Synthesis of ditungsten carbide by controlled decomposition of Cp2W2(CO)4 (dmad) under a hydrogen atmosphere

Controlled decomposition studies of the bis(cyclopentadienyl)ditungsten(tetracarbonyl)-dimethylacetylenedicarboxylate (Cp2W2(CO)4(dmad)) under flowing hydrogen show that it totally decomposes at 600 °C for 2 h to give a pure bulk W2C as revealed by X-ray diffraction. Excess oxygen and carbon at the surface are detected by X-ray photoelectron spectroscopy. An in situ temperature-programmed X-ray diffraction experiment performed on Cp2W2(CO)4 (dmad) shows the detection temperature of W2C to be 600 °C, the sample being amorphous or microcrystalline below that temperature. Based on previous results obtained for the decomposition of Cp2Mo2(CO)4(dmad) on the one hand, and thermogravimetric and chromatographic analyses performed on Cp2W2(CO)4 (dmad), on the other, a decomposition scheme of the latter under hydrogen has been proposed. © 1998 Chapman & Hall     

Effect of exercise on the plasma nonesterified fatty acid composition of dogs and goats: Species with different aerobic capacities and diets

The goals of this study were to determine: (i) whether mammals mobilize particular nonesterified fatty acids (NEFA) preferentially during locomotion, (ii) if differences in aerobic capacity or diet can affect the pattern of NEFA mobilization and (iii) which individual NEFA are most representative of total NEFA concentration changes, to use them as tracers for turnover studies. Individual NEFA were measured in trained dogs and goats (VO₂max dog/VO₂max goat=2.2; where VO₂max=max-imal oxygen consumption) during treadmill exercise at 40 and 60% VO₂max. Important interspecies differences in individual NEFA concentrations could be attributed to differences in aerobic capacity. The more aerobic species (dog) had much higher plasma NEFA concentrations for all but one NEFA (18∶0), when compared with the low-aerobic species (goat). In addition, exercise caused a large increase in concentration of individual NEFA in the dogs, with the largest increases seen in 18∶1 (150% above resting values) and 16∶0 (60% increase), but it had no effect in goats. Therefore, the aerobic species has a much higher ability for mobilizing and transporting NEFA in plasma than its low-aerobic counterpart. Two NEFA accounted for more than half total plasma NEFA in both species, 18∶1 (about 35% total NEFA) and 16∶0 (20%). Calculation of variability in percent composition reveals that oleate and palmitate also closely reflect changes in total NEFA and are therefore the most appropriate tracers forin vivo kinetic studies in exercising mammals. Differences in diet and digestion physiology explained some differences in the plasma NEFA composition of the two species; this was reflected in the percent contributions of individual fatty acids to total NEFA: in dogs 18∶1>16∶0>18∶2>18∶0, while in goats 18∶1>16∶0>18∶0>18∶2. Also, only goats had 18∶3 (6% total NEFA), a fatty acid of plant origin, while only dogs had 16∶1 (7% total NEFA). Overall, however, the plasma NEFA composition of goats did not exactly reflect that of their diet due to preabsorptive modification of unsaturated fatty acids, while in dogs there was a good correlation between dietary and plasma NEFA.     

A neuron membrane mesh representation for visualization of electrophysiological simulations

We present a process to automatically generate three-dimensional mesh representations of the complex, arborized cell membrane surface of cortical neurons (the principal information processing cells of the brain) from nonuniform morphological measurements. Starting from manually sampled morphological points (3D points and diameters) from neurons in a brain slice preparation, we construct a polygonal mesh representation that realistically represents the continuous membrane surface, closely matching the original experimental data. A mapping between the original morphological points and the newly generated mesh enables simulations of electrophysiolgical activity to be visualized on this new membrane representation. We compare the new mesh representation with the state of the art and present a series of use cases and applications of this technique to visualize simulations of single neurons and networks of multiple neurons.     

Modeling of submicrometer gate GaAs field effect transistors

Before describing the mainFet modelings today available, the main technological evolutions ofMesfet andTegfet are summarized. It is brought some information on the various physical effects that occur in the devices and that must be taken into account in the models. It is shown that the different kinds of modelings (Monte Carlo, two dimensional, one dimensional) constitute a continuous chain, where the different elements appear strictly complementary. Finally, the present situation concerning modeling ofMesfet andTegfet will be presented.     

Application of the general rate model with the Maxwell-Stefan equations for the prediction of the band profiles of the 1-indanol enantiomers

The adsorption isotherm data of R- and S-1-indanol and of their racemic mixture on cellulose tribenzoate were measured by frontal analysis. These experimental data were fitted to the single-component and the modified competitive Bilangmuir isotherms. The overloaded elution profiles of bands of the pure enantiomers and of the racemic mixture were calculated for different sample sizes, using the best competitive isotherm model and the General Rate Model of chromatography coupled with the generalized Maxwell-Stefan equation that describes the surface diffusion flux. The calculated and the experimental profiles were found to be in excellent agreement in all cases. The parameters of the model of the mass transfer kinetics were derived from the band profiles obtained for the pure enantiomers. The same values of these parameters give an excellent prediction of the profiles of multicomponent bands. The new model described here allows a satisfactory interpretation of the competitive mass transfer kinetics.     

Emissions control policies under uncertainty and rational learning in a linear-state dynamic model

We compare the use of price-based policies or taxes, and quantity-based policies or quotas, for controlling emissions in a dynamic setup when the regulator faces two sources of uncertainty: (i) market-related uncertainty; and (ii) ecological uncertainty. We assume that the regulator is a rational Bayesian learner and the regulator and firms have asymmetric information. In our model the structure of Bayesian learning is general. Our results suggest that the expected level of emissions is the same under taxes and quotas. However, the comparison of the total benefits related to these policies suggests that taxes dominate quotas, that is, they provide a higher social welfare. Even though taxes have some benefits over quotas, neither learning nor ecological uncertainty affect the choice of policy, i.e., the only factor having such an impact is uncertainty in the instantaneous net emissions benefits (market-related uncertainty). Besides, the more volatile is this uncertainty, the more benefits of taxes over quotas. Ecological uncertainty leads to a difference between the emissions rule under the informed and the rational learning assumptions. However, the direction of this difference depends on the beliefs bias with regard to ecological uncertainty. We also find that a change in the regulator’s beliefs toward more optimistic views will increase the emissions.     

Preparation and properties of high molecular weight poly(1-germa-) or poly(1-sila-cis-pent-3-enes)

High molecular weight poly(1,1-dimethyl-1-germa-cis-pent-3-ene), poly(1,1-diphenyl-1-germa-cis-pent-3-ene), poly(1,1-dimethyl-1-sila-cis-pent-3-ene), and poly(1-methyl-1-phenyl-1-sila-cis-pent-3-ene) have been prepared. The thermal stability of these polymers is found to increase with their molecular weight.     

Adsorption and electrothermal desorption of organic vapors using activated carbon adsorbents with novel morphologies

Novel morphologies of activated carbons such as monolith, beads and fiber cloth can effectively capture organic vapors from industrial sources. These adsorbent materials are also unique because they can undergo direct electrothermal regeneration to recover the adsorbed organic vapors for potential re-use. This investigation compares and contrasts the properties of these adsorbents when using electrothermal-swing adsorption. The adsorption systems consisted of an organic vapor generation system, an electrothermal-swing adsorption vessel, a gas detection unit, and a data acquisition and control system. The activated carbon monolith (ACM) had the lowest pressure drop, highest permeability, highest electrical resistivity and lowest cost as compared to the activated carbon beads (ACB) and the activated carbon fiber cloth (ACFC). ACB had the largest throughput ratio and lowest length of unused bed as compared to the other adsorbents. However, ACFC had the largest adsorption capacity for toluene when compared to ACM and ACB. ACFC was also faster to regenerate and had a larger concentration factor than ACM and ACB. These results describe relevant physical, electrical, adsorption and cost properties for specific morphologies of the adsorbents to more effectively capture and recover organic vapors from gas streams.