激光对光学薄膜损伤的热冲击效应

计算了薄膜在高功率脉冲激光作用下截面温度场和应力场分布。分析了热冲击在光学薄膜激光损伤中的作用，并用调Ｑ１．０６μｍ脉冲激光对ＺｒＯ２单层膜损伤，讨论了不同激光强度下薄膜截面温度场与应力场分布，揭示了热冲击在ＺｒＯ２单层膜损伤中的机理和过程。     

对溢洪闸门自动监控系统中几个问题的探讨

结合某水电站介绍了溢洪闸门自动监控系统的结构、功能，讨论了该研制过程中的几个问题的解决办法．     

Global buckling load of a nonlinearly elastic bar

Summary The nonlinear buckling of an elastic bar with softening characteristic is studied. It is found that, under large disturbances, the bar may buckle under loads well below the linear buckling load.     

Beam test of the CsI(Tl) calorimeter for the BELLE detector at the KEK-B factory

We studied the performance of a prototype electromagnetic calorimeter for the BELLE detector at the KEK proton synchrotron for an energy range of 0.25–3.5 GeV. The prototype consisted of an array of 6 × 5 CsI(Tl) crystals with 30 cm length (16.2 radiation lengths) and about 6 cm × 6 cm cross section. The scintillation light of each CsI(Tl) crystal was read out by two large-area PIN photodiodes and charge-sensitive preamplifiers attached at the rear face of the crystal. We measured the energy and position resolution for electrons and the e/π separation for two sets of matrix configurations: one corresponded to the center and the other to the edge of the barrel calorimeter. The overall performance measured by the test proves that the prototype calorimeter is satisfactory for the use in the BELLE detector.     

制作矢量轮廓字库

本文介绍了一种如何从常见的点阵字库制作矢量轮廓字库的算法。算法采用了预处理、轮廓跟踪和轮廓逼近这三个主要步骤来制作每一个矢量文字，然后采用一种２字节的索引结构加以存储。     

Low-voltage BiCMOS dynamic minimum circuit using a parallelcomparison algorithm for fuzzy controllers

The authors present a low-voltage BiCMOS dynamic minimum circuit using a parallel comparison algorithm for VLSI implementation of fuzzy controllers. Using low-voltage BiCMOS dynamic circuits and a parallel comparison algorithm, a four-4-bit-input minimum circuit designed, based on a 1μm BiCMOS technology, shows a 9.5ns comparison time, which is a ×2.5 improvement in speed as compared to that based on CMOS technology     

铅黄铜水平连铸棒材熔铸工艺的试验研究

在工业生产条件下，对影响HPb59－1水平连铸律材热轧开裂的熔铸工艺进行了试验研究．取三个熔铸工艺因素：铸造速度、冷却水压力、冷却水温度．试验结果表明；铸造速度对热轧开裂影响极为显著，使其控制在410mm／min左右可获得较为理想的效果．     

Two mechanisms for the recapture of extracellular GM2 activator protein: evidence for a major secretory form of the protein

The GM2 activator protein is a small monomeric protein containing a single site for Asn-linked glycosylation. Its only proven in vivo function is to act as a substrate specific cofactor for the hydrolysis of GM2 ganglioside by lysosomal beta-hexosaminidase A. However, we and others have shown it can act as a general glycolipid transporter at neutral pH in vitro. Any other possible in vivo functions would require that some of the newly synthesized activator molecules not be targeted to the lysosome. The lysosomal targeting mechanism for the activator has not been conclusively identified. While earlier reports suggested that it is likely through the mannose-6-phosphate receptor, another more recent report demonstrated that deficient human cells could recapture nonglycosylated, bacterially produced activator, suggesting its use of an alternate targeting pathway. Here, we demonstrate that the mannose-6-phosphate pathway is likely the major intracellular, biosynthetic route to the lysosome, as well as a high affinity recapture pathway for the endocytosis of activator protein from extracellular fluids. Additionally, we show that there exists a second lower affinity recapture pathway that requires its native protein structure, is carbohydrate independent, and likely does not involve its ability to bind glycosphingolipids in the plasma membrane. Finally, we document that the pool of newly synthesized precursor activator protein contains a majority of molecules with a complex-type oligosaccharide, which cannot contain a functional mannose-6-phosphate targeting signal. These molecules makeup the secreted forms of the protein in normal human fibroblasts.