Influence of initial growth layer and Ti underlayer on magneticproperties and recording characteristics of very thin films ofevaporated Co-Cr media

A Co-Cr film deposited directly on a substrate has an initial growth layer with low coercivity. However, the existence of a Ti underlayer prevents the formation of such a layer. As a result, Co-Cr film deposited on a Ti underlayer has high perpendicular anisotropy and coercivity even in cases of extremely thin film thickness (200 Å). As for the read-write characteristics of Co-Cr thin-film media, the existence of such an initial growth layer greatly improves the reproduced output level. The cause for this is considered to be that the free charges which appear on the back surface of the perpendicular recording layer are reduced and the demagnetization field acting on the recorded magnetization subsequently decreases due to the existence of the initial growth layer     

Solution synthesis of crystallized AMO4 (A=Ba, Sr, Ca; M=W, Mo) film at room temperature

A well-crystallized AMO₄ (A=Ba, Ca, Sr; M=W, Mo) films have been prepared at room temperature through a simple solution reaction in respective alkaline solution at higher pH ranging from 12–14. Adopting the corrosion principle for oxidation of metal substrate, these double oxide films were carried out in presence of chemical driving force without any special apparatus or devices. Hydrogen peroxide was used to enhance the dissolution rate of metal substrates. The driving force for the film formation and growth were high concentration of A²⁺, MO₄²⁻ ions with high pH conditions. Average grain sizes of 8–10 μm with bipyramidal shaped particle were grown to the thickness of about 10–14 μm after 3–6 hours treatment. The crystallization of AMO₄ was characterized by three-dimensional nucleation. This work demonstrates the possibility of fabrication of functional ceramic films directly from the aqueous solution in a single step by solution reactions.     

Studies on chitin 3—effect of coagulants and annealing on the preparation and the properties of chitin membrane

Chitin membrane was prepared by casting a N,N-dimethyl acetamide, N-methyl 2-pyrrolidone and lithium chloride (DMA-NMP-LiCl)solution of chitin and coagulating with several media. The effect of the coagulants on membrane formation was studied. 2-Propanol was found to be more favourable than methanol, ethanol, acetone and mixtures of 2-propanol and water. The membrane obtained in 2-propanol was subjected to annealing. Annealing made the membrane dense and strong. The tensile strength of the membrane annealed at 145°C for 2hr was about twice that of an unannealed membrane. The solute permeability of the annealed membranes was lower than that of the original one. These phenomena could be clearly interpreted in terms of crystallinity.     

Change of characteristics of desulfurization and denitrification by combustion flue gas composition and electrode configuration under pulsed corona discharge

Laboratory-scale and parametric experiments of SO₂ and NO_x removal from the simulated combustion gas by pulsed corona discharge have been performed by changing the combustion gas composition and temperature, the electrode configuration of plasma reactor, and the polarity of high-voltage electrode. The following results are obtained: 1) the higher the concentration of H₂O and O₂, the higher the efficiency of desulfurization and denitrification at the same specific input; 2) the pulsed corona discharge with a voltage pulsewidth as short as 200 ns of negative polarity shows the possibility to attain almost 90 percent deSO_x and deNO_x efficiency at the specific discharge input of 20 J/g, which is almost the same as the specific input in the electron-beam process; 3) the deNO_x characteristics show a little temperature dependence in the range of 70 to 130°C, but the deSO_x efficiency increases rapidly in the temperature region below 100°C suggesting the thermochemical dependence of deSO_x reaction; 4) when desulfurization and denitrification proceed, the white dendritic powder deposits on the plasma reactor whose composition is identified to be 49 mol% (NH₄)₂SO₄ and 47 mol% of 2NH₄NO₃ · (NH₄)₂SO₄, and the ratio of SO₂, NO and NH₃ of the deposit is almost equal to that of supplied gas.     

Improvements of the T-Ω method for 3-D eddy currentanalysis

An improved T-Ω method that can analyze magnetic fields produced not only by eddy currents but also by magnetizing currents is proposed. The method is applied to the analysis of 3-D eddy-current models with holes. The usefulness of the method is investigated by comparing calculated results with measured results and with results obtained by the A-Φ method. The T-Ω method has the advantage that the CPU time can be considerably reduced when most of the analyzed region is current-free and the eddy current flows two-dimensionally. The method is especially effective when the shape of the winding is simple and the distribution of magnetizing current is known beforehand. It is not effective when most of the analyzed region is current-carrying     

Development of a current detection type cable fault locator

A cable fault location instrument based on the detection of traveling wave currents was developed. It is different from the conventional pulse radar method based on voltage detection. Measurement is automated, and the distance to the fault point is displayed by merely pushing a switch. In a branched or crossbonded line, the fault point can be located without interference from the branched or the crossbonded point. Tests performed in both real and simulated lines confirmed the practical utility of this instrument     

Acute progressive polyneuropathy in a patient with Waldenstr?m macroglobulinemia

A case of Waldenstr?m's macroglobulinemia (WM) (IgM-kappa type) associated with acute-onset demyelinating peripheral neuropathy is reported. A 49-year-old woman was admitted to our hospital because of general fatigue and recurrent syncope attacks. She was treated with vincristine, cyclophosphamide, epirubicin and prednisolone. By 10th hospital day, her clinical condition improved and serum viscosity was reduced. However, on the 21st hospital day, she suffered from rapidly progressive writing and gait disturbance. Neurological examination showed muscular atrophy and weakness in the distal part of four extremities. Deep tendon reflexes were diminished. There was no sensory deficit. Cerebrospinal fluid was normal. Anti-myelin associated glycoprotein activity of her serum was negative. Both motor and sensory nerve conduction velocities were markedly decreased. Biopsy of sural nerve revealed marked demyelination and onion bulb formation. There was IgM deposition on myelin sheath. Minimal axonal changes excluded the possibility of vincristine neuropathy. Plasmapheresis improved her symptoms, but nerve conduction velocities remained unchanged. Polyneuropathy associated with WM is usually gradual onset and sensory dominant. In this case, associated neuropathy was acute onset, progressive and motor dominant. This type of neuropathy in patients with WM is very rare.