OTDM transmitter using WDM-TDM conversion with an electroabsorptionwavelength converter

An all-optical multiplexing technique using wavelength division multiplexing (WDM)-time division multiplexing (TDM) conversion with an electroabsorption wavelength converter has been proposed and demonstrated. The effectiveness of this WDM-TDM conversion technique for various pulsewidth settings was experimentally investigated. The fluctuation of the signal performance, which was inevitably caused by the coherent crosstalk between adjacent pulses in the conventional optical time division multiplexing (OTDM) technique, were successfully suppressed, even in the case of wide pulse duration. High Q-factor performance has been maintained for a wide range of duty ration from 36% to 74%. By introducing this technique to the optical time division multiplexer, a highly stable and high-quality 40-Gb/s optical signal can be effectively produced without generating the short pulse or setting two tributaries at orthogonal polarization states, and without introducing high-speed electronics for signal multiplexing. The WDM-TDM conversion with an electroabsorption wavelength converter was extended to 60-Gb/s operation by using three 20-Gb/s tributaries. A clear eye opening was confirmed for a waveform after the WDM-TDM conversion of the 60-Gb/s signal     

A STUDY OF THE PRIMARY PHASE OF FOOD FREEZE-DRYING IN VACUO

In the development of a novel freeze-drying technique in a fluidized bed at atmospheric pressure, a parallel study was undertaken using a conventional vacuum equipment. Two kinetically distinct phases were observed during freeze drying of representative Pood samples:

(1) a period during which the rate of drying was constant and (2) a second period during which the drying rate sufferedcontinual reduction. This paper focused attention on the primary drying period which corresponded with the kinetics of sublimation of pure     

IEEE Richard Harold Kaufmann Award Call for Nominations

This letter further discusses the difference between different definitions of voltage unbalance. Contrary to an earlier letter (see P. Pillay et al., ibid., vol.5, p.50-1, 2001), it is concluded that different definitions may give significantly different results. The two IEEE definitions that were not discussed in the earlier letter give different results and both deviate significantly from the true value (ratio of negative, and positive-sequence voltage) when a zero-sequence component is present.     

“Metallisation” of oxide surfaces observed by in situ high-resolution electron microscopy

Intense irradiation (25–40 A/cm²) at intermediate energy (400 keV) has been found to cause “metallisation” of tungsten oxide and titanium niobate crystal surfaces. The possible mechanisms and the likely consequences for high-resolution imaging of clean oxide surfaces are briefly discussed.     

Collision Detection and Multitone Tree Search for Multiple-Access Protocols on Radio Channels

The carrier sense multiple access with collision detection (CSMA-CD) protocol cannot be applied directly to radio channels because of the difficulty in sensing remote carrier in the presence of local transmission. Only recently, a new protocol called the CSMA with timesplit collision detection (CSMA-TCD) was introduced to overcome this problem on radio channels. This paper presents an extension of the CSMA-TCD protocol, called CSMA-TCD with multitone tree search (CSMA-TCD-MTTS). In CSMA-TCD, a preamble is transmitted before data transmission. For CSMA-TCD-MTTS, the preamble is modulated with one out ofNtones. In case of a collision, a resolution algorithm splits the terminals involved into anN-degree tree according to the tone chosen. This paper presents the throughput and approximate delay analysis of the CSMA-TCD-MTTS protocol.     

Front Cover

In this paper, the authors present the results of experiments which clearly demonstrate a technical basis confirming that the carrier frequency harmonics data can be used for diagnostics relative to motor stator insulation degradation.     

MetaModel: a program for modelling and control analysis of metabolic pathways on the IBM PC and compatibles

MetaModel is a user-friendly program for calculating steady-state fluxes and metabolite concentrations of metabolic systems on the IBM PC and compatible computers. For any steady state that is obtained, one can then calculate a matrix of elasticity coefficients at that steady state, or a matrix of control and response coefficients. It thus offers a simple way to calculate the control structure of a pathway: it provides not only an educational tool that allows the student to verify empirically the classic summation relationships of metabolic control analysis but also a research tool for addressing 'what if?' questions about the behaviour of metabolic systems. Results can not only be printed or stored in a file, but can also be written to a special file that can be read by popular spreadsheet programs, thereby giving access to rapid, flexible and powerful methods for subsequent analysis and plotting of these results.