Depth of intergranular oxygen diffusion during environment-dependent fatigue crack growth in alloy 718

The elevated-temperture fatigue crack growth behavior in alloy 718, when subjected to a loading frequency lower than the transitional frequency of this alloy, is viewed as fully environment dependent. In this process, the crack growth increment per loading cycle is assumed to be equal to the intergranular oxygen diffusion depth at the crack tip during the cycle effective oxidation time. In order to identify the trend of this diffusion depth an experimental program was carried out on compact tension specimens made of alloy 718 at 650 °C in which fatigue crack growth measurements were made for cyclic load conditions with and without hold time periods at minimum load level. This work resulted in establishing a relationship correlating the intergranular oxygen diffusion depth and the value of the stress intensity factor range ΔK. This relationship, when integrated over the cycle effective oxidation time, results in a closed-form solution describing the environment-dependent fatigue crack growth rate. A comparison is made between the results of this solution when applied to different loading frequencies and the corresponding experimental results. This comparison shows good agreement between the two sets of results. Furthermore, by combining the parabolic rate law of diffusion and the equation for the intergranular oxygen diffusion depth, an explicit expression for the oxygen diffusivity of grain boundaries is derived. It is found that this diffusivity is both a ΔK- and a frequency-dependent parameter.     

Parallel simulated annealing for power system decomposition

This paper proposes a parallel optimization approach to power system decomposition for voltage control. In this paper, a parallel simulated annealing (PSA) technique is developed to decompose power systems so that subsystems are equally separated in terms of the number of nodes and control variables. System decomposition is one of difficult discrete number combinatorial problems. The PSA technique provides better solutions than the conventional SA because of searching a solution near a global minimum over a wide range. The proposed method is tested in IEEE 30, 57, and 118 node systems     

Detection and Validation of Clusters of Polynomial Zeros

We consider the task of partitioning the zeros of a real or complex polynomial into clusters and of determining their location and multiplicity for polynomials with coefficients of limited accuracy. We derive computational procedures for the solution of this task which combine symbolic computation with floating-point arithmetic. The validation of the existence ofmzeros in a specified small disk is described.     

Kinetic study of the hydrolysis of isocyanic acid in the gas phase

The hydrolysis of isocyanic acid in the gaseous phase has been investigated at temperatures between 553 and 613 K by mass spectrometry and evaluated to obtain the corresponding kinetic data. The reaction order and reaction constant have been determined. Finally, the influence of water on the catalysed formation of melamine from isocyanic acid under the operating conditions employed has been investigated in order to determine whether there is a need to try the process gas.     

Transient and dynamic average-value modeling of synchronous machinefed load-commutated converters

A new average-value model of a synchronous machine fed load-commutated converter is set forth in which the stator dynamics are combined with the DC link dynamics. This model is shown to he extremely accurate in predicting system transients and in predicting frequency-domain characteristics such as the impedance looking into the synchronous machine fed load-commutated converter. The model is verified against a detailed computer simulation and against a hardware test system, thus providing a three-way comparison. The proposed model is shown to be much more accurate than models in which the stator dynamics are neglected     

Zu einem Phänomen der Lochkorrosionsbegrenzung bei hochlegierten Sonderedelstählen und NiCrMo-Legierungen in Chloridlösungen

On a phenomenon of the limitation of pitting corrosion at high alloyed special stainless steels and NiCrMo-alloys in chloride solutions Testing the pitting corrosion resistance of high alloyed special stainless steels and NiCrMo-alloys in chloride solutions there was observed a limitation of the pitting corrosion range toward more positive potentials. Above this limitation, the so-called pitting corrosion limitation potential, the pit initiation by all means is prevented, but the growth of pits which had been initiated before in the pitting corrosion range not necessarily comes to a stop. Therefore current density-potential curves which are obtained by downward polarization after an initial potential jump into the transpassive region and chronopotentiostatic tests are more suitable to investigate this phenomenon than cyclic polarization measurements and potentiostatic alteration tests. There is indicated a dependence of this phenomenon on temperature. The phenomenon of a limitation of the pitting corrosion range toward more positive potentials has been found until now at alloy 926, alloy 31, alloy 28, alloy 59 and alloy C-276.