Low-loss high power RF switching using multifinger AlGaN/GaN MOSHFETs

We demonstrate a novel RF switch based on a multifinger AlGaN/GaN MOSHFET. Record high saturation current and breakdown voltage, extremely low gate leakage current and low gate capacitance of the III-N MOSHFETs make them excellent active elements for RF switching. Using a single element test circuit with 1-mm wide multifinger MOSHFET we achieved 0.27 dB insertion loss and more than 40 dB isolation. These parameters can be further improved by impedance matching and by using submicron gate devices. The maximum switching power extrapolated from the results for 1A/mm 100 /spl mu/m wide device exceeds 40 W for a 1-mm wide 2-A/mm MOSHFET.     

131I-epidepride的制备与SD大鼠体内分布特性研究

采用双氧水标记法和氯胺 -T法进行13 1I -epidepride标记 ,考察标记物的纯度及稳定性 ,并进行SD大鼠体内分布特性研究。实验结果表明 ,双氧水法和氯胺 -T法标记率分别为 97.4 %和 5 2 .9%。标记物的生理盐水溶液室温放置 4h ,放化纯大于 90 %。大鼠静脉注射13 1I -epide pride的生理盐水溶液后 ,纹状体与小脑比值在注射后 32 0min时高达 2 37:1。13 1I -epidepride进入血液后很快被组织摄取 ,其中以肺的早期摄取最高 (2 .11± 1.0 5 ) %ID·g- 1,各脏器的清除均较快 (T1/2 <4h) ,甲状腺的摄取率随时间的延长而增加。     

Two-tier architecture for unconstrained handwritten character recognition

In this paper, we propose an approach that combines the unsupervised and supervised learning techniques for unconstrained handwritten numeral recognition. This approach uses the Kohonen self-organizing neural network for data classification in the first stage and the learning vector quantization (LVQ) model in the second stage to improve classification accuracy. The combined architecture performs better than the Kohonen self-organizing map alone. In the proposed approach, the collection of centroids at different phases of training plays a vital role in the performance of the recognition system. Four experiments have been conducted and experimental results show that the collection of centroids in the middle of the training gives high performance in terms of speed and accuracy. The systems developed also resolve the confusion between handwritten numerals.     

超高相对分子质量聚乙烯纤维研究进展

介绍了超高分子质量聚乙烯纤维的制备、表面改性及应用的研究进展 ,指出了今后超高分子质量聚乙烯纤维的研究及应用的发展方向     

铑自给能中子探测器的灵敏度

本文给出了铑自给能探测器的热中子灵敏度和中子灵敏度的理论计算公式、燃耗修正公式以及不同中子温度下的换算公式。运用这些公式对ZTRh 123型铑自给能探测器的热中子灵敏度和中子灵敏度进行了理论计算,并在反应堆中对其进行了实验验证。其结果表明,理论计算值和实验标定值是相吻合的。其偏差:热中子灵敏度为8.5％,中子灵敏度为3.9％。     

一种确定高窄带滤光片峰值波长的方法

本文介绍一种主动式高窄带滤光片峰值波长的测量方法。该方法可以有效的测量出窄带滤光片的敏感波长，而不需要太复杂的设备。通过染料激光谐振腔的模式竞争，可以测量出滤光片的透射或反射波的波长。     

Comments on `Hash-based and index-based join algorithms for cubeand ring connected multicomputers' by E.R. Omiecinski and E.T. Lin

The cost distributions of both the parallel hybrid-hash join and the parallel join-index join algorithms proposed in the above-named work (ibid., vol.1, p.329-43, Sept. 1989) are presented in more detail. The result shows that almost the entire relation may need to be retrieved from disk, though the join selectivity is low. A table of semi-join selectives and cube sizes is given to show the condition that the join-index method performs better than the hybrid-hash method, i.e., the really low selectivity for the join-index method. An error in one of the cost formulas is corrected, and a more efficient method on the final join in the join-index method is proposed     

多工况多级离心压缩机总体优化命题的建模与数值方法

介绍了多工况 点的压缩机最优模拟设计点的特点及相应的优化建模，包括目标函数的建立、约束条件的确立和计算方法，使满足该模拟设计点要求的压缩机在逼近优目标函数最大值的同时，兼顾各真实工况运行点都在较好效率下工作，并列出了基于模型级数据库的优化设计实例。     

Ionoluminescence decay measured with single ions

A new ion beam analysis-based, single ion technique called the time to first photon has been developed to measure the decay of the luminescence signal of phosphors. Such measurements are currently needed to study luminescence decay mechanisms following high-density excitations and to identify strongly luminescent phosphor coatings with short lifetimes for ion photon emission microscopy (IPEM). The samples for this technique consist of thin phosphor layers placed or coated on the surface of PIN diodes. Single ions from an accelerator strike this sample and simultaneously create ion beam induced luminescence (IBIL) from the phosphor that is measured by a single-photon-detector, and an ion beam induced charge collection (IBICC) signal in the PIN diode. In this case, the IBICC signal provides the start pulse and the IBIL signal the stop pulse to a time to amplitude converter. It is straightforward to show that this approach also measures a signal proportional to activity versus time with an accuracy of 5% as long as the number of detected photons per ion is less than 0.1, which usually requires the use of absorbers for the IBIL detector or electronic discrimination for the IBIL signals. Details of the new analysis are given together with examples of luminescence decay measurements of several ceramic phosphors being considered to coat IPEM samples. IPEM is currently being developed at Sandia National Laboratory (SNL), the University of North Texas in Denton, and the Universities and INFN of Padova and Torino.