Localization-limited exciton oscillator strength in colloidal CdSe nanoplatelets revealed by the optically induced stark effect

2D materials are considered for applications that require strong light-matter interaction because of the apparently giant oscillator strength of the exciton tra...     

Dielectric properties of iron doped calcium copper titanate,CaCu<Subscript>3</Subscript>Ti<Subscript>3.9</Subscript>Fe<Subscript>0.1</Subscript>O<Subscript>12</Subscript> ceramic

Dielectric properties of iron doped CaCu₃Ti₄O₁₂ (CCTO), viz. CaCu₃Ti_3.9Fe_0.1O₁₂ (CCTFO) prepared by a novel semi-wet route have been investigated. X-ray diffraction of powder sintered at 900 °C show formation of single phase solid solution. Energy dispersive X-ray spectroscopy (EDX) confirmed the presence of CuO rich phase at grain boundaries of CCTFO. Nature of dielectric relaxation observed above room temperature is studied using complex plane impedance analysis and modulus spectroscopy. It has been found that out of the two relaxations reported earlier above room temperature, one occurring at lower temperature is due to grainboundaries interfacial polarization.     

Synthesis,characterization and application of biopolymer-ionic liquid composite membranes

Biopolymer composite membranes based on chitosan doped with an ionic liquid (IL) 1-ethyl 3-methylimidazolium thiocyanate (EMImSCN) have been developed and characterized. The doped ionic liquid films show remarkable enhancement in ionic conductivity (σ). The Fourier transform infrared (FTIR) spectroscopy, atomic force microscopy (AFM) and X-ray diffraction studies (XRD) affirmed the composite nature, good incorporation of ionic liquid and reduction in crystallinity of films, respectively. The interaction between ionic liquid, chitosan and iodide polymer electrolyte matrix was evaluated by cyclic voltammetry. The fabricated dye sensitized solar cell (DSSC) using this new biopolymer electrolyte membranes shows promising performance.     

An optimal scheduling and routing under adaptive spectrum-matching framework for MIMO systems

Multi-users (MUs) along the communication links cause noise and traffic in the channel. The prediction of availability and the optimal usage of channels are the main objectives of the multi-input multi-output (MIMO) system. Several optimisation algorithms select the optimal channel for the users effectively. But the high-error rate and the probability values are the two major problems in traditionally optimised channel selection methods. The bandwidth allotted for information transmission is minimum. Moreover, the outage probability values are maximum in traditional scheduling algorithms. This paper proposes the new optimisation algorithm that predicts the channels for transmission and adaptive spectrum matching concept to predict the suitable channel from allocated bands. Also, the prioritisation on high-spectrum intensity basis assures an efficient data delivery to the receiver. The scheduling of available channels and data prioritisation minimises the error probability rates. This paper investigates the effectiveness of proposed optimal channel utilisation against the different modulation schemes such as three-dimensional complementary codes, linear network coding with the quadrature phase shift keying in terms of the average block error probability and bit error rate.     

Planar Ultra-Wideband Bandpass Filter Using Edge Coupled Microstrip Lines and Stepped Impedance Open Stub

The design and implementation of a planar ultra-wideband (UWB) bandpass filter are presented. Three interdigital edge coupled microstrip lines are used for coupling enhancement. A stepped impedance open stub is used for realizing transmission zeros simultaneously in upper and lower stop bands as well as impedance matching in ultra-wide pass band. A pass band from 3.1-10.6 GHz is achieved with an insertion loss of 0.5 dB, a return loss of about 18 dB, a sharp out-of-band-rejection, and a low group delay of only 0.21ns. Single- and double-section filters are realized to meet the UWB mask requirement. The design of the filter is simple, and it shows good frequency response.     

An Effective Power-Aware At-Speed Test Methodology for IP Qualification and Characterization

Advanced nanometer technologies have led to a drastic increase in operational frequencies resulting in the performance of circuits becoming increasingly vulnerable to timing variations. The increasing process spread in advanced nanometer nodes poses considerable challenges in predicting post-fabrication silicon performance from timing models. Thus, there is a great need to qualify basic building structures on silicon in terms of critical parameters before they could be integrated within a complex System-on-Chip (SoC). The work of this paper presents a configurable circuit and an associated power-aware at-speed test methodology for the purpose of qualifying basic standard cells and complex IP structures to detect the presence of timing faults. Our design has been embedded within test-chips used for the development of the 28 nm Fully Depleted Silicon On Insulator (FD-SOI) technology node. The relevant silicon results and analysis validate the proposed power-aware test methodology for qualification and characterization of IPs and provide deeper insights for process improvements.     

Binding of zinc to bovine and human milk proteins

Zn binding by whole bovine and human casein and by purified bovine caseins and whey proteins was investigated by equilibrium dialysis. Bovine alpha s1-casein had the greatest Zn-binding capacity (approximately 11 atoms Zn/mol). Protein aggregation was observed as Zn concentration was increased and the protein precipitated at a free Zn concentration of 1.7 mM. Zn binding increased with increasing pH in the range 5.4-7.0 and decreased with increasing ionic strength. Competition between Zn and Ca was observed for binding to alpha s1-casein indicating common binding sites for these two metals. Bovine beta-casein bound up to 8 atoms Zn/mol and precipitated at a free Zn concentration of approximately 2.5 mM, while kappa-casein bound 1-2 atoms Zn/mol. Whole bovine and human casein bound 5-8 atoms Zn/mol and precipitated at a free Zn concentration of approximately 2.0 mM. Scatchard plots for Zn binding to caseins showed upward convexity, possibly due to Zn-induced association of caseins. Apparent average association constants (Kapp) for all caseins were similar (log Kapp 3.0-3.2). Enzymic dephosphorylation of alpha s1- or whole bovine casein markedly reduced, but did not eliminate, Zn binding. Thus, phosphoserine residues appeared to be the primary Zn-binding sites in caseins. With the exception of bovine serum albumin, which bound over 8 atoms Zn/mol, the bovine whey proteins, beta-lactoglobulin, alpha-lactalbumin and lactotransferrin, had little capacity for Zn binding.