Heat Curing of Soy Protein Films at Atmospheric and Sub-atmospheric Conditions

ABSTRACT: The effect of heat curing at atmospheric or subatmospheric conditions on selected properties (moisture content, water vapor permeability (WVP), color, tensile strength (TS), elongation (E), and total soluble matter (TSM) content) of cast soy protein isolate films was investigated. Films were heat cured at 85 °C for 6, 12, 18, or 24 h at absolute pressures of 101.3, 81.32, or 61.32 kPa. Heat-cured films had increased (P < 0.05) TS and decreased (P < 0.05) WVP and E compared to control, unheated films. Heat treatment under vacuum reduced the WVP of films faster than heat curing at atmospheric pressure. High TS values, low E values, and low TSM values were also reached within short heating time under vacuum. However, vacuum treatment increased the size and number of cavities in cured films as evidenced by scanning electron micrographs.     

Effect of phosphorus concentration on phosphorus removal and biomass

Membrane bioreactor (MBR) process was employed to study the effect of biological phosphorus removal (bio-P removal) and P-content in treated sludge with increased phosphorus concentration present in the wastewater. Further, the following four test fractions of raw wastewaters was obtained having different P-concentrations viz., run 1: P-20 mg/L, run 2: P-40 mg/L, run 3: P-60 mg/L, run 4: P-80 mg/L. The effective P-removal obtained for these four test fractions were found to be 23.07 mg/L (98.17%), 41.35 mg/L (88.16%), 45.75 mg/L (72.04%) and 55.80 mg/L (66.82%) respectively for run 1, 2, 3 and 4 fractions. Moreover, the similar increase in phosphorous concentration i.e., from 20 to 80 mg/L caused an apparent increase in total solid (TS) values from 7 to 8.3 g TS/L, whereas the total volatile solid (TVS) content remained constant (i.e. 4.5 g TVS/L). These results inferred that the proportion of TVS in the TS decreased from 70 to 55%. Moreover, by increasing the initial P-concentration from 20 to 80 mg/L, the corresponding P-proportion of excess sludge was increased from 2 to 6.2%.     

Pasteurization of rainbow trout roe: Listeria monocytogenes and sensory analyses

D- and z-values for a mixture of four Listeria monocytogenes strains originating from the roe of different fish species were determined in rainbow trout (Oncorhynchus mykiss) roe. The D60- and D63-values obtained were 1.60 and 0.44 min, respectively, and the z-value was 5.36 degrees C accordingly. In pilot-scale experiments, rainbow trout roe (100 g) was vacuum packaged into glass jars and pasteurized both at 62 and 65 degrees C for 10 min. These treatments were enough to destroy 10(8) CFU/ g of L. monocytogenes cells, which was the highest possible Listeria cell count to grow in roe. On the basis of the determined z-value and calculation of pasteurization values, these experimental pasteurizations were found to theoretically destroy at least 45 log units of L. monocytogenes cells in rainbow trout roe. In addition, these pasteurization treatments did not significantly affect the sensory quality of the roe. The sensory quality of pasteurized vacuum-packaged rainbow trout roe stored at 3 degrees C was evaluated as good after 6 months of storage and not statistically different from the control that was frozen from the same roe lot as the pasteurized roe samples. Pasteurization of rainbow trout roe was proven to be an appropriate method for ensuring product safety with regard to L. monocytogenes and to stabilizing the sensory and microbial quality of roe. However, the safety risk caused by spore-forming bacteria still exists in pasteurized roe. Therefore, it has to be stored below 3 degrees C.     

Adsorption of antifouling booster biocides on metal oxide nanoparticles: Effect of different metal oxides and solvents

Controlling the release rate of biocides (antifouling agents) from a paint coating is a key issue for the development of multi-season antifouling marine coatings. One promising approach is the use of nanoparticles onto which biocides are adsorbed to prevent premature depletion of the biocide. Adsorption of one novel (Medetomidine) and six commercially available and widely used antifouling biocides (Chlorothalonile, Dichlofluanid, Diuron, Irgarol, Seanine, Tolylfluanid) onto oxide nanoparticles (Al₂O₃, CuO, MgO, SiO₂, TiO₂, ZnO) was investigated by HPLC and NMR in different organic solvents. Large differences in adsorption strength depending on the type of nanoparticle and solvent employed were observed. It was shown that nanoparticles coordinate preferentially with the imidazole moiety of Medetomidine. Independent of the type of particle this interaction was considerably stronger in comparison to the other biocides. However, the interaction strength was strongly dependant on the type of solvent, where the largest strongest interaction was achieved in o-xylene. In addition field tests were performed where a considerable decrease in release rate was displayed from coatings containing Medetomidine adsorbed to nanoparticles compared to coatings containing Medetomidine as single additive.     

Characterization of corn stover, distiller grains and cattle manure for thermochemical conversion

Corn stover, distiller grains and cattle manure were characterized to evaluate their acceptability for thermochemical conversion. The energy densities of ground corn stover, distiller grains and cattle manure after totally drying were 3402, 11,813 and 10,374 MJ/m³, compared to 37,125 MJ/m³ for coal. The contents of volatiles in corn stover, distiller grains and cattle manure were 77.4, 82.6 and 82.8%, respectively, on a dry and ash-free basis compared to 43.6% for coal. About 90% of the volatiles in corn stover, distiller grains and cattle manure were released at pyrolysis temperatures of 497, 573 and 565 °C, respectively. The combustion of corn stover, distiller grains and cattle manure were completed at 620, 840 and 560 °C, respectively. The heat values of the biomass and air mixture for stoichiometric combustion were 2.64, 2.75 and 1.77 MJ/kg for dried corn stover, distiller grains and cattle manure, respectively, as compared to 2.69 MJ/kg for coal. Combustion of 1 kg of dry corn stover, distiller grains and cattle manure generated 5.33, 6.20 and 5.66 Nm³ of flue gas, respectively, compared to 8.34 Nm³ for coal. Simulation showed that gasification of 1 kg of dried corn stover, distiller grains and cattle manure at 850 °C and ER of 0.3 generated 2.02, 2.37 and 1.44 Nm³ dry syngas at a heating value of about 4.5 MJ/Nm³, compared to 3.52 Nm³ at 5.8 MJ/Nm³ for coal. The molecular ratio of H₂ to CO in the biomass-derived syngas was close to 1.0, compared to about 0.5 for the coal-derived syngas.     

Plasma Electrolytic Oxidation of Arc-Sprayed Aluminum Coatings

Different posttreatment methods, such as heat treatment, mechanical processing, sealing, etc., are known to be capable to improve microstructure and exploitation properties of thermal spray coatings. In this work, a plasma electrolytic oxidation of aluminum coatings obtained by arc spraying on aluminum and carbon steel substrates is carried out. Microstructure and properties of oxidized layers formed on sprayed coating as well as on bulk material are investigated. Oxidation is performed in electrolyte containing KOH and liquid glass under different process parameters. It is shown that thick uniform oxidized layers can be formed on arc-sprayed aluminum coatings as well as on solid material. Distribution of alloying elements and phase composition of obtained layers are investigated. A significant improvement of wear resistance of treated layers in two types of abrasive wear conditions is observed. This article is an invited paper selected from presentations at the 2007 International Thermal Spray Conference and has been expanded from the original presentation. It is simultaneously published in Global Coating Solutions, Proceedings of the 2007 International Thermal Spray Conference, Beijing, China, May 14-16, 2007, Basil R. Marple, Margaret M. Hyland, Yuk-Chiu Lau, Chang-Jiu Li, Rogerio S. Lima, and Ghislain Montavon, Ed., ASM International, Materials Park, OH, 2007.     

基于稀疏组lasso-granger因果关系特征的脑电信号情感识别

针对目前基于单一脑区功能性网络层面的特征提取,文中提出稀疏组lasso-granger因果关系方法.首先从效应性脑网络层面提取不同脑区之间的因果关系作为脑电特征,分别提取受试者α,β,γ脑电波段的granger因果特征值.然后引用稀疏组lasso算法对获取的granger因果特征值进行特征筛选,获得高相关性特征子集作为情感分类特征.最后使用SVM分类器进行情感分类.此外,为了减少计算时间复杂度,使用过滤特征选择(ReliefF)算法,选取有效的脑电信号通道.实验表明,文中方法在Valence-Arousal二维情感模型上获得较高的平均情感分类准确率,分类效果优于对比的脑电特征,提取的情感脑电特征可以有效识别受试者的不同情感状态.