Marine energy has a significant role to play in lowering carbon emissions within the energy sector. Paradoxically, it may be susceptible to changes in climate that will result from rising carbon emissions. Wind patterns are expected to change and this will alter wave regimes. Despite a lack of definite proof of a link to global warming, wind and wave conditions have been changing over the past few decades. Changes in the wind and wave climate will affect offshore wind and wave energy conversion: where the resource is constrained, production and economic performance may suffer; alternatively, stormier climates may create survival issues. Here, a relatively simple sensitivity study is used to quantify how changes in mean wind speed—as a proxy for wider climate change—influence wind and wave energy production and economics. 相似文献
New penetration, scabbing and perforation formulae are derived for use in the design of reinforced concrete barriers to withstand impact by hard missiles. This is done by using dimensional analysis together with physical theories for the various impact processes. This leads to impact formulae with unknown coefficients which are then determined by an analysis of all available test data. The new formulae so derived are simple and, because of their parametric formulation, have a range of applicability easily definable in terms of impact parameters. The analysis indicates that some recently proposed impact formulae are not safe from the point of view of barrier design because the test data used for their derivation was affected by global movement of the barriers which reduced the measured local damage. 相似文献
Mechanical and thermal-mechanical treatments of 304 stainless steel enables yield strengths of over 200,000 psi to be obtained
with elongations better than 10 pct. Electron microscopy, X-ray, and magnetic techniques show that during deformation, strain
induced γ → ∈ → α transformation occurs with further thermal nucleation of α achieved by aging up to 400°C. The yield strength
is linearly proportional to the amount of ° irrespective of the treatment used to form α. The yield strength is given by αy = 225f + 48.65 ksi, where ƒ is the volume fraction of martensite. Softening occurs by aging at 500°C and above due to a decrease
in percent α which may occur by renucleation of γ. The system is an unusual form of composite strengthening; hard martensite
particles are formed within the austenite, and the percent α (and thereby the mechanical properties), can be controlled by
the mechanical/thermal-mechanical processing.
Formerly with the Department of Materials Science and Engineering, University of California, Berkeley, Calif. 相似文献
A new method for the retrieval of the spectral refractive indices of micrometer-sized particles from infrared aerosol extinction spectra has been developed. With this method we use a classical damped harmonic-oscillator model of molecular absorption in conjunction with Mie scattering to model extinction spectra, which we then fit to the measurements using a numerical optimal estimation algorithm. The main advantage of this method over the more traditional Kramers-Kronig approach is that it allows the full complex refractive-index spectra, along with the parameters of the particle size distribution, to be retrieved from a single extinction spectrum. The retrieval scheme has been extensively characterized and has been found to provide refractive indices with a maximum uncertainty of approximately 10% (with a minimum of approximately 0.1%). Comparison of refractive indices calculated from measurements of a ternary solution of HNO3, H2SO4, and H2O with those published in J. Phys. Chem. A 104, 783 (2000) show similar differences as found by other authors. 相似文献
The effect of high-energy electron irradiation on ferritin/haemosiderin cores (in an iron-overloaded human liver biopsy), its mineral analogue; six-line ferrihydrite (6LFh), and iron phosphate dihydrate (which has similar octahedral ferric iron to oxygen coordination to that in ferrihydrite and ferritin/haemosiderin cores) has been investigated using electron energy-loss spectroscopy (EELS). Fe L2,3-ionisation edges were recorded on two types of electron microscope: a 200 keV transmission electron microscope (TEM) and a 100 keV scanning transmission electron microscope (STEM), in order to investigate the damage mechanisms in operation and to establish a methodology for minimum specimen alteration during analytical electron microscopic characterisation. A specimen damage mechanism dominated by radiolysis that results in the preferential loss of iron co-ordinating ligands (O, OH and H2O) is discussed. The net result of irradiation is structural re-organisation and reduction of iron within the iron hydroxides. At sufficiently low electron fluence and particularly in the lower incident energy, finer probe diameter STEM, the alteration is shown to be minimal. All the materials examined exhibit damage which as a function of cumulative fluence is best fitted by an inverse power-law, implying that several chemical and structural changes occur in response to the electron beam and we suggest that these are governed by secondary processes arising from the primary ionisation event. This work affirms that electron fluence and current density should be considered when measuring mixed valence ratios with EELS. 相似文献
Choosing the right compounds to synthesise from large virtual combinatorial libraries is a current challenge for the pharmaceutical industry. Herein we describe a highly optimised method that aligns lead‐like properties with compound diversity. The methods are illustrated by considering a two‐dimensional library based on the interesting spirocyclic bis‐azetidine template.
The 2-oxoglutarate-dependent hypoxia inducible factor prolyl hydroxylases (PHDs) are targets for treatment of a variety of diseases including anaemia. One PHD inhibitor is approved for use for the treatment of renal anaemia and others are in late stage clinical trials. The number of reported templates for PHD inhibition is limited. We report structure–activity relationship and crystallographic studies on a promising class of 4-hydroxypyrimidine-containing PHD inhibitors. 相似文献
We report on the introduction of active optical elements into confocal and multiphoton microscopes in order to reduce the sample-induced aberration. Using a flexible membrane mirror as the active element, the beam entering the rear of the microscope objective is altered to produce the smallest point spread function once it is brought to a focus inside the sample. The conventional approach to adaptive optics, commonly used in astronomy, is to utilise a wavefront sensor to determine the required mirror shape. We have developed a technique that uses optimisation algorithms to improve the returned signal without the use of a wavefront sensor. We have investigated a number of possible optimisation methods, covering hill climbing, genetic algorithms, and more random search methods. The system has demonstrated a significant enhancement in the axial resolution of a confocal microscope when imaging at depth within a sample. We discuss the trade-offs of the various approaches adopted, comparing speed with resolution enhancement. 相似文献