Preparation of Titanium Nitride/Alumina Laminate Composites

A preparation route for TiN/Al₂O₃ laminate composites has been described. A water-based process using Al₂O₃ and TiN slurries with solids contents of 40 and 35 vol%, respectively, was used to make TiN and Al₂O₃ tapes. The removal of the binder was monitored by weight-loss measurements in a thermogravimetry unit. Bodies composed of Al₂O₃ and TiN tapes were densified at temperatures of 1400° and 1500°C using the Spark Plasma Sintering^® (SPS) technique. Densities of >98% of the theoretical densities were approached. Crack-free and almost fully densified TiN/Al₂O₃ compacts were prepared by heating the burned-out green bodies to the final sintering temperature (1500°C) at a rate of 100°C/min, and with a holding time of 5–10 min, under a pressure of 75 MPa. The microstructures of the obtained compacts were studied using scanning electron microscopy. Grain sizes in the sintered Al₂O₃ and TiN compacts were similar to those of the precursor powders. Hardness and indentation fracture toughness were measured at room temperature, and the monolithic compacts as well as the laminate composites exhibited anisotropic mechanical behavior; i.e., the cracks propagated much more easily in a direction parallel to the laminas than perpendicular to them.     

CaSO_4晶须对聚氨酯胶粘剂性能影响的研究

用实验室自制的相对分子质量为2500的聚己二酸-1,4-丁二醇酯二醇和甲苯二异氰酸酯、混合扩链剂配制聚氨酯胶粘剂,并使用实验室自制的改性和未改性200nm硫酸钙晶须对聚氨酯胶粘剂进行改性,考察不同硫酸钙晶须及其加入量、加入方式对聚氨酯胶粘剂综合力学性能的影响。根据实验结果,200nm改性硫酸钙晶须当加入量为3％时,聚氨酯胶粘剂的拉伸强度、初粘性和最终剥离强度均有明显提高。     

轻质多孔复合隔墙板挤压成型的研究与应用

〕介绍了轻质多孔复合隔墙板挤压成型机的构造原理、技术参数、使用方法与保养、经济分析和有关问题的探讨     

Phase Assemblages of Pr α-sialon Derived from SHS-ed Powders and TEM Study on the Nucleation of Pr α-sialon

The Pr α-sialon powders prepared by self-propagating high-temperature synthesis (SHS), consisting of 55 wt% Pr α-sialon and 45 wt% of β-sialon (abbreviated as α' and β'), were hot-pressed at 1800°C for 1 h. The results showed that Pr α' phase would transfer to β' with the appearance of JEM phase (Pr(Si_{6− z} Al _z )(N_{10− z} O _z )) after sintering, thus resulting in the increase of β' phase to 86 wt%. The addition of Y₂O₃ into SHS-ed Pr α' powders as the starting materials restrains the transformation of α' to β' and prevents the formation of JEM phase as well. The nucleation mechanism of Pr α' grain during hot-pressing was investigated in terms of transmission electron microscope and energy-dispersive spectrometer analysis. Two nucleation modes of Pr α' grains were found, i.e., nucleating on the undissolved Pr α' grains and on the nuclei of (Pr, Y) α' grains precipitated from liquid phase.     

对煤磨MDC89-7袋式除尘器的节能环保改造

0 前言 湖南韶峰水泥集团有限公司规格为φ2.5 m×3.9 m的风扫式煤磨配套的MDC89-7袋式除尘器于1993年投用,经十多年的生产应用,其导流板及风道损坏达80%左右;外壳、主风道因烧袋和腐蚀,严重变形且花板变得很薄;反吹风道变形穿孔,提升阀密封不严,导致清灰时风量流失严重,运行阻力增加,系统产量降低,且系统中含氧量增加,带来安全隐患;除尘效率下降、污染严重,粉尘排放浓度高达1 g/m3;系统能耗高,且维修强度大(每个滤袋重50kg,每次换袋需12人)且费用高.为此,该公司于2004年4月对该煤磨除尘器进行技术改造,取得了明显的效果.     

降低循环流化床锅炉飞灰含碳量的因素分析

循环流化床锅炉的飞灰含碳量是锅炉燃烧工况好坏的直接反映 ,其对锅炉的热效率的影响是很大的 ,它还直接影响着粉煤灰的综合开发和利用 .在对云天化循环流化床锅炉的生产实验研究中 ,分析了影响循环流化床锅炉飞灰含碳量的各种因素 (床温、煤质煤粒、一次风、二次风、床压和旋风分离器效率等 ) ,通过实验研究找到了降低循环流化床锅炉飞灰含碳量的具体而又行之有效的操作方法 ,以指导实际生产 .     

Phase separation in polymer blends comprising copolymers: 6. Effect of molecular architecture of block copolymers

To study the effect of the molecular architecture of a copolymer on its miscibility with corresponding homopolymers a series of block copolymers of styrene and isoprene with diblock, triblock and four-arm star architectures have been prepared and the morphologies of the blends of the copolymers and polyisoprene with different molecular weights have been examined by electron microscopy. The results show that miscibility varies in the sequence diblock>triblock>four-arm star copolymers. This sequence is in the opposite direction to the variation of the architectural complexity of the block copolymers, i.e. the more complex is molecular architecture, the greater is conformation restriction in microdomain formation and the less is solubility of homopolymer in corresponding domains.     

MACD与K线图技术在证券投机中的实证研究

利用MACD趋势指标与K线形态图进行相互验证技术,改进一般的基于MACD的证券买卖准则。实证结果表明,基于改进后的MACD买卖准则进行证券投机,几乎能使投机者捕捉到每一波段行情,从而获取较高收益。