of GaAs_1-xP_x LED's have been determined. In all cases, the equivalent parallel capacitance reaches a maximum and then either saturates (x = 0.4) or becomes negative at certain frequencies (x = 0.85 and x = 1). The current densities at which C_p maxima are reached are below typical values for display, multiplexing or optical emitters applications (i.e. J_F = 1 A/cm² for x = 0.85). It is suggested large series resistances for x = 0.4, and conductivity modulation effects for x > 0.4 are responsible for the above impedance behavior.     

TiO2 catalysed reduction of Cr(VI) in aqueous solutions under ultraviolet illumination

The photoassisted reduction of Cr(VI) to Cr(III) in aqueous suspensions of TiO₂ under ultraviolet (UV) illumination has been studied by determining the amount of Cr(VI) photoreduced at different irradiation times, the mass of catalyst in suspension, the Cr(VI) initial concentration and the pH. Samples of wastes from metal-surface treatment industries have been used to test this photocatalytic procedure for Cr(VI) elimination in a real ease. It has been observed that the presence in these samples of certain species such as Fe(III) and Cr(III) at low concentrations can increase significantly the yield of Cr(VI) photoreduction. It is assumed that these cations act by maintaining the pH during the photoreduction process, preventing the alkalization by hydrolysis of the solution.     

Sine-Wave Signal Characterization Using Square-Wave and ΣΔ-Modulation: Application to Mixed-Signal BIST

This paper presents a method for extracting, in the digital domain, the main characteristic parameters of an analog sine-wave signal. It is based on a double-modulation, square-wave and sigma-delta, together with a simple Digital Processing Algorithm. It leads to an efficient and robust approach very suitable for BIST applications. In this line, some considerations for on-chip implementation are addressed together with simulation results that validate the feasibility of the proposed approach.Diego Vázquez was born in El Coronil, Sevilla, Spain, in 1966. He received the Licenciado en Física degree in 1989 and the Doctor en Ciencias Físicas degree in 1995, both from the University of Sevilla, Spain. Since 1990, he has been with the Departamento de Electrónica y Electromagnetismo, University of Sevilla, where he is a Associate Professor, and also with the Instituto de Microelectrónica de Sevilla, Centro Nacional de Microelectrónica (IMSE-CNM-CSIC), Sevilla, Spain. He has published about 100 papers in international journals, books and major conferences. In 1992 he won the Best Paper Award of the 10th IEEE VLSI Test Symposium. His research interests are in the fields of design, fault tolerance, test, and design for testability of analog and mixed-signal circuits.Gloria Huertas was born in Sevilla, Spain, in 1974. She received the Licenciado en Física degree in 1997 and the Ph.D. in 2004, both from the University of Sevilla, Spain. Since then, she has been with the Departamento de Electrónica y Electromagnetismo, University of Sevilla, where she is Assistant Professor, and also with the Instituto de Microelectrónica de Sevilla, Centro Nacional de Microelectrónica (IMSE-CNM-CSIC), Sevilla, Spain. Her research focuses on designing electronic mixed-signal circuits and systems including techniques for testability.África Luque was born in Zamora (Spain) in 1977. She received the Licenciado en Física degree in 2000 from the University of Sevilla, Sevilla, Spain. She is with the Departamento de Electrónica y Electromagnetismo, University of Sevilla, and also with the Instituto de Microelectrónica de Sevilla, Centro Nacional de Microelectrónica (IMSE-CNM-CSIC), Sevilla, Spain, where she is currently pursuing the Ph.D. degree. Her research focuses on the design and test of mixed-signal circuits including Silicon-On-Insulator technologies.Manuel J. Barragan was born in Sevilla, Spain, in 1980. He received the Licenciado en Física degree in 2003 from the University of Sevilla, Sevilla, Spain. He is currently pursuing the Ph.D. degree from the Instituto de Microelectrónica de Sevilla (IMSE, CNM) on the topics of test and design for testability of analog and mixed-signal circuits.Gildas Leger was born in St. Brieuc, Côtes dArmor, France, in 1976. He received the Ingénieur en Physique degree in 1999 from the National Institute of Applied Sciences (INSA) of Rennes, France.He is currently pursuing the Ph.D. degree from the Instituto de Microelectrónica de Sevilla (IMSE, CNM). His research focuses on designing electronic mixed-signal circuits and systems including techniques for testability, specially in the domain of analog to digital conversion.Adoración Rueda joined the Department of Electronics and Electromagnetism at the University of Seville in 1976 as Assistant Professor, and obtained the Ph.D. degree in 1982. From 1984 to 1996 she was Associate Professor in that Department, where now holds the position of Full Professor in Electronics. In 1989 she became researcher at the Department of Analog Design of the National Microelectronics Center (CNM), now Institute of Microelectronics at Seville (IMSE).She has participated in several research projects financed by the Spanish CICYT and by different programs of the European Community. She has published about 135 papers in international journals, books and major conferences. In 1992 she won the Best Paper Award of the 10th IEEE VLSI Test Symposium. Her research interests are currently focused on the topics of Design and Test of Analog and Mixed-signal Circuits, Behavioral Modeling of Mixed-signal Circuits, and development of CAD tools.Jose Luis Huertas received the Licenciado en Física degree nd the Doctor en Ciencias Físicas degrees in 1969 and 1973, respectively, both from the University of Sevilla, Spain.From 1970 to 1971, he was with the Philips International Institute, Eindhoven, The Netherlands, as a postgraduate student. Since 1971, he has been with the Departamento de Electrónica y Electromagnetismo, University of Sevilla, Spain, where he is a Full Professor. He is also the Director of the Instituto de Microelectrónica de Sevilla, Centro Nacional de Microelectrónica de Sevilla, Seville, Spain. His current interests include the design and testing of analog/digital integrated circuits, computer-aided IC analysis and design, fuzzy logic, nonlinear microelectronics, and neural networks.     

Hybrid Turbo FEC/ARQ Systems and Distributed Space-Time Coding for Cooperative Transmission

Cooperative transmission can be seen as a “virtual” MIMO system, where the multiple transmit antennas are in fact implemented distributed by the antennas both at the source and the relay terminal. Depending on the system design, diversity/multiplexing gains are achievable. This design involves the definition of the type of retransmission (incremental redundancy, repetition coding), the design of the distributed space-time codes, the error correcting scheme, the operation of the relay (decode & forward or amplify & forward) and the number of antennas at each terminal. Proposed schemes are evaluated in different conditions in combination with forward error correcting codes (FEC), both for linear and near-optimum (sphere decoder) receivers, for its possible implementation in downlink high speed packet services of cellular networks. Results show the benefits of coded cooperation over direct transmission in terms of increased throughput. It is shown that multiplexing gains are observed even if the mobile station features a single antenna, provided that cell wide reuse of the relay radio resource is possible.     

Light and Strong SiC Networks

The directional freezing of microfiber suspensions is used to assemble highly porous (porosities ranging between 92% and 98%) SiC networks. These networks exhibit a unique hierarchical architecture in which thin layers with honeycomb‐like structure and internal strut length in the order of 1–10 μm in size are aligned with an interlayer spacing ranging between 15 and 50 μm. The resulting structures exhibit strengths (up to 3 MPa) and stiffness (up to 0.3 GPa) that are higher than aerogels of similar density and comparable to other ceramic microlattices fabricated by vapor deposition. Furthermore, this wet processing technique allows the fabrication of large‐size samples that are stable at high temperature, with acoustic impedance that can be manipulated over one order of magnitude (0.03–0.3 MRayl), electrically conductive and with very low thermal conductivity. The approach can be extended to other ceramic materials and opens new opportunities for the fabrication of ultralight structures with unique mechanical and functional properties in practical dimensions.     

Influence of carcass weight on instrumental and sensory lamb meat quality in intensive production systems

The effects of cooking viz. pressure-cooking and broiling and storage at 4 °C for six days and -10 °C for 90 days on lipid oxidation and development of cholesterol oxidation products in mutton were studied. Results revealed that cooking of meat significantly increased the total lipids, phospholipids, cholesterol, glycolipids, free fatty acids and glycerides, but they did not change during refrigerated and frozen storage. The TBA values increased on cooking and during storage. However, the values were below the threshold level for rancidity development. The following cholesterol oxidation products were separated by thin layer chromatography cholestanetriol, 7-α-hydroxy cholesterol, 19-hydroxycholesterol, 7-ketocholesterol, cholesterol-α-epoxide, cholesterol-β-epoxide and an unidentified fraction. All these fractions except the unidentified fraction increased on cooking. On refrigerated and even on frozen storage all these fractions increased except the unidentified fraction, which showed a concomitant reduction. The changes in broiled meat were more pronounced compared to pressure-cooked meat. Results clearly indicated that even frozen storage of cooked meat did not prevent the development of cholesterol oxidation products.     

Veal colour assessment with three wavelengths

A method to derive reflectance spectra and colour coordinates of meat by measurement of reflectance at only three wavelengths, 480, 570 and 620 nm has been developed, by treating the spectra of a meat sample as a linear combination of the spectra of the three major myoglobin derivatives (reduced myoglobin, oxymyoglobin and metmyoglobin). Applied to 300 samples of Semitendinosus and Longissimus dorsi veal muscles at different times post mortem (24 h to 9 d), colour differences ΔE (?) between the derived spectra and the real ones were about 1.5 units. The total pigment content, with high correlation with the extraction method (P < 0.02), and the relative proportions of the derivatives can also be estimated.     

Clock Faults Induced Min and Max Delay Violations

In this paper, we show that clock faults producing duty-cycle variations, which have been proven very likely, can give rise to min or max delay violations. This mandates new, specific testing approaches for clock faults, to avoid them to compromise the system correct operation in the field, with dramatic effects on product quality and defect level. We then introduce a new scheme that can be employed to detect the clock faults causing duty-cycle variations.     

Lethal effect of electric fields on isolated ventricular myocytes

Defibrillator-type shocks may cause electric and contractile dysfunction. In this study, we determined the relationship between probability of lethal injury and electric field intensity ($E$ ) in isolated rat ventricular myocytes, with emphasis on field orientation and stimulus waveform. This relationship was sigmoidal with irreversible injury for $E ≫ hbox{50 V/cm}$ . During both threshold and lethal stimulation, cells were twofold more sensitive to the field when it was applied longitudinally (versus transversally) to the cell major axis. For a given $E$, the estimated maximum variation of transmembrane potential ( $Delta V_{max }$) was greater for longitudinal stimuli, which might account for the greater sensitivity to the field. Cell death, however, occurred at lower maximum $Delta V_{max }$ values for transversal shocks. This might be explained by a less steep spatial decay of transmembrane potential predicted for transversal stimulation, which would possibly result in occurrence of electroporation in a larger membrane area. For the same stimulus duration, cells were less sensitive to field-induced injury when shocks were biphasic (versus monophasic). Ours results indicate that, although significant myocyte death may occur in the $E$ range expected during clinical defibrillation, biphasic shocks are less likely to produce irreversible cell injury.      

Low-cost group rekeying for unattended wireless sensor networks

Wireless sensor networks (WSNs) are made up of large groups of nodes that perform distributed monitoring services. Since sensor measurements are often sensitive data acquired in hostile environments, securing WSN becomes mandatory. However, WSNs consists of low-end devices and frequently preclude the presence of a centralized security manager. Therefore, achieving security is even more challenging. State-of-the-art proposals rely on: (1) attended and centralized security systems; or (2) establishing initial keys without taking into account how to efficiently manage rekeying. In this paper we present a scalable group key management proposal for unattended WSNs that is designed to reduce the rekeying cost when the group membership changes.