Microstructure-related fracture toughness and fatigue crack growth behaviour in toughened, anhydride-cured epoxy resins

Fracture toughness and fatigue crack propagation (FCP) of plain and modified anhydride-cured epoxy resin (EP) were studied at ambient temperature. Liquid carboxyl-terminated acrylonitrile-butadiene (CTBN) and silicon (SI) rubber dispersions were used as tougheners for the EP. The morphology of the modified EP was characterized by dynamic mechanical analysis (DMA) and by scanning electron microscopy (SEM). The fracture toughness, K_c, of the compositions decreased with increasing deformation rate. K_c of the EP was slightly improved by CTBN addition and practically unaffected by incorporation of the SI dispersion when tests were performed at low cross-head speed, v. Both modifiers improved K_c at high v, and also the resistance to FCP, by shifting the curves to higher stress intensity factor ranges, ΔK, by comparison with the plain EP. It was established that both fracture and fatigue performance rely on the compliance, J_R, at the rubbery plateau, and thus on the apparent molecular mass between crosslinks, M_c. The failure mechanisms were less dependent upon the loading mode (fracture, fatigue), but differed basically for the various modifiers. Rubber-induced cavitation and shear yielding of the EP were dominant for CTBN, whereas crack bifurcation and branching controlled the cracking in SI-modified EP. The simultaneous use of both modifiers resulted in a synergistic effect for both the fracture toughness at high deformation rate and the FCP behavior.     

Nontuberculous mycobacteriosis as a complication of the Swyer-James syndrome

The chest radiograph of a 35-year-old man with fatigue, exertional dyspnoea and haemoptyses revealed a cavity in the left upper lobe and a shrunken left lung with radiolucency greater than that on the right. Acid-fast rods in sputum were identified as Mycobacterium kansasii on culture. Scintigraphy showed a 9% residual perfusion on the left and abnormal ventilation, compatible with Swyer-James syndrome. This had favoured the development of a mycobacterial infection. There was also a decrease in ciliary function (rate of 4-7 Hz, normal: 10-11). Treatment, begun when tuberculosis had been suspected, was after sensitivity tests changed to a combination of rifampicin (600 mg), ethambutol (1600 mg) and protionamide (500 mg) daily. There was marked regression of the findings within 4 weeks, but treatment was prematurely stopped after 11 months. Two years later there was a recurrence which again responded well to the same drug regimen with additional sulphamethoxazole (1600 mg/d).     

Prebiotic synthesis of sequential peptides on the Hadean beach by a molecular engine working with nitrogen oxides as energy sources

Addressing the still open question of the prebiotic origin of sequential macromolecules (peptides, nucleic acids) on the primitive Earth, we describe a molecular engine (the primary pump), which works at ambient temperature and continuously generates, elongates and complexifies sequential peptides. This new scenario is based on a cyclic reaction sequence, whose keystep is the activation of amino acids into their N‐carboxyanhydrides (NCA) through nitrosation by NOx. This process could have taken place on tidal beaches; it requires a buffered ocean, emerged land and a nitrosating atmosphere. With the help of geochemical studies and computer simulations of atmosphere photochemistry, we show that the primitive Earth during the Hadean may have satisfied all these requirements. © 2001 Society of Chemical Industry.     

Selectivity in Methanol Oxidation as Studied on Model Systems Involving Vanadium Oxides

Oxidation catalysts are modeled by oxide single crystals, thin oxide films, as well as supported oxide nanoparticles. We characterize the surface of those materials using a variety of surface sensitive techniques including scanning tunneling microscopy and spectroscopy, photoelectron spectroscopy, infrared spectroscopy, and thermal desorption spectroscopy. We find temperature dependent structural transformations from V₂O₅(001) to V₂O₃(0001) via V₆O₁₃(001). V₂O₃(0001) is found to be vanadyl terminated in an oxygen ambient and it loses the vanadyl termination after electron bombardment. It is shown that the concentration of vanadyl groups controls the selectivity of the methanol oxy-dehydrogenation towards formaldehyde. A proposal for the mechanism is made. The results on single crystalline thin films are compared with similar measurements on deposited vanadia nanoparticles. The experimental results are correlated with theoretical calculations and models.     

Preparation of Phase-Pure M1 MoVTeNb Oxide Catalysts by Hydrothermal Synthesis—Influence of Reaction Parameters on Structure and Morphology

This work presents a detailed investigation of the preparation of MoVTeNbO _x catalysts by hydrothermal synthesis. Phase-pure synthesis of M1 has been achieved applying the metals in a molar ratio Mo/V/Te/Nb = 1/0.25/0.23/0.12. Raman, UV/Vis spectroscopy, and SEM/EDX analysis show that the elements are inhomogeneously distributed in the initial suspension that is formed after mixing the metal salts in an aqueous medium. Iso- and heteropoly anions of molybdenum, free telluric acid as well as supra-molecular polyoxometalate clusters are observed in the solution, whereas all metals have been found in the precipitate. Complete rearrangement of molecular building blocks under hydrothermal conditions is essential for formation of phase-pure materials. Optimized synthesis conditions with respect to temperature and time result in the formation of a precursor consisting of nano-structured M1 characterized by an extended periodic organization in the [001] direction and a fairly homogeneous distribution of the elements. Residual ammonium containing supra-molecular species in the precursor result in the formation of phase mixtures during the subsequent crystallization by heat treatment in inert gas. Phase-pure M1 exhibits a distinct degree of flexibility with respect to the chemical composition that becomes obvious by incorporating Nb not exclusively into pentagonal bi-pyramidal units, but also into octahedral coordinated positions as shown by EXAFS. Anisotropic growth of the needle-like M1 crystals has been observed during the final heat treatment performed at 873–923 K in inert atmosphere disclosing a potential method to control the catalytic properties of MoVTeNbO _x catalysts.